large-scale-automated-production-adipose-derived-stem-cell-spheroids

Large-Scale, Automated Production of Adipose-Derived Stem Cell Spheroids for 3D Bioprinting

Adipose-derived stromal/stem cells (ASCs) are a subpopulation of cells found in the stromal vascular fraction of human subcutaneous adipose tissue ...

Federal University of Rio de Janeiro

National Institute of Metrology, Quality and Technology (Inmetro)

Unigranrio

Since initial methods were developed for isolating cells from adipose tissue, little has been done to improve mesenchymal stromal cell (MSC) yield. The aim of the present study was to isolate a population of MSC from lipoaspirate samples without tissue digestion and to assess the possibility of cryopreserving the freshly isolated cells.

An alternative method for the isolation of mesenchymal stromal cells derived from lipoaspirate samples.

The objective of our study was to investigate chondrogenesis potential of human adipose-derived mesenchymal stromal cells (MSCs), using as a positive control a human source of cartilage-derived progenitor cells (PCs). This source of PCs was recently described by our group and dwells on the surface of nasoseptal cartilage. Histological analysis using Safranin O staining and immunofluorescence for actin filaments and collagen type II was performed on three-dimensional (3D) pellet cultures. Cartilage PCs and adipose MSCs showed similarities in monolayer culture related to cell morphology and proliferation. Our 3D pellet cultures substantially reduced the actin stress and after 21 days under chondrogenic medium, we observed an increase in the pellet diameter for cartilage PCs (7.4%) and adipose MSCs (21.2%). Adipose-derived MSCs responded to chondrogenic stimulus, as seen by positive areas for collagen type II, but they were not able to recreate a mature extracellular matrix. Using semi-quantitative analysis, we observed a majority of Safranin O areas rising from blue (no stain) to orange (moderate staining) and no changes in fibroblastic morphology (P < 0.0001). For cartilage PCs, chondrogenic induction is responsible for morphological changes and a high percentage of matrix area/number of cells (P ≤ 0.0001), evaluated by computerized histomorphometry. Morphological analyses reveal that adipose-derived MSCs were not able to recreate a bioengineered cartilage. The cost of culture was reduced, as the cartilage PCs under growth-factor free medium exhibit a high score for cartilage formation compared with the induced adipose mesenchymal stromal cells (P = 0.0021). Using a pellet 3D culture, our cartilage PCs were able to produce a cartilage tissue in vitro, leading to the future development of bioengineered products.

Bioengineered cartilage in a scaffold-free method by human cartilage-derived progenitor cells: a comparison with human adipose-derived mesenchymal stromal cells.

Subcutaneous adipose tissue is an interesting source of autologous stem cells with a fundamental role in the pathophysiology of obesity, metabolic syndromes and insulin resistance. We hypothesize that obesity could alter the stromal-vascular fraction (SVF) and adipose stem cell (ASCs) functions, which could compromise its regenerative behavior. Furthermore, we aimed to evaluate whether ASCs derived from post bariatric surgery ex-obese women maintain their functions in a similar fashion as do those from individuals who have never been obese.

Stromal-vascular fraction content and adipose stem cell behavior are altered in morbid obese and post bariatric surgery ex-obese women.

Adipose stem cells (ASCs) spheroids show enhanced regenerative effects compared to single cells. Also, spheroids have been recently introduced as building blocks in directed self-assembly strategy. Recent efforts aim to improve long-term cell retention and integration by the use of microencapsulation delivery systems that can rapidly integrate in the implantation site. Interlockable solid synthetic microscaffolds, so called lockyballs, were recently designed with hooks and loops to enhance cell retention and integration at the implantation site as well as to support spheroids aggregation after transplantation. Here we present an efficient methodology for human ASCs spheroids biofabrication and lockyballs cellularization using micro-molded non-adhesive agarose hydrogel. Lockyballs were produced using two-photon polymerization with an estimated mechanical strength. The Young's modulus was calculated at level 0.1362 +/-0.009 MPa. Interlocking in vitro test demonstrates high level of loading induced interlockability of fabricated lockyballs. Diameter measurements and elongation coefficient calculation revealed that human ASCs spheroids biofabricated in resections of micro-molded non-adhesive hydrogel had a more regular size distribution and shape than spheroids biofabricated in hanging drops. Cellularization of lockyballs using human ASCs spheroids did not alter the level of cells viability (p › 0,999) and gene fold expression for SOX-9 and RUNX2 (p › 0,195). The biofabrication of ASCs spheroids into lockyballs represents an innovative strategy in regenerative medicine, which combines solid scaffold-based and directed self-assembly approaches, fostering opportunities for rapid in situ biofabrication of 3D building-blocks.

