For at begynde skal du generere og behandle den computerassisterede designfil i STL-format. Placer glasunderlaget på holderen. Brug et elektronisk multimeter til at bekræfte, at indiumtinoxid eller ITO-belagt side af glassubstratet er orienteret opad.
Og tape glasset grundigt. Under en kemisk damphætte påføres en dråbe IPS Photoresist i midten af glassubstratet, og indsæt holderen i 3D-printeren med harpiksdråben vendt mod målet. Gennem softwarefilmenuen skal du indlæse GWL-filerne, vælge Approach Sample og derefter finde Interface.
Vælg Start job for at starte udskrivningen. Og når du er færdig, skal du trykke på Exchange Holder. Fjern forsigtigt underlaget med den trykte del.
Og under en røghætte inkuberes glassubstratet i PGMEA efterfulgt af isopropanol. For at hærde den lufttørrede trykte del skal du udsætte den for 365 til 405 nanometer UV-lys i fem til 20 minutter. Under en laminær strømningshætte skal du forsigtigt fjerne den trykte del fra glassubstratet og placere den på en to mikroliter dråbe harpiks i en petriskål.
Efter fem minutters UV-eksponering skal du afslutte skålen og inkubere ved 80 grader Celsius i 30 minutter.