Morpholino Injection: A Method to Knockdown Target Gene Expression to Study Function in Zebrafish

Protocol

1. Morpholino Injection

1. The day prior to injecting the morpholino, make an injection plate (Figure 1). Make sure to cut out a notch at one end of the well, which helps stabilize the fish for the microinjection procedure.
2. Dilute the fluorescein-tagged morpholino to the proper concentration (recommend starting with 1.2 mM) and place in a 65 °C water bath, for 5 minutes.
3. Load the needle with the morpholino (note: depending on whether you back-fill or front-load your needle will determine whether you load the needle first, or cut the tip first).
4. Cut the tip off the needle at an angle.
5. Follow the directions of your micro-injection system to inject an approximately 5 nl bubble of morpholino per injection. Larger volumes of morpholino could disrupt the tissue.
6. Anesthetize the fish and place on injection plate. Remove all excess liquid and orient the needle to the appropriate location, just distal to the bony ray (Figure 2). Using a microscope and microinjection apparatus appropriate for morpholino injections (see Table of Specific Reagents), inject the morpholino into the fin from anterior to posterior, as shown in Figure 2. Injecting from posterior to anterior causes the fin tissue to roll up during the injection and is very difficult.
7. Insert the needle gently into the regenerative tissue, just distal to each bony ray (marked "1" in Figure 2) and push distally until located in the blastema (marked "2" in Figure 2). Be careful not to push the needle through the entire fin. When the needle is correctly localized, inject the morpholino (i.e. click one time). At 1.2 mM, the fluorescein-tagged morpholino solution appears yellow-green, even in normal light conditions. With each injection, a yellow "puff" of morpholino solution can be visualized, which helps localize the injection to the blastema. Approximately 75 nl (10-15 clicks) of morpholino solution should be injected per bony ray. Pause ~ 1 sec between clicks. We only inject the dorsal side, using the ventral as electroporation-only control.

Results

Figure 1. A. Schematic of the injection plate, which is made from agarose and contains a small well to hold the fish during microinjection of the morpholino.

Figure 2. Schematic of morpholino microinjection. A. Place the fish in the dish with the he...

Materials

Name	Company	Catalog Number	Comments
Morpholino	GeneTools, LLC		Morpholino should be custom designed to your protein of interest
Micro-injection pump	World Precision Instruments, Inc.	PV830	Pneumatic PicoPump Many different microinjection systems could be used
Micro-manipulator	World Precision Instruments, Inc.	MMJR	Right-handed (MMJL for lefthanded)
Micro-injection needles, 1.0 mm outside diameter	World Precision Instruments, Inc.	1B100F-4	These are borosilicate glass capillaries, pulled into a needle
Needle holder	World Precision Instruments, Inc.	5430-ALL	Pico Nozzle Kit; make sure to inset the 1.0 mm pipette gasket
Needle puller	Sutter Instrument Co.	P-97	Other micropipette/needle pullers should also work
Microscope	Leica, Nikon, Zeiss	Number varies depending on the manufacturer	Any stereomicroscope with 20X optics and the ability to work with micromanipulators
2-Phenoxyethanol	Sigma-Aldrich	77861-1L	Anesthesia; dilute 1:1000 in fish system water for procedure, 1:500 for euthanasia