Om te beginnen print je een 3D-mal met behulp van twee fotonpolymerisatie en monteer je deze op een petrischaal, die nu een mal wordt genoemd. Voor de fabricage van het apparaat incubeert u de mal gedurende zeven minuten met 10 microliter hydrofoob middel en spoelt u deze af met 70% ethanol, gevolgd door twee keer gedeïoniseerd water. Voeg het eerder bereide PDMS-mengsel voorzichtig toe aan de mal totdat de beoogde eindhoogte van het apparaat is bereikt.
Incubeer de afgedekte vorm in een voorverwarmde oven van 80 graden Celsius gedurende 18 minuten. Maak vervolgens het uitgeharde PDMS-blok voorzichtig los van de mal onder de laminaire stroomkap en dompel het 10 minuten onder in isopropanol in een glazen petrischaal. Snijd onder een stereomicroscoop met behulp van een oogheelkundig steekmes voorzichtig het centrale vierkante gedeelte uit en vervolgens langs de randen van het apparaat.
Dompel het apparaat vervolgens 30 minuten onder in ethanol. Breng het apparaat onder een laminaire stroomkap over in een nieuwe petrischaal en laat het drogen.