Larval Ring Gland Dissection: Isolation of Developmental Endocrine Organs from Drosophila

研究方案

This protocol is an excerpt from Imura et al., Protocols for Visualizing Steroidogenic Organs and Their Interactive Organs with Immunostaining in the Fruit Fly Drosophila melanogaster, J. Vis. Exp. (2017).

NOTE: The overall scheme of protocols is shown in Figure 1.

1. The Dissection of the Larval Ring Gland (RG)

NOTE: In D. melanogaster, which belongs to cyclorrhaphous Diptera, the PG is within a composite endocrine organ called the ring gland (RG, Figure 2D). Since it is unfeasible that the PG is surgically separated from other types of cells (discussed later), a practical target is to isolate an intact, undamaged RG by dissection.

1. Preparation of larvae at the appropriate developmental stages
   NOTE: To synchronize the developmental stages of D. melanogaster larvae, it is necessary to collect eggs within a narrow time window and to collect larvae at the appropriate times.
   1. Collect eggs for 2 h on a grape-juice agar plate at 25 °C.
   2. Collect newly-hatched 1^st instar larvae under a dissecting microscope with forceps and transfer them to a small vial containing mashed standard yeast/cornmeal fly food.
      NOTE: The age of larvae is represented by "hours after egg laying (hAEL)", "hours after hatch (hAH)", or "hours after L3 ecdysis (hAL3E)".
   3. At the appropriate time point, collect the staged larvae with a disposable plastic loop to avoid undesirable injury. To minimize a difference in developmental progression of the 3^rd instar larvae, collect the 2^nd instar larvae at 70 hAEL (48 hAH) and allow them to molt in 2 h intervals. Then, collect the 3^rd instar larvae within 2 h after the L3 ecdysis; this procedure gives 0-2 hAL3E larvae.
   4. Transfer the staged larvae to a dish filled with phosphate buffered saline (PBS).
   5. Rinse the larvae with PBS to remove residual food from the body.
2. Coarse dissection of larvae under a dissecting microscope
   1. Hold the mouth hook of a larva with forceps. Sever the larval body at the anterior one-third of the body length using micro scissors.
   2. Hold the cut end of the anterior larval body with one pair of forceps. Using the other pair of forceps, gently push the tip of the head toward the inside of the body; this procedure turns the larval body inside out.
      NOTE: This step can be skipped for the dissection of 1^st instar larvae.
   3. Repeat steps 1.2.1-1.2.2 with additional larvae for 5-10 min.
      NOTE: The number of larvae should be equal to or less than 20 to save time for dissection.
3. Fixation and staining of tissue with immunohistochemistry
   1. Put the anterior one-third of the larval bodies (step 1.2.2) into a 1.5 mL microtube filled with 500 µL the fix solution (4% paraformaldehyde in PBS). Fix less than 20 samples at one time, otherwise PBS attached to the fixed samples may cause an unfavorable dilution of the fixative. For fillet dissection, remove a drop of PBS and then add a drop of fix solution.
      NOTE: For fix solution, either 3.7% formaldehyde or 4% paraformaldehyde may be used.
   2. Incubate the dissected tissues in the fix solution for 30 min at room temperature (RT) or alternatively for 2 h at 4 °C.
   3. Replace the fix solution with 500 µL PBS and quickly rinse the samples 3 times. Wash the samples with 500 µL 0.3% PBT (PBS + 0.3% octylphenol ethoxylate) for 15 min on a rocker at RT. For fillet dissection, remove the insect pins and transfer the samples into a 1.5 mL microtube.
      NOTE: For increasing the permeability of antibodies into tissues, the samples are treated with 500 µL 2.0% PBT for 1-2 h on a rocker at RT.
   4. Replace PBT with 500 µL blocking solution (2% bovine serum albumin in PBT). Incubate the samples for 1.5 h on a rocker at RT.
   5. Replace the blocking solution with 50 µL the primary antibody solution, i.e. antibodies diluted in the blocking solution.
   6. Incubate the samples overnight on a rocker at 4 °C.
   7. Replace the primary antibody solution with 500 µL 0.3% PBT and quickly rinse the samples 5 times. Wash the samples 3 times with 500 µL 0.3% PBT for 15 min each on a rocker at RT.
   8. Replace 0.3% PBT with 50 µL the secondary antibody solution (dye-conjugated antibodies diluted in the blocking solution). For nuclear staining, 0.5 µL 4',6-diamidino-2-phenylindole (DAPI, 0.1 mg/mL stock solution) is added to 50 µL solution. Incubate the samples on a rocker for 2 h at RT or alternatively at 4 °C overnight.
      NOTE: Keep the samples in the dark.
   9. Replace the antibody solution with 500 µL 0.3% PBT and rinse 5 times. Wash the samples 3 times with 500 µL 0.3% PBT for 15 min each at RT.
4. Fine dissection of the brain-RG complex containing the PG and mounting
   1. Use a disposable pipet to transfer the immunostained samples to a dish filled with 0.3% PBT.
      NOTE: To avoid inconvenient bubbles during dissection and mounting, 0.3% PBT can be replaced with PBS.
   2. Under a dissecting microscope, hold the cuticle or mouth hook with one pair of forceps. Using a 27 G needle attached to a 1 mL syringe as a "knife", cut the anterior tip of the esophagus and eye discs to remove the brain-RG-eye disc complex from body cuticle.
   3. Separate the esophagus and gut from the brain-RG-eye disc complex with forceps. Since the esophagus passes through the brain above the ventral nerve cord (VNC), pull out the gut to the posterior side.
      NOTE: To remove extra imaginal discs from the samples, cut the connections between the brain, eye discs, and leg discs with a needle knife.
   4. Repeat the steps 1.4.1-1.4.4 for other samples.
      NOTE: To prevent tissue debris from sticking to the samples, transfer each completed sample to a different clean dish filled with 0.3% PBT or PBS.
   5. Transfer the samples to the center of a clean glass slide with a micropipette.
      NOTE: For 2^nd or 3^rd instar larvae, the end of a micropipette tip should be truncated with a razor blade.
   6. Under a dissecting microscope, align individual samples with their dorsal side up by using forceps.
      NOTE: The RG is located on the dorsal side of the brain (Figure 2A). This alignment facilitates the specification of individual samples during imaging.
   7. Tilt a glass slide and wipe off as much excess PBT as possible. Put a drop of mounting reagent on a side of the slide. Place the edge of a cover slip from the other side of the drop and put the cover slip on the samples slowly with forceps.
      NOTE: This procedure prevents the samples from moving outside the cover slip.
   8. Store the samples at 4 °C. Keep the samples in the dark.

