preparing microscope slide with fully-grown amyloid spherulite

Caractérisation des sphérolulites, à l’aide de la microscopie à deux photons sensible à la polarisation

Over the past decades, although there has been significant development of numerous fluorescence microscopy techniques for bioimaging of proteins and their aggregates1, only a few have been used to resolve their local ordering within the sample2,3. Fluorescence lifetime imaging microscopy4 was used to study the intrinsic structural heterogeneity of amyloid superstructures-spherulites. Moreover, quantitative determination of the local ordering inside complex and densely-packed biostructures such as spherulites could be resolved using polarization-sensitive methods3. However, standard fluorescence techniques with superficial tissue penetration are limited since using UV-VIS wavelengths to excite fluorophores in vivo leads to high tissue light scattering5. In addition, such imaging often requires designing and binding specific fluorescent probes to a targeted biomolecule, thereby increasing the cost and amount of work needed to perform imaging.
Recently, to address these issues, our team has adapted polarization-sensitive two-photon excited fluorescence microscopy (ps-2PFM) for label-free imaging of biological structures6,7. Ps-2PFM allows for the measurement of the dependence of two-photon fluorescence intensity on the direction of linear polarization of the excitation beam and analysis of the polarization of the emitted fluorescence8. The implementation of this technique requires supplementation of the standard multi-photon microscope setup excitation path (Figure 1) with a half-wave plate to control the light polarization plane. Then, polar graphs, depicting the dependence of two-photon excited fluorescence intensity on the polarization of the excitation laser beam, are created from signals collected by two avalanche photodiodes, thus collecting the two, mutually perpendicular components of fluorescence polarization.
The last step is the data analysis process, taking into account the impact of the optical elements, such as dichroic mirrors or a high numerical aperture objective, on polarization. Because of the nature of the two-photon process, this method provides both reduced angular photo-selection and enhanced axial resolution, as two-photon excitation of fluorophores outside the focal plane is probabilistically limited. It was also proven that similar methods could be successfully implemented for in vivo imaging of near-infrared probes (NIR) for deep-tissue imaging9. Ps-2PFM has been previously applied to image fluorophores in cell membranes10 and DNA11,12, as well as non-standard fluorescent markers of biological systems, such as gold nanoparticles13. However, in all these examples, the information about the organization of biomolecules was obtained indirectly and required a predefined mutual orientation between a fluorophore and a biomolecule.
In one of our recent papers, we have shown that ps-2PFM could be successfully applied for determining the local polarization of the autofluorescence of amyloid superstructures and fluorescence from Thioflavin T, an amyloid-specific dye, bound to amyloid fibrils in spherulites6. Furthermore, in another one, we have proven that ps-2PFM could be utilized to detect amyloid fibril orientation inside amyloid spherulites in a sub-micron size regime, which was confirmed by correlating it with transmission electron microscopy (TEM) imaging7. The achievement of this outcome was possible thanks to i) intrinsic autofluorescence of spherulites-amyloids, when excited with either one or two photons, exhibit intrinsic autofluorescence with emission maxima located in a range from 450 to 500 nm and two-photon absorption cross sections comparable with standard fluorescent dyes14, ii) mathematical models introduced previously to describe how ps-2PEF of dyes labeling biological membranes and DNA structures could be applied to fluorescence exhibited by spherulites and dyes bound to them8,11,15. Thus, before proceeding with the analysis, we highly recommend looking through the required theory described in both, the main text and supporting information of our first paper concerning this topic6. Here, we present the protocol for how to apply the ps-2PFM technique for a label-free amyloid structural characterization of bovine insulin spherulites.

