a-structured-rehabilitation-protocol-for-improved-multifunctional

A Structured Rehabilitation Protocol for Improved Multifunctional Prosthetic Control: A Case Study

Advances in robotic systems have resulted in prostheses for the upper limb that can produce multifunctional movements. However, these sophisticated ...

Bernstein Focus Neurotechnology Göttingen

Georg-August University

We propose an approach for online simultaneous and proportional myoelectric control of two degrees-of-freedom (DoF) of the wrist, using surface electromyographic signals. The method is based on the nonnegative matrix factorization (NMF) of the wrist muscle activation to extract low-dimensional control signals translated by the user into kinematic variables. This procedure does not need a training set of signals for which the kinematics is known (labeled dataset) and is thus unsupervised (although it requires an initial calibration without labeled signals). The estimated control signals using NMF are used to directly control two DoFs of wrist. The method was tested on seven subjects with upper limb deficiency and on seven able-bodied subjects. The subjects performed online control of a virtual object with two DoFs to achieve goal-oriented tasks. The performance of the two subject groups, measured as the task completion rate, task completion time, and execution efficiency, was not statistically different. The approach was compared, and demonstrated to be superior to the online control by the industrial state-of-the-art approach. These results show that this new approach, which has several advantages over the previous myoelectric prosthetic control systems, has the potential of providing intuitive and dexterous control of artificial limbs for amputees.

Intuitive, online, simultaneous, and proportional myoelectric control over two degrees-of-freedom in upper limb amputees.

In this paper, we present a systematic analysis of the relationship between the accuracy of the mapping between EMG and hand kinematics and the control performance in goal-oriented tasks of three simultaneous and proportional myoelectric control algorithms: nonnegative matrix factorization (NMF), linear regression (LR), and artificial neural networks (ANN). The purpose was to investigate the impact of the precision of the kinematics estimation by a myoelectric controller for accurately complete goal-directed tasks. Nine naïve subjects performed a series of goal-directed myoelectric control tasks using the three algorithms, and their online performance was characterized by 6 indexes. The results showed that, although the three algorithms' mapping accuracies were significantly different, their online performance was similar. Moreover, for LR and ANN, the offline performance was not correlated to any of the online performance indexes, and only a weak correlation was found with three of them for NMF . We conclude that for reliable simultaneous and proportional myoelectric control, it is not necessary to achieve high accuracy in the mapping between EMG and kinematics. Rather, good online myoelectric control is achieved by the continuous interaction and adaptation of the user with the myoelectric controller through feedback (visual in the current study). Control signals generated by EMG with rather poor association with kinematic variables can still be fully exploited by the user for precise control. This conclusion explains the possibility of accurate simultaneous and proportional control over multiple degrees of freedom when using unsupervised algorithms, such as NMF.

Is accurate mapping of EMG signals on kinematics needed for precise online myoelectric control?

Targeted muscle reinnervation (TMR) redirects nerves that have lost their target, due to amputation, to remaining muscles in the region of the stump with the intent of establishing intuitive myosignals to control a complex prosthetic device. In order to directly recover the neural code underlying an attempted limb movement, in this paper, we present the decomposition of high-density surface electromyographic (EMG) signals detected from three TMR patients into the individual motor unit spike trains. The aim was to prove, for the first time, the feasibility of decoding the neural drive that would reach muscles of the missing limb in TMR patients, to show the accuracy of the decoding, and to demonstrate the representativeness of the pool of extracted motor units. Six to seven flexible EMG electrode grids of 64 electrodes each were mounted over the reinnervated muscles of each patient, resulting in up to 448 EMG signals. The subjects were asked to attempt elbow extension and flexion, hand open and close, wrist extension and flexion, wrist pronation and supination, of their missing limb. The EMG signals were decomposed using the Convolution Kernel Compensation technique and the decomposition accuracy was evaluated with a signal-based index of accuracy, called pulse-to-noise ratio (PNR). The results showed that the spike trains of 3 to 27 motor units could be identified for each task, with a sensitivity of the decomposition > 90%, as revealed by PNR. The motor unit discharge rates were within physiological values of normally innervated muscles. Moreover, the detected motor units showed a high degree of common drive so that the set of extracted units per task was representative of the behavior of the population of active units. The results open a path for a new generation of human-machine interfaces in which the control signals are extracted from noninvasive recordings and the obtained neural information is based directly on the spike trains of motor neurons.

Noninvasive, accurate assessment of the behavior of representative populations of motor units in targeted reinnervated muscles.

Myoelectric control offers a direct interface between human intent and various robotic applications through recorded muscle activity. Traditional control schemes realize this interface through direct mapping or pattern recognition techniques. The former approach provides reliable control at the expense of functionality, while the latter increases functionality at the expense of long-term reliability. An alternative approach, using concepts of motor learning, provides session-independent simultaneous control, but previously relied on consistent electrode placement over biomechanically independent muscles. This paper extends the functionality and practicality of the motor learning-based approach, using high-density electrode grids and muscle synergyinspired decomposition to generate control inputs with reduced constraints on electrode placement. The method is demonstrated via real-time simultaneous and proportional control of a 4- DoF myoelectric interface over multiple days. Subjects showed learning trends consistent with typical motor skill learning without requiring any retraining or recalibration between sessions. Moreover, they adjusted to physical constraints of a robot arm after learning the control in a constraint-free virtual interface, demonstrating robust control as they performed precision tasks. The results demonstrate the efficacy of the proposed manmachine interface as a viable alternative to conventional control schemes for myoelectric interfaces designed for long-term use.

High-Density Electromyography and Motor Skill Learning for Robust Long-Term Control of a 7-DoF Robot Arm.

Pattern recognition and regression methods applied to the surface EMG have been used for estimating the user intended motor tasks across multiple degrees of freedom (DoF), for prosthetic control. While these methods are effective in several conditions, they are still characterized by some shortcomings. In this study we propose a methodology that combines these two approaches for mutually alleviating their limitations. This resulted in a control method capable of context-dependent movement estimation that switched automatically between sequential (one DoF at a time) or simultaneous (multiple DoF) prosthesis control, based on an online estimation of signal dimensionality. The proposed method was evaluated in scenarios close to reallife situations, with the control of a physical prosthesis in applied tasks of varying difficulties. Test prostheses were individually manufactured for both able-bodied and transradial amputee subjects. With these prostheses, two amputees performed the Southampton Hand Assessment Procedure (SHAP) test with scores of 58 and 71 points. The 5 able-bodied individuals performed standardized tests, such as the box█ and clothes pin test, reducing the completion times by up to 30%, with respect to using a state-of-the-art pure sequential control algorithm. Apart from facilitating fast simultaneous movements, the proposed control scheme was also more intuitive to use, since human movements are predominated by simultaneous activations across joints. The proposed method thus represents a significant step towards intelligent, intuitive and natural control of upper limb prostheses.

Ivan Vujaklija

Department of Neurorehabilitation Engineering

Bernstein Focus Neurotechnology Göttingen

A Structured Rehabilitation Protocol for Improved Multifunctional Prosthetic Control: A Case Study

Ivan Vujaklija

.css-o250i3{font-size:18px;font-family:Open Sans,sans-serif;line-height:21.6px;}Department of Neurorehabilitation Engineering

Bernstein Focus Neurotechnology Göttingen

A Structured Rehabilitation Protocol for Improved Multifunctional Prosthetic Control: A Case Study

Department of Neurorehabilitation Engineering