fabrication-polymer-microspheres-for-optical-resonator-laser

Fabrication of Polymer Microspheres for Optical Resonator and Laser Applications

This paper describes three methods of preparing fluorescent microspheres comprising &#960;-conjugated or non-conjugated polymers: vapor diffusion, ...

university of tsukuba

Confinement of light inside an active medium cavity can amplify emission. Whispering gallery mode (WGM) is one of mechanisms that amplifies light effectively by confining it inside high-refractive-index microstructures, where light propagates along the circumference of a sphere via total internal reflection. Here we show that isolated single microspheres of 2-10 μm diameter, formed from self-assembly of π-conjugated alternating copolymers, display WGM photoemission induced by laser pumping. The wavelengths of the emission peaks depend sensitively on the sphere size, position of the excitation spot and refractive index of each polymer. The Q-factor increases with increasing sphere diameter and displays a linear correlation with the reciprocal radius, indicating that the small curvature increases the efficacy of the total internal reflection. WGM photoemission from π-conjugated polymer microspheres is unprecedented and may be of high technological impact since the microspheres fulfill the role of fluorophores, high-refractive-index media and resonators simultaneously, in addition to their simple fabrication process.

Self-assembled conjugated polymer spheres as fluorescent microresonators.

We investigate the whispering gallery modes (WGMs) of self-assembled single microspheres. They consist of a recently developed highly fluorescent π-conjugated copolymer and exhibit excellent optical properties with Q-factors up to 10(4). Under continuous laser irradiation, we observe a splitting of the highly degenerate spherical WGMs into a multiplet of lines. Comparison with the calculated spectral response of a weakly distorted sphere shows that the optical excitation induces a change of the optical path length in the microcavity so that it resembles a prolate spheroid. The separation of the lines is given by the ellipticity and the azimuthal mode number. Measurements in various gaseous environments suggest that the distortion is caused by light induced oxidation of the polymer. Our findings show that photooxidation can be a beneficial mechanism for in-situ tuning of optically active polymer structures.

Optically induced mode splitting in self-assembled, high quality-factor conjugated polymer microcavities.

Highly luminescent π-conjugated polymeric microspheres were fabricated through self-assembly of energy-donating and energy-accepting polymers and their blends. To avoid macroscopic phase separation, the nucleation time and growth rate of each polymer in the solution were properly adjusted. Photoluminescence (PL) studies showed that efficient donor-to-acceptor energy transfer takes place inside the microspheres, revealing that two polymers are well-blended in the microspheres. Focused laser irradiation of a single microsphere excites whispering gallery modes (WGMs), where PL generated inside the sphere is confined and resonates. The wavelengths of the PL lines are finely tuned by changing the blending ratio, accompanying the systematic yellow-to-red color change. Furthermore, when several microspheres are coupled linearly, the confined PL propagates the microspheres through the contact point, and a cascade-like process converts the PL color while maintaining the WGM characteristics. The self-assembly strategy for the formation of polymeric nano- to microstructures with highly miscible polymer blends will be advantageous for optoelectronic and photonic device applications.

Conjugated Polymer Blend Microspheres for Efficient, Long-Range Light Energy Transfer.

We report a sensor array composed of a highly fluorescent positively charged poly(para-phenyleneethynylene) P1 and its complex C with a negatively charged pyridine-containing poly(para-aryleneethynylene) P2 (quencher) at pH 10 and pH 13; a sensor field composed of four elements, P1 (pH 10), P1 (pH 13), C (pH 10), and C (pH 13), results. The elements of this small sensor field experience either fluorescence turn on or fluorescence quenching upon exposure toward nonsteroidal anti-inflammatory drugs (NSAIDs), such as aspirin, ibuprofen, diclofenac, or naproxen. The combined responses of the sensor field are analyzed by linear discriminant analysis (LDA). All of the NSAIDs were identified and discriminated, and the sensing mechanism, hydrophobic versus electrostatic, was discussed.

Soh Kushida

Faculty of Pure and Applied Sciences

university of tsukuba

Fabrication of Polymer Microspheres for Optical Resonator and Laser Applications

Soh Kushida

.css-o250i3{font-size:18px;font-family:Open Sans,sans-serif;line-height:21.6px;}Faculty of Pure and Applied Sciences

university of tsukuba

Fabrication of Polymer Microspheres for Optical Resonator and Laser Applications

Faculty of Pure and Applied Sciences