flame-experiments-at-advanced-light-source-new-insights-into-soot

Flame Experiments at the Advanced Light Source: New Insights into Soot Formation Processes

The following experimental protocols and the accompanying video are concerned with the flame experiments that are performed at the Chemical Dynamics ...

Sandia National Laboratories

Version 3 of the Atmospheric Trace Molecule Spectroscopy (ATMOS) experiment data set for some 30 trace and minor gas profiles is available. From the IR solar-absorption spectra measured during four Space Shuttle missions (in 1985, 1992, 1993, and 1994), profiles from more than 350 occultations were retrieved from the upper troposphere to the lower mesosphere. Previous results were unreliable for tropospheric retrievals, but with a new global-fitting algorithm profiles are reliably returned down to altitudes as low as 6.5 km (clouds permitting) and include notably improved retrievals of H2O, CO, and other species. Results for stratospheric water are more consistent across the ATMOS spectral filters and do not indicate a net consumption of H2 in the upper stratosphere. A new sulfuric-acid aerosol product is described. An overview of ATMOS Version 3 processing is presented with a discussion of estimated uncertainties. Differences between these Version 3 and previously reported Version 2 ATMOS results are discussed. Retrievals are available at http://atmos.jpl.nasa.gov/atmos.

Atmospheric Trace Molecule Spectroscopy (ATMOS) Experiment Version 3 data retrievals.

We present a data set for testing models of time-resolved laser-induced incandescence of soot. Measurements were made in a laminar ethene diffusion flame over a wide range of laser fluences at 532 nm. The laser was seeded to provide a smooth temporal profile, and the beam was spatially filtered and imaged into the flame to provide a homogeneous spatial profile. The particle incandescence was imaged onto a fast photodiode. The measurements are compared with the standard Melton model [Appl. Opt. 23,2201 (1984)] and with a new model that incorporates physical mechanisms not included in the Melton model.

Time-resolved laser-induced incandescence of soot: the influence of experimental factors and microphysical mechanisms.

We investigated the physical and chemical changes induced in soot aggregates exposed to laser radiation using a scanning mobility particle sizer, a transmission electron microscope, and a scanning transmission x-ray microscope to perform near-edge x-ray absorption fine structure spectroscopy. Laser-induced nanoparticle production was observed at fluences above 0.12 J/cm(2) at 532 nm and 0.22 J/cm(2) at 1064 nm. Our results indicate that new particle formation proceeds via (1) vaporization of small carbon clusters by thermal or photolytic mechanisms, followed by homogeneous nucleation, (2) heterogeneous nucleation of vaporized carbon clusters onto material ablated from primary particles, or (3) both processes.

Particle formation from pulsed laser irradiation of soot aggregates studied with a scanning mobility particle sizer, a transmission electron microscope, and a scanning transmission x-ray microscope.

Spontaneous emission measurements are discussed for the Swings transitions of the C(3) radical in laser-generated graphite plasma, and the spectroscopy of the C(3) radical in carbon vapor and plasma is summarized. A review is given of some theoretical calculations and emission spectroscopic investigations are presented. Time-averaged, laser-induced optical breakdown spectra are reported from Nd:YAG laser generated graphite microplasma. In 200-300 Torr of argon and helium, and depending on the specific experimental configuration, a weak emission continuum is observed centered at 400 nm when using a laser fluence of typically 1 J/cm(2). Such continua were not detected in our previous experiments using focused laser radiation. The possibilities for the origin of this continuum are considered.

Spontaneous emission from the C3 radical in carbon plasma.

Temporal behavior of pulses from a Q-switched Nd:YAG laser with an unstable resonator can vary significantly with radial position in the beam. Our laser provides pulses with position-dependent durations spanning 8-11.5 ns at 1064 nm and 7-10 ns at 532 nm. Pulses emerge first and have the longest duration at the center of the beam; they are shorter (by up to 4 ns) and increasingly delayed (by up to 10 ns) with increasing radial distance from the center. This behavior can have a dramatic effect on time-sensitive experiments, such as laser-induced incandescence of soot, if not taken into account.

Complications to optical measurements using a laser with an unstable resonator: a case study on laser-induced incandescence of soot.

Motivated by the question of whether and how a state-of-the-art regional chemical transport model (CTM) can facilitate characterization of CO2 spatiotemporal variability and verify CO2 fossil-fuel emissions, we for the first time applied the Community Multiscale Air Quality (CMAQ) model to simulate CO2. This paper presents methods, input data, and initial results for CO2 simulation using CMAQ over the contiguous United States in October 2007. Modeling experiments have been performed to understand the roles of fossil-fuel emissions, biosphere-atmosphere exchange, and meteorology in regulating the spatial distribution of CO2 near the surface over the contiguous United States. Three sets of net ecosystem exchange (NEE) fluxes were used as input to assess the impact of uncertainty of NEE on CO2 concentrations simulated by CMAQ. Observational data from six tall tower sites across the country were used to evaluate model performance. In particular, at the Boulder Atmospheric Observatory (BAO), a tall tower site that receives urban emissions from Denver CO, the CMAQ model using hourly varying, high-resolution CO2 fossil-fuel emissions from the Vulcan inventory and Carbon Tracker optimized NEE reproduced the observed diurnal profile of CO2 reasonably well but with a low bias in the early morning. The spatial distribution of CO2 was found to correlate with NO(x), SO2, and CO, because of their similar fossil-fuel emission sources and common transport processes. These initial results from CMAQ demonstrate the potential of using a regional CTM to help interpret CO2 observations and understand CO2 variability in space and time. The ability to simulate a full suite of air pollutants in CMAQ will also facilitate investigations of their use as tracers for CO2 source attribution. This work serves as a proof of concept and the foundation for more comprehensive examinations of CO2 spatiotemporal variability and various uncertainties in the future. Implications: Atmospheric CO2 has long been modeled and studied on continental to global scales to understand the global carbon cycle. This work demonstrates the potential of modeling and studying CO2 variability at fine spatiotemporal scales with CMAQ, which has been applied extensively, to study traditionally regulated air pollutants. The abundant observational records of these air pollutants and successful experience in studying and reducing their emissions may be useful for verifying CO2 emissions. Although there remains much more to further investigate, this work opens up a discussion on whether and how to study CO2 as an air pollutant.

Article	Year
Atmospheric Trace Molecule Spectroscopy (ATMOS) Experiment Version 3 data retrievals. Applied optics\| PubMed ID: 12463241	2002
Time-resolved laser-induced incandescence of soot: the influence of experimental factors and microphysical mechanisms. Applied optics\| PubMed ID: 14526849	2003
Particle formation from pulsed laser irradiation of soot aggregates studied with a scanning mobility particle sizer, a transmission electron microscope, and a scanning transmission x-ray mic... Applied optics\| PubMed ID: 17279144	2007
Spontaneous emission from the C3 radical in carbon plasma. Applied optics\| PubMed ID: 17571143	2007
Complications to optical measurements using a laser with an unstable resonator: a case study on laser-induced incandescence of soot. Applied optics\| PubMed ID: 18026549	2007
Toward verifying fossil fuel CO2 emissions with the CMAQ model: motivation, model description and initial simulation. Journal of the Air & Waste Management Association (1995)\| PubMed ID: 24843913	2014

Hope A. Michelsen

Biography

JoVE Journal Publications

Other Publications