quantitative-31p-nmr-analysis-of-lignins-and-tannins

Quantitative <sup>31</sup>P NMR Analysis of Lignins and Tannins

The development of sustainable biorefinery products is confronted, among others, with the challenge of lignin and tannin valorization. These abundant, ...

Ca’ Foscari University of Venezia

A new fractionation protocol for wheat straw organosolv lignin was developed on the basis of the dominating H-bonding orientations of its components. Acetone as H-bond accepting aprotic polar solvent and methanol as H-bond donating and accepting protic polar solvent were used in sequence. Obtained fractions were structurally and thermally analysed. The protocol allowed for the generation of purified lignin fractions and the isolation of a novel, yet unobserved lignin carbohydrate complex (LCC) fraction. This LCC fraction was found to contain exclusively phenyl glycosides and γ-esters as LCC motifs.

Facile Isolation of LCC-Fraction from Organosolv Lignin by Simple Soxhlet Extraction.

The analysis of chemical structural characteristics of biorefinery product streams (such as lignin and tannin) has advanced substantially over the past decade, with traditional wet-chemical techniques being replaced or supplemented by NMR methodologies. Quantitative P NMR spectroscopy is a promising technique for the analysis of hydroxyl groups because of its unique characterization capability and broad potential applicability across the biorefinery research community. This protocol describes procedures for (i) the preparation/solubilization of lignin and tannin, (ii) the phosphitylation of their hydroxyl groups, (iii) NMR acquisition details, and (iv) the ensuing data analyses and means to precisely calculate the content of the different types of hydroxyl groups. Compared with traditional wet-chemical techniques, the technique of quantitative P NMR spectroscopy offers unique advantages in measuring hydroxyl groups in a single spectrum with high signal resolution. The method provides complete quantitative information about the hydroxyl groups with small amounts of sample (~30 mg) within a relatively short experimental time (~30-120 min).

Claudia Crestini

Department of Molecular Sciences and Nanosystems

Ca’ Foscari University of Venezia

Quantitative ³¹P NMR Analysis of Lignins and Tannins

Claudia Crestini

.css-o250i3{font-size:18px;font-family:Open Sans,sans-serif;line-height:21.6px;}Department of Molecular Sciences and Nanosystems

Ca’ Foscari University of Venezia

Quantitative 31P NMR Analysis of Lignins and Tannins

Department of Molecular Sciences and Nanosystems

Quantitative ³¹P NMR Analysis of Lignins and Tannins