rapid-manufacturing-of-thin-soft-pneumatic-actuators-and-robots

Rapid Manufacturing of Thin Soft Pneumatic Actuators and Robots

This protocol describes a method for rapid manufacturing of soft pneumatic actuators and robots with an ultrathin form factor using a heat press and a ...

Weill Cornell Medicine

The primary mode of visualization during transcatheter procedures for structrural heart disease is fluoroscopy, which suffers from low contrast and lacks any depth perception, thus limiting the ability of an interventionalist to position a catheter accurately. This paper describes a new image guidance system by utilizing augmented reality to provide a 3D visual environment and quantitative feedback of the catheter's position within the heart of the patient. The real-time 3D position of the catheter is acquired via two fluoroscopic images taken at different angles, and a patient-specific 3D heart rendering is produced pre-operatively from a CT scan. The spine acts as a fiduciary land marker, allowing the position and orientation of the catheter within the heart to be fully registered. The automated registration method is based on Fourier transformation, and has a high success rate (100%), low registration error (0.42 mm), and clinically acceptable computational cost (1.22 second). The 3D renderings are displayed and updated on the augmented reality device (i.e., Microsoft HoloLens), which can provide pre-set views of various angles of the heart using voice-command. This new image-guidance system with augmented reality provides a better visualization to interventionalists and potentially assists them in understanding of complicated cases. Furthermore, this system coupled with the developed 3D printed models can serve as a training tool for the next generation of cardiac interventionalists.

An augmented reality system for image guidance of transcatheter procedures for structural heart disease.

Micropatterning is often used to engineer the surface properties of objects because it allows the enhancement or modification of specific functionalities without modification of the bulk material properties. Microneedle arrays have been explored in the past for drug delivery and enhancement of tissue anchoring; however, conventional methods are primarily limited to thick, planar substrates. Here, we demonstrate a method for the fabrication of microneedle arrays on thin flexible polyurethane substrates. These thin-film microneedle arrays can be used to fabricate balloons and other inflatable objects. In addition, these thin-filmed microneedles can be transferred, using thermal forming processes, to more complex 3D objects on which it would otherwise be difficult to directly pattern microneedles. This function is especially useful for medical devices, which require effective tissue anchorage but are a challenging target for micropatterning due to their 3D nonplanar shape, large size, and the complexity of the required micropatterns. Ultrathin flexible thermoplastic polyurethane microneedle arrays were fabricated from a polydimethylsiloxane (PDMS) mold. The technique was applied onto the nonplanar surface of rapidly prototyped soft robotic implantable polyurethane devices. We found that a microneedle-patterned surface can increase the anchorage of the device to a tissue by more than twofold. In summary, our soft lithographic patterning method can rapidly and inexpensively generate thin-film microneedle surfaces that can be used to produce balloons or enhance the properties of other 3D objects and devices.

Alexandre Caprio

Dalio Institute of Cardiovascular Imaging,
New York-Presbyterian Hospital,
Department of Radiology,
Dalio Institute of Cardiovascular Imaging, New York-Presbyterian Hospital

Weill Cornell Medicine

Rapid Manufacturing of Thin Soft Pneumatic Actuators and Robots

Alexandre Caprio

.css-o250i3{font-size:18px;font-family:Open Sans,sans-serif;line-height:21.6px;}Dalio Institute of Cardiovascular Imaging,New York-Presbyterian Hospital,Department of Radiology,Dalio Institute of Cardiovascular Imaging, New York-Presbyterian Hospital

Weill Cornell Medicine

Rapid Manufacturing of Thin Soft Pneumatic Actuators and Robots

Dalio Institute of Cardiovascular Imaging,
New York-Presbyterian Hospital,
Department of Radiology,
Dalio Institute of Cardiovascular Imaging, New York-Presbyterian Hospital