assessment-acute-inhalation-toxicity-airborne-particles-exposing

Assessment of the Acute Inhalation Toxicity of Airborne Particles by Exposing Cultivated Human Lung Cells at the Air-Liquid Interface

Here, we present a specially designed modular in vitro exposure system that enables the homogenous exposure of cultivated human lung cells at the ALI to ...

Cultex Laboratories GmbH

Cultex Technologies GmbH (formerly Cultex Laboratories GmbH)

E-cigarettes are emerging products, often described as "reduced-risk" nicotine products or alternatives to combustible cigarettes. Many smokers switch to e-cigarettes to quit or significantly reduce smoking. However, no regulations for e-cigarettes are currently into force, so that the quality and safety of e-liquids is not necessarily guaranteed. We exposed primary human bronchial epithelial cells of two different donors to vapor of e-cigarette liquid with or without nicotine, vapor of the carrier substances propylene glycol and glycerol as well as to mainstream smoke of K3R4F research cigarettes. The exposure was done in a CULTEX® RFS compact  module, allowing the exposure of the cells at the air-liquid interface. 24 h post-exposure, cell viability and oxidative stress levels in the cells were analyzed. We found toxicological effects of e-cigarette vapor and the pure carrier substances, whereas the nicotine concentration did not have an effect on the cell viability. The viability of mainstream smoke cigarette exposed cells was 4.5-8 times lower and the oxidative stress levels 4.5-5 times higher than those of e-cigarette vapor exposed cells, depending on the donor. Our experimental setup delivered reproducible data and thus provides the opportunity for routine testing of e-cigarette liquids to ensure safety and quality for the user. 

Evaluation of E-cigarette liquid vapor and mainstream cigarette smoke after direct exposure of primary human bronchial epithelial cells.

The in vitro toxicological evaluation of e-liquid aerosol is an important aspect of consumer protection, but the cell model is of great significance. Due to its water solubility, e-liquid aerosol is deposited in the conducting zone of the respiratory tract. Therefore, primary normal human bronchial epithelial (NHBE) cells are more suitable for e-liquid aerosol testing than the widely used alveolar cell line A549. Due to their prolonged lifespan, immortalized cell lines derived from primary NHBE cells, exhibiting a comparable in vitro differentiation, might be an alternative for acute toxicity testing. In our study, A549 cells freshly isolated NHBE cells and the immortalized cell line CL-1548 were exposed at the air-liquid interface to e-liquid aerosol and cigarette mainstream smoke in a CULTEX(®) RFS compact module. The cell viability was analyzed 24 h post-exposure. In comparison with primary NHBE cells, the CL-1548 cell line showed lower sensitivity to e-liquid aerosol but significantly higher sensitivity compared to A549 cells. Therefore, the immortalized cell line CL-1548 is recommended as a tool for the routine testing of e-liquid aerosol and is preferable to A549 cells. 

Cytotoxic Evaluation of e-Liquid Aerosol using Different Lung-Derived Cell Models.

Response to Polosa et al. Comments on Scheffler et al. Cytotoxic Evaluation of E-Liquid Aerosol Using Different Lung Derived Cell Models. Int. J. Environ. Res. Public Health, 2015, 12, 12466-12474.

The exposure of cellular based systems cultivated on microporous membranes at the air-liquid interface (ALI) has been accepted as an appropriate approach to simulate the exposure of cells of the respiratory tract to native airborne substances. The efficiency of such an exposure procedure with regard to stability and reproducibility depends on the optimal design at the interface between the cellular test system and the exposure technique. The actual exposure systems favor the dynamic guidance of the airborne substances to the surface of the cells in specially designed exposure devices. Two module types, based on a linear or radial feed of the test atmosphere to the test system, were used for these studies. In our technical history, the development started with the linear designed version, the CULTEX glass modules, fulfilling basic requirements for running ALI exposure studies (Mohr and Durst, 2005). The instability in the distribution of different atmospheres to the cells caused us to create a new exposure module, characterized by a stable and reproducible radial guidance of the aerosol to the cells. The outcome was the CULTEX RFS (Mohr et al., 2010). In this study, we describe the differences between the two systems with regard to particle distribution and deposition clarifying the advantages and disadvantages of a radial to a linear aerosol distribution concept.

Olaf Krischenowski

Cultex Laboratories GmbH

Assessment of the Acute Inhalation Toxicity of Airborne Particles by Exposing Cultivated Human Lung Cells at the Air-Liquid Interface