preparation-janus-particles-alternating-current-electrokinetic

Preparation of Janus Particles and Alternating Current Electrokinetic Measurements with a Rapidly Fabricated Indium Tin Oxide Electrode Array

This article provides a simple method to prepare partially or fully coated metallic particles and to perform the rapid fabrication of electrode arrays, ...

National Taiwan University

Measurement of energy dissipation in small nonequilibrium systems is generally a difficult task. Recently, Harada and Sasa [Phys. Rev. Lett. 95, 130602 (2005)] derived an equality relating the energy dissipation rate to experimentally accessible quantities in nonequilibrium steady states described by the Langevin equation. Here, we show an experimental test of this new relation in an optically driven colloidal system. We find that this equality is validated to a fairly good extent, thus the irreversible work of a small system is estimated from readily obtainable quantities.

Experimental test of a new equality: measuring heat dissipation in an optically driven colloidal system.

The nonequilibrium distribution of colloids in a polymer solution under a temperature gradient is studied experimentally. A slight increase of local temperature by a focused laser drives the colloids towards the hot region, resulting in the trapping of the colloids irrespective of their own thermophoretic properties. An amplification of the trapped colloid density with the polymer concentration is measured, and is quantitatively explained by hydrodynamic theory. The origin of the attraction is a migration of colloids driven by a nonuniform polymer distribution sustained by the polymer's thermophoresis. These results show how to control the thermophoretic properties of colloids.

Manipulation of colloids by a nonequilibrium depletion force in a temperature gradient.

We study self-propulsion of a half-metal coated colloidal particle under laser irradiation. The motion is caused by self-thermophoresis: i.e., absorption of a laser at the metal-coated side of the particle creates local temperature gradient which in turn drives the particle by thermophoresis. To clarify the mechanism, temperature distribution and a thermal slip flow field around a microscale Janus particle are measured for the first time. With measured temperature drop across the particle, the speed of self-propulsion is corroborated with the prediction based on accessible parameters. As an application for driving a micromachine, a microrotor is demonstrated.

Active motion of a Janus particle by self-thermophoresis in a defocused laser beam.

We demonstrate a functional rotating electrothermal technique for rapidly concentrating and sorting a large number of particles on a microchip by the combination of particle dielectrophoresis (DEP) and inward rotating electrothermal (RET) flows. Different kinds of particles can be attracted (positive DEP) to or repelled (negative DEP) from electrode edges, and then the n-DEP responsive particles are further concentrated in the heated region by RET flows. The RET flows arise from the spatial inhomogeneous electric properties of fluid caused by direct infrared laser (1470 nm) heating of solution in a rotating electric field. The direction of the RET flows is radially inward to the heated region with a co-field (the same as the rotating electric field) rotation. Moreover, the velocity of the RET flows is proportional to the laser power and the square of the electric field strength. The RET flows are significant over a frequency range from 200 kHz to 5 MHz. The RET flows are generated by the simultaneous application of the infrared laser and the rotating electric field. Therefore, the location of particle concentrating can be controlled within the rotating electric field depending on the position of the laser spot. This multi-field technique can be operated in salt solutions and at higher frequency without external flow pressure, and thus it can avoid electrokinetic phenomena at low frequency to improve the manipulation accuracy for lab-on-chip applications.

Hong-Ren Jiang

Institute of Applied Mechanics

National Taiwan University

Preparation of Janus Particles and Alternating Current Electrokinetic Measurements with a Rapidly Fabricated Indium Tin Oxide Electrode Array

Hong-Ren Jiang

.css-o250i3{font-size:18px;font-family:Open Sans,sans-serif;line-height:21.6px;}Institute of Applied Mechanics

National Taiwan University

Preparation of Janus Particles and Alternating Current Electrokinetic Measurements with a Rapidly Fabricated Indium Tin Oxide Electrode Array

Institute of Applied Mechanics