fabrication-dipole-assisted-solid-phase-extraction-microchip-for

Fabrication of a Dipole-assisted Solid Phase Extraction Microchip for Trace Metal Analysis in Water Samples

This paper describes a fabrication protocol for a dipole-assisted solid phase extraction (SPE) microchip available for trace metal analysis in water ...

National Synchrotron Radiation Research Center

A nano-structured Co oxide electrode (with a Ni substrate) was successfully prepared using an entirely electrochemical process, which included the co-deposition of a Ni-Cu alloy film, selective etching of Cu from the film, and anodic deposition of Co oxide on the obtained nano-porous Ni substrate which had an average pore size of approximately 100 nm and a pore density of about 10(13) m(-2). The excellent electrochemical activity of the prepared electrode was demonstrated in terms of its pseudocapacitive performance, which was evaluated using cyclic voltammetry (CV) in 1 M KOH solution. The specific capacitance of the nano-structured Co oxide measured at a potential scan rate of 10 mV s(-1) was as high as 2200 F g(-1), which is over ten times higher than that of a flat oxide electrode (209 F g(-1)). The highly porous Co oxide also had superior kinetic performance as compared to a flat electrode. At a high CV scan rate of 50 mV s(-1), the two electrodes retained 94% and 59%, respectively, of their specific capacitances measured at 5 mV s(-1).

An entirely electrochemical preparation of a nano-structured cobalt oxide electrode with superior redox activity.

The electrochemical behavior of anodically deposited manganese oxide was studied in pyrrolidinium formate (P-HCOO), 1-butyl-3-methylimidazolium hexafluorophosphate (BMI-PF6), and 1-ethyl-3-methylimidazolium thiocyanate (EMI-SCN) ionic liquids (ILs). The experimental data indicate that the Mn oxide electrode showed ideal pseudocapacitive performance in aprotic EMI-SCN IL. In a potential window of approximately 1.5 V, the oxide specific capacitance, evaluated using cyclic voltammetry and chronopotentiometry, was about 55 F/g. The electrochemical energy storage reaction was examined using X-ray photoelectron spectroscopy (XPS). It was confirmed that the SCN- anions, instead of the EMI+ cations, were the primary working species that can become incorporated into the oxide and thus compensate the Mn3+/Mn4+ valent state variation upon the charge-discharge process. According to the analytical results, a pseudocapacitive mechanism of Mn oxide in the SCN- based aprotic IL was proposed.

Pseudocapacitive mechanism of manganese oxide in 1-ethyl-3-methylimidazolium thiocyanate ionic liquid electrolyte studied using X-ray photoelectron spectroscopy.

With an ordered polystyrene (PS) template-assisted electrochemical approach we synthesized three-dimensional ordered macroporous (3DOM) Cu2O/Ni inverse opals as electrodes for supercapacitors. The 3DOM Cu2O/Ni electrodes display superior kinetic performance, and satisfactory rate capability and cycling performance.

Three-dimensionally ordered macroporous Cu2O/Ni inverse opal electrodes for electrochemical supercapacitors.

We employed a polymeric material, poly(methyl methacrylate) (PMMA), for fabricating a microdevice and then implanted the chlorine (Cl)-containing solid-phase extraction (SPE) functionality into the PMMA chip to develop an innovative on-chip dipole-assisted SPE technique. Instead of the ion-ion interactions utilized in on-chip SPE techniques, the dipole-ion interactions between the highly electronegative C-Cl moieties in the channel interior and the positively charged metal ions were employed to facilitate the on-chip SPE procedures. Furthermore, to avoid labor-intensive manual manipulation, a programmable valve manifold was designed as an interface combining the dipole-assisted SPE microchip and inductively coupled plasma-mass spectrometry (ICP-MS) to achieve the fully automated operation. Under the optimized operation conditions for the established system, the detection limits for each analyte ion were obtained based on three times the standard deviation of seven measurements of the blank eluent solution. The limits ranged from 3.48 to 20.68 ng L(-1), suggesting that this technique appears uniquely suited for determining the levels of heavy metal ions in natural water. Indeed, a series of validation procedures demonstrated that the developed method could be satisfactorily applied to the determination of trace heavy metals in natural water. Remarkably, the developed device was durable enough to be reused more than 160 times without any loss in its analytical performance. To the best of our knowledge, this is the first study reporting on the combination of a dipole-assisted SPE microchip and elemental analysis instrument for the online determination of trace heavy metal ions.

A dipole-assisted solid-phase extraction microchip combined with inductively coupled plasma-mass spectrometry for online determination of trace heavy metals in natural water.

Large-area Co(OH)2-based supercapacitor electrodes composed of nanotube arrays grown on a 3D nickel-foam (CONTA) electrode and sucker-like nanoporous films grown on a 3D nickel-foam (COSNP) electrode were prepared with a facile electrochemical method for applications in energy storage. These nanoporous Co(OH)2 electrodes were fabricated with the codeposition of Cu/Ni film on the nickel foam, then etching of Cu from the Cu/Ni layer to form Ni nanotube arrays and sucker-like Ni nanoporous layers, and further cathodic deposition of Co(OH)2 on the prepared nanoporous Ni substrates. The CONTA and COSNP electrodes exhibited specific capacitances of 2500 and 2900 F/g in a voltage range of 0.65 V (capacitance of the substrates deducted from the total) at 1 A/g in a three electrode cell, respectively. The COSNP electrode demonstrated an excellent supercapacitive performance with specific capacitances 1100 F/g at 1 A/g and 850 F/g at 20 A/g in a voltage range of 1.2 V in a two electrode cell. The remarkable performance of COSNP electrodes correlated with a large conversion of the Co oxidation state during the charge/discharge cycling were examined by in situ X-ray absorption near edge structure (XANES).

Ming-Jay Deng

National Synchrotron Radiation Research Center

Fabrication of a Dipole-assisted Solid Phase Extraction Microchip for Trace Metal Analysis in Water Samples