Delivery of Human Adipose Stem Cells Spheroids into Lockyballs.

Stem cell tissue constructs are likely to come into contact with silver-based nanoparticles-such as silver chloride nanoparticles (AgCl-NPs)-used as microbicidals at the implant site or in cosmetics. However, the effect of silver-based nanoparticles on 3D cell cultures with potential for tissue engineering has received little attention. Here, we examined the effect of sub-lethal doses (5, 10 and 25 µg/mL, for 1, 7 and 21 days) of AgCl-NPs produced by 'green' bacterial-based synthesis on spheroid 3D cultures of human adipose tissue stem cells (ASCs). Light microscopy analysis revealed that the shape and diameter of ASC spheroids remained largely unchanged after AgCl-NP treatment. Flow cytometry analysis with 7-AAD and 2',7'-dichlorofluorescein diacetate revealed no statistically significant differences in cell death but showed an increase of ROS levels for the untreated group and significant differences for the groups treated with 5 and 10 µg/mL at day 7 (p = 0.0395, p = 0.0266, respectively). Electron microscopy analysis showed limited cell damage in the periphery of AgCl-NP-treated spheroids. However, treatment with AgCl-NP had statistically significant effects on the secretion of IL-6, IL-8, IL-1β and IL-10 by spheroids, at specific treatment periods and concentrations, and particularly for IL-6, IL-8 and IL-1β. TGF-β1 and -β2 secretion also changed significantly throughout the treatment period. Our results indicate that, despite having little effect on cell viability and morphology, sub-lethal AgCL-NP doses modulate ROS production at day 7 for the groups treated with 5 and 10 µg/mL and also modulate the secretory profile of ASC spheroids. Thus, the use of skin implants or products containing Ag-NPs may promote long-term disturbances in subcutaneous adipose tissue homeostasis.

Biologically produced silver chloride nanoparticles from B. megaterium modulate interleukin secretion by human adipose stem cell spheroids.

There are currently three in vitro methods adopted by the Organization for the Economic Co-operation and Development for testing chemicals based on the third key event of the skin sensitization adverse outcome pathway, the activation of dendritic cells. All of them use culture medium supplemented with fetal bovine serum (FBS), which brings technical disadvantages and animal welfare concerns. The objective of this study was to analyze the possibility of eliminating the use of FBS in the human Cell Line Activation Test (h-CLAT). After successful implementation of the h-CLAT using THP-1 cells cultured in FBS-containing medium, several attempts to adapt THP-1 cells to four different serum-free media were made. The best results were obtained with gradual adaptation to RPMI-1640 medium with HL-1™ Supplement and to X-VIVO™ 10. Adapted cells were cryopreserved and submitted to the reactivity check. After being approved, they were used in dose finding and proficiency assays. Despite minor adjustments in the original protocol, it was possible to correctly predict the sensitizing potential of the ten proficiency substances using THP-1 cells adapted to X-VIVO™ 10, which indicates that it is possible to eliminate the use of FBS in the h-CLAT, using a chemically defined medium.

Adaptation of a skin sensitization assay to a chemically defined culture.

