fabrication-validation-an-organ-on-chip-system-with-integrated

Fabrication and Validation of an Organ-on-chip System with Integrated Electrodes to Directly Quantify Transendothelial Electrical Resistance

Organs-on-chips, in vitro models involving the culture of (human) tissues inside microfluidic devices, are rapidly emerging and promise to provide useful ...

University of Twente

This paper reports a novel design of a miniaturized three-electrode electrochemical cell, the purpose of which is aimed at generating drug metabolites with a high conversion efficiency. The working electrode and the counter electrode are placed in two separate channels to isolate the reaction products generated at both electrodes. The novel design includes connecting channels between these two electrode channels to provide a uniform distribution of the current density over the entire working electrode. In addition, the effect of ohmic drop is decreased. Moreover, two flow resistors are included to ensure an equal flow of analyte through both electrode channels. Total conversion of fast reacting ions is achieved at flow rates up to at least 8 μL/min, while the internal chip volume is only 175 nL. Using this electrochemical chip, the metabolism of mitoxantrone is studied by microchip electrospray ionization-mass spectrometry. At an oxidation potential of 700 mV, all known metabolites from direct oxidation are observed. The electrochemical chip performs equally well, compared to a commercially available cell, but at a 30-fold lower flow of reagents.

Improved conversion rates in drug screening applications using miniaturized electrochemical cells with frit channels.

Trans-epithelial electrical resistance (TEER) measurements are widely used as real-time, non-destructive, and label-free measurements of epithelial and endothelial barrier function. TEER measurements are ideal for characterizing tissue barrier function in organs-on-chip studies for drug testing and investigation of human disease models; however, published reports using this technique have reported highly conflicting results even with identical cell lines and experimental setups. The differences are even more dramatic when comparing measurements in conventional Transwell systems with those obtained in microfluidic systems. Our goal in this work was therefore to enhance the fidelity of TEER measurements in microfluidic organs-on-chips, specifically using direct current (DC) measurements of TEER, as this is the most widely used method reported in the literature. Here we present a mathematical model that accounts for differences measured in TEER between microfluidic chips and Transwell systems, which arise from differences in device geometry. The model is validated by comparing TEER measurements obtained in a microfluidic gut-on-a-chip device versus in a Transwell culture system. Moreover, we show that even small gaps in cell coverage (e.g., 0.4%) are sufficient to cause a significant (~80%) drop in TEER. Importantly, these findings demonstrate that TEER measurements obtained in microfluidic systems, such as organs-on-chips, require special consideration, specifically when results are to be compared with measurements obtained from Transwell systems.

Measuring direct current trans-epithelial electrical resistance in organ-on-a-chip microsystems.

The costs of drug development have been rising exponentially over the last six decades, making it essential to select drug candidates in the early drug discovery phases before proceeding to expensive clinical trials. Here, we present novel screening methods using an electrochemical chip coupled online to mass spectrometry (MS) or liquid chromatography (LC) and MS, to generate phase I and phase II drug metabolites and to demonstrate protein modification by reactive metabolites. The short transit time (∼4.5 s) between electrochemical oxidation and mass spectrometric detection, enabled by an integrated electrospray emitter, allows us to detect a short-lived radical metabolite of chlorpromazine which is too unstable to be detected using established test routines. In addition, a fast way to screen candidate drugs is established by recording real-time mass voltammograms, which allows one to identify the drug metabolites that are expected to be formed upon oxidation by applying a linear potential sweep and simultaneously detect oxidation products. Furthermore, detoxification of electrochemically generated reactive metabolites of paracetamol was mimicked by their adduct formation with the antioxidant glutathione. Finally, the potential toxicity of reactive metabolites can be investigated by the modification of proteins, which was demonstrated by modification of carbonic anhydrase I with electrochemically generated reactive metabolites of paracetamol. With this series of experiments, we demonstrate the potential of this electrochemical chip as a complementary tool for a variety of drug metabolism studies in the early stages of drug discovery.

Mass spectrometric detection of short-lived drug metabolites generated in an electrochemical microfluidic chip.

Desalination as a sample preparation step is essential for noise reduction and reproducibility of mass spectrometry measurements. A specific example is the analysis of proteins for medical research and clinical applications. Salts and buffers that are present in samples need to be removed before analysis to improve the signal-to-noise ratio. Capacitive deionization is an electrostatic desalination (CDI) technique which uses two porous electrodes facing each other to remove ions from a solution. Upon the application of a potential of 0.5 V ions migrate to the electrodes and are stored in the electrical double layer. In this article we demonstrate CDI on a chip, and desalinate a solution by the removal of 23% of Na(+) and Cl(-) ions, while the concentration of a larger molecule (FITC-dextran) remains unchanged. For the first time impedance spectroscopy is introduced to monitor the salt concentration in situ in real-time in between the two desalination electrodes.

Capacitive deionization on-chip as a method for microfluidic sample preparation.

An integrated surface-enhanced Raman scattering (SERS) spectroelectrochemical (SEC) analysis system is presented that combines a small volume microfluidic sample chamber (<100 μL) with a compact three-electrode configuration for in situ surface-enhanced Raman spectroelectrochemistry. The SEC system includes a nanostructured Au surface that serves dual roles as the electrochemical working electrode (WE) and SERS substrate, a microfabricated Pt counter electrode (CE), and an external Ag/AgCl reference electrode (RE). The nanostructured Au WE enables highly sensitive in situ SERS spectroscopy through large and reproducible SERS enhancements, which eliminates the need for resonant wavelength matching of the laser excitation source with the electronic absorption of the target molecule. The new SEC analysis system has the merits of wide applicability to target molecules, small sample volume, and a low detection limit. We demonstrate in situ SERS spectroelectrochemistry measurements of the metalloporphyrin hemin showing shifts of the iron oxidation marker band ν4 with the nanostructured Au working electrode under precise potential control.

