non-invasive-assay-for-chlorophyll-biosynthesis-kinetics

Non-invasive Assay for Chlorophyll Biosynthesis Kinetics Determination during Early Stages of <em>Arabidopsis</em> De-etiolation

Chlorophyll biosynthesis is a hallmark of de-etiolation, one of the most dramatic stages in the plant life cycle. The tightly controlled and highly ...

Prumyslova

An advanced optical biosensor was developed based on the enzymatic reaction with halogenated aliphatic hydrocarbons that is accompanied by the fluorescence change of pH indicator. The device is applicable for the detection of halogenated contaminants in water samples with pH ranging from 4 to 10 and temperature ranging from 5 to 60°C. Main advantages of the developed biosensor are small size (60×30×190mm(3)) and portability, which together with short measurement time of 1min belong to crucial attributes of analytical technique useful for routine environmental monitoring. The biosensor was successfully applied for the detection of several important halogenated pollutants under laboratory conditions, e.g., 1,2-dichloroethane, 1,2,3-trichloropropane and γ-hexachlorocyclohexane, with the limits of detection of 2.7, 1.4 and 12.1mgL(-1), respectively. The continuous monitoring was demonstrated by repetitive injection of halogenated compound into measurement solution. Consequently, field trials under environmental settings were performed. The presence of 1,2-dichloroethane (10mgL(-1)) was proved unambiguously on one of three potentially contaminated sites in Czech Republic, and the same contaminant was monitored on contaminated locality in Serbia. Equipped by Global Positioning System, the biosensor was used for creation of a precise map of contamination. Concentrations determined by biosensor and by gas chromatograph coupled with mass spectrometer exhibited the correlation coefficient of 0.92, providing a good confidence for the routine use of the biosensor system in both field screening and monitoring.

Fluorescence-based biosensor for monitoring of environmental pollutants: From concept to field application.

This study focused on the antifouling effect of copper oxide (CuO)- and zineb-based coatings against  sp.  by analysing photosynthetic activity using chlorophyll fluorescence. The photoautotrophically grown cyanobacterium was exposed to toxic coatings over a short-term period of 32 h. The study showed that  cultures are particularly sensitive to biocides (i) released from antifouling paints and (ii) exhibited by contact with the coated surfaces. Changes in the maximum quantum yield of photosystem II (F/F) were observed within the first 12 h of exposure to the coatings. Partial recovery of F/F in  was revealed 24 h post exposure to a copper- and zineb-free coating. In this research, we proposed an analysis of the evaluation of fluorescence data to study the initial response of cyanobacterial cells to copper- and non-copper-based antifouling coatings formulated with zineb. We evaluated the dynamics of coating toxicity by determining the characteristic time constants of changes in the F/F. Within the most toxic paints studied, those formulated with the highest concentration of CuO and zineb, the estimated time constants were 3.9 times lower compared to the copper- and zineb-free paint. The use of zineb in copper-based antifouling coatings enhanced the toxic effect of paints and contributed to a faster decline in photosystem II activity in  cells. The analysis we proposed, along with the fluorescence screening results, may be useful in evaluating the initial antifouling dynamic action against photosynthetic aquacultures.

Fluorescence Analysis of Biocide Efficiency in Antifouling Coatings against Cyanobacteria.

In this work, an online sampling of plant xylem sap combined with an efficient (CE)-based method was developed and applied to study the kinetics of changes in the sap composition and to assess plant fitness under stress conditions comprehensively. A laboratory-built CE device was developed to provide online sampling and CE analysis of various ionogenic species in the sap during plant stress response. The rapid online sampling and short CE analysis time allow for real-time monitoring of changes in sap constituents in the living plant during the stress response. The developed device was successfully used to analyze chloride, nitrate, and sulfate ions in the plant xylem during the salt stress or stress caused by nitrate deficiency within short time scales.

A new device for online nanoscale sampling and capillary electrophoresis analysis of plant sap composition.

The success of bottom-up proteomic analysis frequently depends on the efficient removal of contaminants from protein or peptide samples before LC-MS/MS. For a peptide clean-up workflow, single-pot solid-phase-enhanced peptide sample preparation on carboxylate-modified paramagnetic beads (termed SP2) was evaluated for sodium dodecyl sulfate or polyethylene glycol removal from  tryptic peptides. The robust and efficient 40-min SP2 protocol, tested for 10-ng, 250-ng, and 10-µg peptide samples, was proposed and benchmarked thoroughly against the ethyl acetate extraction protocol. The SP2 protocol on carboxylated magnetic beads proved to be the most robust approach, even for the simultaneous removal of massive sodium dodecyl sulfate (SDS) and polyethylene glycol (PEG) contaminations from AT peptide samples in respect of the LC-MS/MS data outperforming ethyl acetate extraction.

Benchmarking of Two Peptide Clean-Up Protocols: SP2 and Ethyl Acetate Extraction for Sodium Dodecyl Sulfate or Polyethylene Glycol Removal from Plant Samples before LC-MS/MS.

Martin Trtilek

Photon Systems Instruments

Prumyslova

Non-invasive Assay for Chlorophyll Biosynthesis Kinetics Determination during Early Stages of Arabidopsis De-etiolation

Martin Trtilek

.css-o250i3{font-size:18px;font-family:Open Sans,sans-serif;line-height:21.6px;}Photon Systems Instruments

Prumyslova

Non-invasive Assay for Chlorophyll Biosynthesis Kinetics Determination during Early Stages of Arabidopsis De-etiolation

Photon Systems Instruments