Pleins feux sur l’auteur : Imagerie non invasive de biostructures complexes à l’aide de la microscopie à deux photons sensible à la polarisation 

Microscopie à deux photons sensible à la polarisation pour une caractérisation de la structure amyloïde sans marquage

Our goal is to develop new optical markers and techniques for the detection of protein aggregates called amyloids. They are involved in a range of diseases such as Alzheimer's disease and type two diabetes. So in order to cure these diseases, we need to have techniques to visualize amyloids.We demonstrated that two-photon microscopy can be used to detect amyloid fibril orientation inside amyloid superstructures. It can be achieved not only using amyloid-specific dyes, but also by utilizing the autofluorescence of amyloids. Since our technique operates on nonlinear optical phenomena, it can achieve reduced angular photoselection, enhance axial resolution, lower light scattering, lower phototoxicity, and deeper sample penetration when compared to the one-photon fluorescence microscopic technique.Polarization-sensitive two-photon fluorescence microscopy is a promising tool to image internal structure of various complex biological structures, not only protein aggregates, but also DNA vesicles and lipid membranes.

Watch this Scientific Journal Video about Preparing Microscope Slide with Fully-Grown Amyloid Spherulite at JoVE.com

Preparing Microscope Slide with Fully-Grown Amyloid Spherulite  

Préparation d’une lame de microscope avec de la sphérulite amyloïde adulte

Pour commencer, lavez soigneusement la lame de verre du microscope avec de l’eau. Ensuite, après avoir trempé les lames dans du méthanol, laissez-les sécher dans des conditions ambiantes sur une lingette sans poussière. Ensuite, à l’aide d’une pipette automatique, transférez 100 microlitres de la solution de sphérulite d’insuline dans le puits situé dans la zone centrale de la lame de microscope.Couvrez soigneusement la solution avec une lamelle, en évitant la formation de bulles d’air. Ensuite, à l’aide d’une pipette automatique, déposez le produit de montage le long des bords de la lamelle de recouvrement sur la lame pour sceller la solution de sphérulite native. Laissez l’échantillon dans des conditions ambiantes pour que le produit de montage durcisse.À l’aide d’un microscope optique polarisé avec des polariseurs croisés, vérifiez si les sphérulites d’insuline se sont formées correctement. Parcourez l’échantillon, à la recherche d’un motif caractéristique de zones lumineuses, connu sous le nom de croix de Malte. La microscopie optique polarisée a révélé la présence de la croix de Malte dans les sphérulites.

preparing-microscope-slide-with-fully-grown-amyloid-spherulite

Research

JoVE Journal

Chemistry

Preparing Microscope Slide with Fully-Grown Amyloid Spherulite

130 vues.  Wrocław University of Science and Technology. Pour commencer, lavez soigneusement la lame de verre du microscope avec de l’eau. Ensuite, après avoir trempé les lames dans du méthanol, laissez-les sécher dans des conditions ambiantes sur une lingette sans poussière. Ensuite, à l’aide d’une pipette automatique, transférez 100 microlitres de la solution de sphérulite d’insuline dans le puits situé dans la zone centrale de la lame de microscope.Couvrez soigneusement la solution avec une lamelle, en évitant la formati...

Vidéo: Preparing Microscope Slide with Fully-Grown Amyloid Spherulite  

Polarization-Sensitive Two-Photon Microscopy for a Label-Free Amyloid Structural Characterization

Compared to its one-photon counterpart, two-photon excitation is beneficial for bioimaging experiments because of its lower phototoxicity, deeper tissue penetration, efficient operation in densely packed systems, and reduced angular photoselection of fluorophores. Thus, the introduction of polarization analysis in two-photon fluorescence microscopy (2PFM) provides a more precise determination of molecular organization in a sample compared to standard imaging methods based on linear optical processes. In this work, we focus on polarization-sensitive 2PFM (ps-2PFM) and its application in the determination of molecular ordering within complex bio-structures-amyloid spherulites. Neurodegenerative diseases such as Alzheimer's or Parkinson's are often diagnosed through the detection of amyloids-protein aggregates formed due to an impaired protein misfolding process. Exploring their structure leads to a better understanding of their creation pathway and consequently, to developing more sensitive diagnostic methods. This paper presents the ps-2PFM adapted for the determination of local fibril ordering inside the bovine insulin spherulites and spherical amyloidogenic protein aggregates. Moreover, we prove that the proposed technique can resolve the three-dimensional organization of fibrils inside the spherulite.

