formation-thick-dense-yttrium-iron-garnet-films-using-aerosol

Formation of Thick Dense Yttrium Iron Garnet Films Using Aerosol Deposition

Aerosol deposition (AD) is a thick-film deposition process that can produce layers up to several hundred micrometers thick with densities greater than 95% ...

Naval Research Laboratory

To make graphene technologically viable, the transfer of graphene films to substrates appropriate for specific applications is required. We demonstrate the dry transfer of epitaxial graphene (EG) from the C-face of 4H-SiC onto SiO(2), GaN and Al(2)O(3) substrates using a thermal release tape. Subsequent Hall effect measurements illustrated that minimal degradation in the carrier mobility was induced following the transfer process in lithographically patterned devices. Correspondingly, a large drop in the carrier concentration was observed following the transfer process, supporting the notion that a gradient in the carrier density is present in C-face EG, with lower values being observed in layers further removed from the SiC interface. X-ray photoemission spectra collected from EG films attached to the transfer tape revealed the presence of atomic Si within the EG layers, which may indicate the identity of the unknown intrinsic dopant in EG. Finally, this transfer process is shown to enable EG films amenable for use in device fabrication on arbitrary substrates and films that are deemed most beneficial to carrier transport, as flexible electronic devices or optically transparent contacts.

Fritz J. Kub

Power Electronics Branch

Naval Research Laboratory

Formation of Thick Dense Yttrium Iron Garnet Films Using Aerosol Deposition

Fritz J. Kub

.css-o250i3{font-size:18px;font-family:Open Sans,sans-serif;line-height:21.6px;}Power Electronics Branch

Naval Research Laboratory

Formation of Thick Dense Yttrium Iron Garnet Films Using Aerosol Deposition

Power Electronics Branch