After preparing the mouse for surgery and exposing the skull, place the bone screws in the extreme lateral, rostral or caudal portions of the skull where the bone is thickest and the bone screws are sufficiently far away from the micro drive implant. Use a scalpel blade or drill bit to score the skull near the bone screw hole locations, providing a rough surface for the liquid cyanoacrylate to bind. Then thread each bone screw into place, careful not to pierce the underlying dura.
Using a sterile 30-gauge needle, apply liquid cyanoacrylate around each bone screw, thickening the skull where the bone screws have been attached. Ensure that no cyanoacrylate enters the exposed dura above the recording sites.
