For å begynne, generere og behandle den datamaskinassisterte designfilen i STL-format. Plasser glassunderlaget på holderen. Bruk et elektronisk multimeter til å bekrefte at indiumtinnoksidet eller den ITO-belagte siden av glasssubstratet er orientert oppover.
Og teip glasset grundig. Under en kjemisk avtrekkshette påfører du en dråpe IPS Photoresist i midten av glasssubstratet, og setter holderen inn i 3D-skriveren med harpiksdråpen mot målet. Gjennom programvarefilmenyen laster du inn GWL-filene, velger Approach Sample, og finner deretter Interface.
Velg Start jobb for å starte utskriften. Og når du er ferdig, trykker du på Exchange Holder. Fjern underlaget forsiktig med den trykte delen.
Og under en avtrekkshette, inkuber glasssubstratet i PGMEA etterfulgt av isopropanol. For å herde den lufttørkede trykte delen, utsett den for 365 til 405 nanometer UV-lys i fem til 20 minutter. Under en laminær strømningshette, fjern forsiktig den trykte delen fra glassunderlaget og legg den på en to mikroliters dråpe harpiks i en petriskål.
Etter fem minutter med UV-eksponering, kork fatet og inkuber ved 80 grader Celsius i 30 minutter.