rapid-nanoprobe-signal-enhancement-situ-gold-nanoparticle

Rapid Nanoprobe Signal Enhancement by <em>In Situ</em> Gold Nanoparticle Synthesis

The use of nanoprobes such as gold, silver, silica or iron-oxide nanoparticles as detection reagents in bioanalytical assays can enable high sensitivity ...

KTH Royal Institute of Technology

Reverse phase microarrays are useful tools for affinity-based detection in hundreds of samples simultaneously. However, current methods typically require long assay times and fluorescent detection. Here we describe a paper-based Vertical Flow Microarray (VFM) assay as a rapid 8-minute colorimetric alternative for reverse phase microarray analysis. The VFM platform was optimized for detection of IgE with a detection limit of 1.9 μg mL(-1) in whole serum. Optimized conditions were then used to screen 113 serum samples simultaneously for hyper IgE syndrome (hIgE), a rare primary immunodeficiency characterized by elevated levels of IgE. The same set of samples were then analysed with a conventional planar microarray with fluorescent detection for head-to-head testing. Both assays found elevated levels in three out of four hIgE patient samples, whereas no control samples displayed elevated levels in either method. The comparison experiments showed a good correlation between the two assays, as determined from a linear correlation study (Pearson's r = 0.76). Further, the assay-time reduction and reproducibility (intra assay CV = 12.4 ± 4.11%) demonstrate the applicability of the VFM platform for high throughput reverse phase screening.

An 8 minute colorimetric paper-based reverse phase vertical flow serum microarray for screening of hyper IgE syndrome.

Protein microarrays are useful tools for highly multiplexed determination of presence or levels of clinically relevant biomarkers in human tissues and biofluids. However, such tools have thus far been restricted to laboratory environments. Here, we present a novel 384-plexed easy to use lateral flow protein microarray device capable of sensitive (<30 ng/mL) determination of antigen-specific antibodies in ten minutes of total assay time. Results were developed with gold nanobeads and could be recorded by a cell-phone camera or table top scanner. Excellent accuracy with an area under curve (AUC of 98% was achieved in comparison with an established glass microarray assay for 26 antigen-specific antibodies. We propose that the presented framework could find use in convenient and cost-efficient quality control of antibody production, as well as in providing a platform for multiplexed affinity-based assays in low-resource or mobile settings.

A lateral flow protein microarray for rapid and sensitive antibody assays.

There is a growing need for multiplexed specific IgE tests that can accurately evaluate patient sensitization profiles. However, currently available commercial tests are either single/low-plexed or require sophisticated instrumentation at considerable cost per assay. Here, we present a novel convenient lateral flow microarray-based device that employs a novel dual labelled gold nanoparticle-strategy for rapid and sensitive detection of a panel of 15 specific IgE responses in 35 clinical serum samples. Each gold nanoparticle was conjugated to an optimized ratio of HRP and anti-IgE, allowing significant enzymatic amplification to improve the sensitivity of the assay as compared to commercially available detection reagents. The mean inter-assay variability of the developed LFM assay was 12% CV, and analysis of a cohort of clinical samples (n = 35) revealed good general agreement with ImmunoCAP, yet with a varying performance among allergens (AUC = [0.54-0.88], threshold 1 kU). Due to the rapid and simple procedure, inexpensive materials and read-out by means of a consumer flatbed scanner, the presented assay may provide an interesting low-cost alternative to existing multiplexed methods when thresholds >1 kU are acceptable.

A lateral flow paper microarray for rapid allergy point of care diagnostics.

Sophisticated equipment, lengthy protocols, and skilled operators are required to perform protein microarray-based affinity assays. Consequently, novel tools are needed to bring biomarkers and biomarker panels into clinical use in different settings. Here, we describe a novel paper-based vertical flow microarray (VFM) system with a multiplexing capacity of at least 1480 microspot binding sites, colorimetric readout, high sensitivity, and assay time of <10 min before imaging and data analysis.

Point-of-care vertical flow allergen microarray assay: proof of concept.

Passive particle focusing based on inertial microfluidics was recently introduced as a high-throughput alternative to active focusing methods that require an external force field to manipulate particles. In inertial microfluidics, dominant inertial forces cause particles to move across streamlines and occupy equilibrium positions along the faces of walls in flows through straight micro channels. In this study, we systematically analyzed the addition of secondary Dean forces by introducing curvature and show how randomly distributed particles entering a simple u-shaped curved channel are focused to a fixed lateral position exiting the curvature. We found the lateral particle focusing position to be fixed and largely independent of radius of curvature and whether particles entering the curvature are pre-focused (at equilibrium) or randomly distributed. Unlike focusing in straight channels, where focusing typically is limited to channel cross-sections in the range of particle size to create single focusing point, we report here particle focusing in a large cross-section area (channel aspect ratio 1:10). Furthermore, we describe a simple u-shaped curved channel, with single inlet and four outlets, for filtration applications. We demonstrate continuous focusing and filtration of 10 μm particles (with >90% filtration efficiency) from a suspension mixture at throughputs several orders of magnitude higher than flow through straight channels (volume flow rate of 4.25 ml/min). Finally, as an example of high throughput cell processing application, white blood cells were continuously processed with a filtration efficiency of 78% with maintained high viability. We expect the study will aid in the fundamental understanding of flow through curved channels and open the door for the development of a whole set of bio-analytical applications.

