JoVE Logo

Sign In

Material Measurement Laboratory, National Institute of Standards and Technology

4 ARTICLES PUBLISHED IN JoVE

image

Chemistry

Disentangling High Strength Copolymer Aramid Fibers to Enable the Determination of Their Mechanical Properties
Amanda L. Forster 1, Viviana Rodriguez Cardenas 1, Ajay Krishnamurthy 1,2, Zois Tsinas 3, Amy Engelbrecht-Wiggans 1,2, Nolan Gonzalez 1
1Material Measurement Laboratory, National Institute of Standards and Technology, 2Theiss Research, 3University of Maryland

The primary goal of the study is to develop a protocol to prepare consistent specimens for accurate mechanical testing of high strength copolymer aramid fibers, by removing a coating and disentangling the individual fiber strands without introducing significant chemical or physical degradation.

image

JoVE Core

Cutting Procedures, Tensile Testing, and Ageing of Flexible Unidirectional Composite Laminates
Amy Engelbrecht-Wiggans 1,2, Ajay Krishnamurthy 1,2, Faraz Burni 1,3, William Osborn 1, Amanda L. Forster 1
1Material Measurement Laboratory, National Institute of Standards and Technology, 2Theiss Research, 3Chemical and Biomolecular Engineering Department, University of Maryland

The goal of the study was to develop protocols to prepare consistent specimens for accurate mechanical testing of high-strength aramid or ultra-high-molar-mass polyethylene-based flexible unidirectional composite laminate materials and to describe protocols for performing artificial ageing on these materials.

image

Engineering

Calibration Procedures for Orthogonal Superposition Rheology
Ran Tao 1,2, Aaron M. Forster 1
1Material Measurement Laboratory, National Institute of Standards and Technology, 2Department of Chemical Engineering, Texas Tech University

We present a detailed calibration protocol for a commercial orthogonal superposition rheology technique using Newtonian fluids including end-effect correction factor determination methods and recommendations for best practices to reduce experimental error.

image

Engineering

Solution Blow Spinning of Polymeric Nano-Composite Fibers for Personal Protective Equipment
Zois Tsinas 1,2, Ran Tao 1,3, Amanda L. Forster 1
1Material Measurement Laboratory, National Institute of Standards and Technology, 2Theiss Research, 3Department of Chemical Engineering, Texas Tech University

The primary goal of this study is to describe a protocol to prepare polymeric fiber mats with consistent morphology via solution blow spinning (SBS). We aim to use SBS to develop novel, tunable, flexible polymeric fiber nanocomposites for various applications, including protective materials, by incorporating nanoparticles in a polymer-elastomer matrix.

JoVE Logo

Privacy

Terms of Use

Policies

Research

Education

ABOUT JoVE

Copyright © 2024 MyJoVE Corporation. All rights reserved