A stabilized cartilage construct without signs of hypertrophy in chondrocytes is still a challenge. Suspensions of adipose stem/stromal cells (ASCs) and cartilage progenitor cells (CPCs) were seeded into micromolded nonadhesive hydrogel to produce spheroids (scaffold- and serum-free method) characterized by size, immunohistochemistry, fusion, and biomechanical properties. After cell dissociation, they were characterized for mesenchymal cell surface markers, cell viability, and quantitative real-time polymerase chain reaction. Both targeted and nontargeted (shotgun mass spectrometry) analyses were conducted on the culture supernatants. Induced ASC spheroids (ø = 350 μm) showed high cell viability and CD73 downregulation contrasting to CD90. The transforming growth factor (TGF)-β3/TGF-β1 ratio and  increased ( < 0.05), whereas interleukin (IL)-6, IL-8, , and  decreased. Induced ASC spheroids were able to completely fuse and showed a higher force required to compression at day 14 ( < 0.0001). Strong collagen type II  was associated with gradual decrease of collagen type X and a lower  gene expression at day 14 compared with day 7 ( = 0.0352). The comparison of the secretome content of induced and non-induced ASCs and CPCs identified 138 proteins directly relevant to chondrogenesis of 704 proteins in total. Although collagen X was absent, thrombospondin-1 (TSP-1), described as antiangiogenic and antihypertrophic, and cartilage oligomeric matrix protein (COMP), a biomarker of chondrogenesis, were upregulated in induced ASC spheroids. Our scaffold- and serum-free method mimics stable cartilage acting as a tool for biomarker discovery and for regenerative medicine protocols. Impact Statement Promising adult stem cell sources for cartilage regeneration include adipose stem/stromal cells (ASCs) from subcutaneous adipose tissue. Our main objective was the development of a reproducible and easy-to-handle scaffold- and serum-free method to obtain stable cartilage from induced ASC spheroids. In addition to targeted protein profiling and biomechanical analysis, we provide the first characterization of the secretome composition for ASC spheroids, providing a useful tool to monitor  chondrogenesis and a noninvasive quality control of tissue-engineered constructs. Furthermore, our secretome analysis revealed a potential novel biomarker-thrombospondin-1 (TSP-1), known by its antiangiogenic properties and recently described as an antihypertrophic protein.

A Scaffold- and Serum-Free Method to Mimic Human Stable Cartilage Validated by Secretome.

The new coronavirus (2019-nCoV) or the severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) was officially declared by the World Health Organization (WHO) as a pandemic in March 2020. To date, there are no specific antiviral drugs proven to be effective in treating SARS-CoV-2, requiring joint efforts from different research fronts to discover the best route of treatment. The first decisions in drug discovery are based on 2D cell culture using high-throughput screening. In this context, spheroids and organoids emerge as a reliable alternative. Both are scaffold-free 3D engineered constructs that recapitulate key cellular and molecular events of tissue physiology. Different studies have already shown their advantages as a model for different infectious diseases, including SARS-CoV-2 and for drug screening. The use of these 3D engineered tissues as an in vitro model can fill the gap between 2D cell culture and in vivo preclinical assays (animal models) as they could recapitulate the entire viral life cycle. The main objective of this review is to understand spheroid and organoid biology, highlighting their advantages and disadvantages, and how these scaffold-free engineered tissues can contribute to a better comprehension of viral infection by SARS-CoV-2 and to the development of in vitro high-throughput models for drug screening.

Spheroids and organoids as humanized 3D scaffold-free engineered tissues for SARS-CoV-2 viral infection and drug screening.

Cancer is considered one of the most predominant diseases in the world and one of the principal causes of mortality per year. The cellular and molecular mechanisms involved in the development and establishment of solid tumors can be defined as tumorigenesis. Recent technological advances in the 3D cell culture field have enabled the recapitulation of tumorigenesis , including the complexity of stromal microenvironment. The establishment of these 3D solid tumor models has a crucial role in personalized medicine and drug discovery. Recently, spheroids and organoids are being largely explored as 3D solid tumor models for recreating tumorigenesis . In spheroids, the solid tumor can be recreated from cancer cells, cancer stem cells, stromal and immune cell lineages. Organoids must be derived from tumor biopsies, including cancer and cancer stem cells. Both models are considered as a suitable model for drug assessment and high-throughput screening. The main advantages of 3D bioprinting are its ability to engineer complex and controllable 3D tissue models in a higher resolution. Although 3D bioprinting represents a promising technology, main challenges need to be addressed to improve the results in cancer research. The aim of this review is to explore (1) the principal cell components and extracellular matrix composition of solid tumor microenvironment; (2) the recapitulation of tumorigenesis  using spheroids and organoids as 3D culture models; and (3) the opportunities, challenges, and applications of 3D bioprinting in this area.

Leandra S. Baptista

Nucleus of Multidisciplinary Research in Biology (Numpex-Bio)

Federal University of Rio de Janeiro

Large-Scale, Automated Production of Adipose-Derived Stem Cell Spheroids for 3D Bioprinting

Leandra S. Baptista

.css-o250i3{font-size:18px;font-family:Open Sans,sans-serif;line-height:21.6px;}Nucleus of Multidisciplinary Research in Biology (Numpex-Bio)

Federal University of Rio de Janeiro

Large-Scale, Automated Production of Adipose-Derived Stem Cell Spheroids for 3D Bioprinting

Nucleus of Multidisciplinary Research in Biology (Numpex-Bio)