This paper describes how polarization-sensitive two-photon microscopy could be applied to characterize the local organization within label-free amyloid superstructures-spherulites. It also describes how to prepare and measure the sample, assemble the required setup, and analyze the data to obtain information about the local organization of amyloid fibrils.

Compared to its one-photon counterpart, two-photon excitation is beneficial for bioimaging experiments because of its lower phototoxicity, deeper tissue ...

Recherche

Chimie

To begin, thoroughly wash the microscope glass slide with water. Then, after dipping the slides in methanol, allow them to dry under ambient conditions on a dust-free wipe. Next, using an automatic pipette, transfer 100 microliters of the insulin spherulite solution to the well in the center area of the microscope slide.Carefully cover the solution with a cover slip, avoiding air bubble formation. Then, using an automatic pipette, deposit the mountant along the edges of the cover slip on the slide to seal the native spherulite solution. Leave the sample under ambient conditions for the mountant to harden.Using a polarized optical microscope with crossed polarizers, confirm if insulin spherulites have formed correctly. Scan through the sample, looking for a characteristic pattern of bright areas, known as a Maltese cross. The polarized optical microscopy revealed the presence of the Maltese cross in the spherulites.

Polarization-Sensitive Two-Photon Fluorescence Microcopy of Bovine Insulin Spherulites

After building and aligning the polarization-sensitive two-photon microscope system, according to the displayed schematic representation, test the optics alignment quality with an isotropic reference sample like fluorescein embodied in an amorphous polymer. To do so, switch on the excitation laser and measure the 360 degree polar graphs of the reference sample for a zero half-wave plate. Adjust the half-wave plate angle to correspond to the X and Y axes of the sample plane, and check if both photodiodes collect similar intensities of two photon-excited emission components.To analyze the sample, mount the glass slide with this spherulite specimen on the Piezoelectric Stage, ensuring the face of the slide containing the cover slip faces the high numerical aperture immersion objective. Then secure the glass slide with tape. Next, by adjusting the X, Y, and Z positions using the microscope knobs, focus the objective on the spherulite in the solution.Focus specifically on the central area of the entire structure, as spherulite diameters are usually in the range of tens of microns. Then center this spherulite in the field of view in the microscope plane. Determine the size of the XY scan by adjusting the number of Piezo Stage steps in X and Y directions to cover the entire structure's area.Adjust the Piezo Stage parameters such as scanning speed, step size, and range to cover the area of the whole spherulite. Open the shutter, turn on the photodiodes, and collect the X and Y emission components of two-photon excited fluorescence intensity for every single step of the selected scanning area for the excitation beam polarized corresponding to the X and then the Y axes. Then scan this spherulite sample, resulting in two-photon excited fluorescence.To perform full polarization analysis from the specific spot on the sample, turn off the excitation beam. Take specific coordinates of Piezo Stage corresponding to the chosen location on this spherulite where the information about the orientation of molecules is required with the submicron resolution. Adjust the Piezoelectric Stage to center the field of view at indicated X and Y coordinates.After turning on the excitation beam, turn on the 180 degree rotation of the half-wave plate to perform a full 360 degree polarization analysis of the X and Y emission components of the two-photon excited fluorescence emission. The image of the insulin spherulite obtained after performing a 2PFM raster scan was consistent with those reported for a spherulite. The position of the half-wave plate corresponding to the excitation of the sample along the X and Y axes was also verified.The polar graphs changed while performing a full polarization analysis from different selected spots. Outside the spherulite, the PLO graph looked like a collection of artifacts and random signal noise spikes. Properly measured polygraphs from highly ordered locations along the X and Y axes had different shapes and geometries depending on the local orientation and organization of fluorophores.