Access restricted. Please log in or start a trial to view this content.

结果

Figure 1: The overall scheme of protocols. Two distinct dissection methods are applicable to larvae and adult females, depending on the purpose of the experiments. The mounting methods are also devised according to sample conditions. Fixation, staining, and imaging techniques are basically common to all samples. Please click here...

Access restricted. Please log in or start a trial to view this content.

材料

Name	Company	Catalog Number	Comments
Egg collection
tissue culture dish (55 mm)	AS ONE	1-8549-02	for grape-juice agar plates
collection cup	HIKARI KAGAKU
yeast paste	Oriental dry yeast, Tokyo
100% grape juice	Welch Food Inc.
rearing larvae
small vials (12ml, 40×23.5 mm, PS)	SARSTEDT	58.487
disposable loop	AS ONE	6-488-01
standard fly food			The recipe is on the website of Bloomington stock center.
Dissection
dissecting microscope	Carl Zeiss	Stemi 2000-C
dissecting microscope	Leica	S8 AP0
tissue culture dish (35 x 10 mm, non-treated)	IWAKI	1000-035
Sylgard	TORAY		coarting silicon inside dishes
Terumo needle (27G, 0.40 x 19 mm)	TERUMO	NN-2719S	A "knife" to cut the tissue
forceps, Inox, #5	Dumont, Switzerland
insect pin (0.18 mm in diameter)	Shiga Brand		for fillet dissection
micro scissors	NATSUME SEISAKUSHO CO LTD.	MB-50-10
Fixation
ultrapure water	Merck Millipore
phosphate buffered saline (PBS)
Formaldehyde	Nacalai tesque	16222-65
Paraformaldehyde	Nacalai tesque	02890-45
Triton-X100	Nacalai tesque	35501-15
microtubes (1.5 ml)	INA OPTIKA	CF-0150
Incubation
As one swist mixer TM-300 (rocker)	As one	TM-300	rocker
Bovine Serum Albumin	SIGMA	9048-46-8
Primary antibody
anti-Sro (guinea pig), 1:1000
anti-GFP (rabbit), 1:1000	Molecular Probes	A6455	Shimada-Niwa ans Niwa, 2014
anti-GFP (mouse mAb, GF200), 1:100	Nakarai tesque	04363-66
anti-5HT (rabbit), 1:500	SIGMA	S5545
anti-Hts 1B1 (mouse)	Developmental Studies Hybridoma Bank (DSHB)	1B1
anti-DE-cadherin (rat), 1:20	DSHB	DCAD2
anti-nc82 (mouse), 1:50	DSHB	nc82
Secondary antibody
Goat anti-Rabbit IgG (H+L) Secondary Antibody, Alexa Fluor 488 conjugate	Life Technologies	A-11008
Goat anti-Mouse IgG (H+L) Secondary Antibody, Alexa Fluor 488 conjugate	Life Technologies	A-11001
Goat anti-Rat IgG (H+L) Secondary Antibody, Alexa Fluor 546 conjugate	Life Technologies	A-11081
Goat anti-Guinea Pig IgG (H+L) Secondary Antibody, Alexa Fluor 555 conjugate	Life Technologies	A-21435
Alexa Fluor 546 dye-conjugated phalloidin	Life Technologies	A-22283
Mounting reagents
Micro slide glass	Matsunami Glass Ind.,Ltd.	SS7213
Square microscope cover glass	Matsunami Glass Ind.,Ltd.	C218181
FluorSave reagent (Mounting reagent)	Calbiochem	345789
Transfer pipette 1 ml (Disposable dropper)	WATSON	5660-222-1S
Fly stocks
w; GMR45C06-GAL4			from Bloomington Drosophila Stock Center. (#46260)
UAS–GFP; UAS–mCD8::GFP			gifts from K. Ito, The University of Tokyo.
w[1118]
w; phantom-GAL4#22/UAS-turboRFP
w; UAS-mCD8::GFP; TRH-GAL4			Li, H. H. (2014) and Alekseyenko, O. V, Lee, C. & Kravitz, E. A. (2010)
w; UAS-mCD8::GFP			from Bloomington Drosophila Stock Center. (#32188)
yw;; nSyb-GAL4			from Bloomington Drosophila Stock Center. (#51941)