In situ surface-enhanced Raman spectroelectrochemical analysis system with a hemin modified nanostructured gold surface.

Measuring transendothelial or transepithelial electrical resistance (TEER) is a widely used method to monitor cellular barrier tightness in organs-on-chips. Unfortunately, integrated electrodes close to the cellular barrier hamper visual inspection of the cells or require specialized cleanroom processes to fabricate see-through electrodes. Out-of-view electrodes inserted into the chip's outlets are influenced by the fluid-filled microchannels with relatively high resistance. In this case, small changes in temperature or medium composition strongly affect the apparent TEER. To solve this, we propose a simple and universally applicable method to directly determine the TEER in microfluidic organs-on-chips without the need for integrated electrodes close to the cellular barrier. Using four electrodes inserted into two channels - two on each side of the porous membrane - and six different measurement configurations we can directly derive the isolated TEER independent of channel properties. We show that this method removes large variation of non-biological origin in chips filled with culture medium. Furthermore, we demonstrate the use of our method by quantifying the TEER of a monolayer of human hCMEC/D3 cerebral endothelial cells, mimicking the blood-brain barrier inside our microfluidic organ-on-chip device. We found stable TEER values of 22 Ω cm(2)±1.3 Ω cm(2) (average ± standard error of the mean of 4 chips), comparable to other TEER values reported for hCMEC/D3 cells in well-established Transwell systems. In conclusion, we demonstrate a simple and robust way to directly determine TEER that is applicable to any organ-on-chip device with two channels separated by a membrane. This enables stable and easily applicable TEER measurements without the need for specialized cleanroom processes and with visibility on the measured cell layer.

Direct quantification of transendothelial electrical resistance in organs-on-chips.

Specific electrochemical cleavage of peptide bonds at the C-terminal side of tyrosine and tryptophan generates peptides amenable to liquid chromatography-tandem mass spectrometry (LC-MS/MS) analysis for protein identification. To this end we developed a microfluidic electrochemical cell of 160 nL volume that combines a cell geometry optimized for a high electrochemical conversion efficiency (>95%) with an integrated boron doped diamond (BDD) working electrode offering a wide potential window in aqueous solution and reduced adsorption of peptides and proteins. Efficient cleavage of the proteins bovine insulin and chicken egg white lysozyme was observed at 4 out of 4 and 7 out of 9 of the predicted cleavage sites, respectively. Chicken egg white lysozyme was identified based on 5 electrochemically generated peptides using a proteomics database searching algorithm. These results show that electrochemical peptide bond cleavage in a microfluidic cell is a novel, fully instrumental approach toward protein analysis and eventually proteomics studies in conjunction with mass spectrometry.

Electrochemical Protein Cleavage in a Microfluidic Cell with Integrated Boron Doped Diamond Electrodes.

Reactive xenobiotic metabolites and their adduct formation with biomolecules such as proteins are important to study as they can be detrimental to human health. Here, we present a microfluidic electrochemical cell with integrated micromixer to study phase I and phase II metabolism as well as protein adduct formation of xenobiotics in a purely instrumental approach. The newly developed microfluidic device enables both the generation of reactive metabolites through electrochemical oxidation and subsequent adduct formation with biomolecules in a chemical microreactor. This allows us to study the detoxification of reactive species with glutathione and to predict potential toxicity of xenobiotics as a result of protein modification. Efficient mixing in microfluidic systems is a slow process due to the typically laminar flow conditions in shallow channels. Therefore, a passive gradient rotation micromixer has been designed that is capable of mixing liquids efficiently in a 790 pL volume within tens of milliseconds. The mixing principle relies on turning the concentration gradient that is initially established by bringing together two streams of liquid, to take advantage of the short diffusion distances in the shallow microchannels of thin-layer flow cells. The mixer is located immediately downstream of the working electrode of an electrochemical cell with integrated boron doped diamond electrodes. In conjunction with mass spectrometry, the two microreactors integrated in a single device provide a powerful tool to study the metabolism and toxicity of xenobiotics, which was demonstrated by the investigation of the model compound 1-hydroxypyrene.

Oxidation and adduct formation of xenobiotics in a microfluidic electrochemical cell with boron doped diamond electrodes and an integrated passive gradient rotation mixer.

Electrochemistry on graphene is of particular interest due to graphene's high surface area, high electrical conductivity and low interfacial capacitance. Because the graphene Fermi level can be probed by its strong Raman signal, information on the graphene doping can be obtained which in turn can provide information on adsorbed atoms or molecules. For this paper, the adsorption analysis was successfully performed using three electroactive substances with different electrode interaction mechanisms: hexaammineruthenium(III) chloride (RuHex), ferrocenemethanol (FcMeOH) and potassium ferricyanide/potassium ferrocyanide (Fe(CN)6). The adsorption state was probed by analysing the G-peak position in the measured in-situ Raman spectrum during electrochemical experiments. We conclude that electrochemical Raman spectroscopy on graphene is a valuable tool to obtain in-situ information on adsorbed species on graphene, isolated from the rest of the electrochemical behaviour.

Mathieu Odijk

University of Twente

Fabrication and Validation of an Organ-on-chip System with Integrated Electrodes to Directly Quantify Transendothelial Electrical Resistance