Surveillance actine démontage Time-lapse microscopie

Okay, so what I'd like to do today is to show you how to construct a flow chamber, a fusion chamber for imaging on an upright microscope. What then I then do is I create two spaces using film. So what I do is I take the para film, I cut it into small strips.

Next I'm going to, this will basically form the channels for the, the walls, and I dry them with a tilted air. I put the cover slip on top of the para, And here's the finished. Then I heat it on a heat block to melt the param and basically create a seal.

So what this is, is the, the cover glass here, and then on top of the cover glass is two layers of phim as you see right here. And then on top of this, again, there's a, it's a 22 by two two mil meter cover slip. This one right here, which I pressed against the param to fall the seal.

Okay, so the liquid goes in in one direction here and I can suck it out with a filter paper here in this direction. And I'll show you how to do that in a bit. So what I like to do is I like to put it in a humidified chamber, which is very simple.

Take two kind of elevated strips and have a filter of paper underneath. And to keep it noisy as I, I put the cover, cover slip on the flow chamber on. Now the way you introduce a solution to the chamber is that you just put the pipet tip at the entrance of the chamber and you just split.

Now what I do is I incubate the chamber with the lid closed for 10 minutes. What I usually do to suck the liquid out from the other side is to use it, get a filter paper and cut it into thin strips like this. And I take one of these thin strips and I simultaneously apply the solution into the entrance while putting the filter paper at the exit to suck the exchange, the solution.

So you'll see the liquid flowing through the solution. And then I wait for five minutes for the mid close. Now what I'm ready to do is to actually put that the actin it and the actin, I actually have to polymerize, I polymerize inside the flow chamber and it's just the same procedures before.

So because like this, and then now that the action is polymerized, I wash out all the un excess un polymerized action using a large volume of just buffer. So here I have about a hundred microliters and it's a few reaction chamber volumes worth of buffer. Just, you know, when the filter paper becomes saturated, I have to change the direction.Okay?

And so I'm ready to do imaging with this. So perfusion chamber with actin attached to it. Now I take the slide, mount it under the microscope, and since I'm imaging with an oil objective, I'm gonna put some immersion oil on the top surface of the cover, grass touch, such so assess solution or protein or anything on acting inside.

So what I do is I can actually exchange the solution side while I'm doing the time lapse imaging. As such.