Dean flow-coupled inertial focusing in curved channels.

In vitro tissue/organ models are useful platforms that can facilitate systematic, repetitive, and quantitative investigations of drugs/chemicals. The primary objective when developing tissue/organ models is to reproduce physiologically relevant functions that typically require complex culture systems. Bioprinting offers exciting prospects for constructing 3D tissue/organ models, as it enables the reproducible, automated production of complex living tissues. Bioprinted tissues/organs may prove useful for screening novel compounds or predicting toxicity, as the spatial and chemical complexity inherent to native tissues/organs can be recreated. In this Review, we highlight the importance of developing 3D in vitro tissue/organ models by 3D bioprinting techniques, characterization of these models for evaluating their resemblance to native tissue, and their application in the prioritization of lead candidates, toxicity testing, and as disease/tumor models.

3D Bioprinting of Tissue/Organ Models.

Highly multiplexed point of care tests could improve diagnostic accuracy and differential diagnostic capacity in for instance emergency medicine and low resource environments. Available technology platforms for POC biomarker detection are typically simplex or low-plexed, whereas common lab-based microarray systems allow for the simultaneous detection of thousands of DNA or protein biomarkers. In this study, we demonstrate a novel suspension particle array platform that utilizes 900 μm bricks for POC amenable colorimetric biomarker detection with an encoding capacity of over two million. Due to the mm-scale size, both the lithographic codes and colorimetric signals of individual particles can be visualized using a consumer grade office flatbed scanner, with a potential for simultaneous imaging of around 19 000 particles per scan. The analytical sensitivity of the assay was determined to be 4 ng mlusing an antibody model system. As a proof of concept, autoantibodies toward anoctamin 2 were detected in order to discriminate between multiple sclerosis plasma samples and healthy controls with p < 0.0001 and an inter-assay % CV of 9.44%.

Towards encoded particles for highly multiplexed colorimetric point of care autoantibody detection.

Point-of-care (POC) tests have become increasingly available and more widely used in recent years. They have been of particular importance to low-income settings, enabling them with clinical capacities that had previously been limited. POC testing programs hold a great potential for significant improvement in low-income health systems. However, as most POC tests are developed in high-income countries, disengagement between developers and end-users inhibit their full potential. This study explores perceptions of POC test end-users in a low-income setting, aiming to support the development of novel POC tests for low-income countries.

Health care workers' perceptions of point-of-care testing in a low-income country-A qualitative study in Southwestern Uganda.

The introduction of nanomaterials as detection reagents has enabled improved sensitivity and facilitated detection in a variety of bioanalytical assays. However, high nanoprobe densities are typically needed for colorimetric detection and to circumvent this limitation several enhancement protocols have been reported. Nevertheless, there is currently a lack of universal, enzyme-free and versatile methods that can be readily applied to existing as well as new biosensing strategies. The novel method presented here is shown to enhance the signal of gold nanoparticles enabling visual detection of a spot containing <10 nanoparticles. Detection of Protein G on paper arrays was improved by a 100-fold amplification factor in under five minutes of assay time, using IgG-labelled gold, silver, silica and iron oxide nanoprobes. Furthermore, we show that the presented protocol can be applied to a commercial allergen microarray assay, ImmunoCAP ISAC sIgE 112, attaining a good agreement with fluorescent detection when analysing human clinical samples.

Jesper Gantelius

Division of Proteomics and Nanobiotechnology,
Science for Life Laboratory,
Division of Proteomics and Nanobiotechnology, Science for Life Laboratory

KTH Royal Institute of Technology

Rapid Nanoprobe Signal Enhancement by In Situ Gold Nanoparticle Synthesis

Jesper Gantelius

.css-o250i3{font-size:18px;font-family:Open Sans,sans-serif;line-height:21.6px;}Division of Proteomics and Nanobiotechnology,Science for Life Laboratory,Division of Proteomics and Nanobiotechnology, Science for Life Laboratory

KTH Royal Institute of Technology

Rapid Nanoprobe Signal Enhancement by In Situ Gold Nanoparticle Synthesis

Division of Proteomics and Nanobiotechnology,
Science for Life Laboratory,
Division of Proteomics and Nanobiotechnology, Science for Life Laboratory