All
Research
Education
Forschung
Lehre
Business
Lösungen
DE
EN - English
CN - 中文
DE - Deutsch
ES - Español
KR - 한국어
IT - Italiano
FR - Français
PT - Português
TR - Türkçe
JA - 日本語
PL - Polski
RU - Русский
HE - עִברִית
AR - العربية
Anmelden
Chapter 18
A rod subjected to a load undergoes elongation. A load-deformation diagram can represent the elongation but cannot predict deformation in different rods. ...
Consider a cylindrical specimen placed in a system to measure its tensile strength. Two gauge marks are inscribed on the central portion of the specimen. ...
When a specimen is subjected to loading the length first increases linearly at a slow rate, resulting in an initial straight line with a steep slope on ...
Brittle materials, including glass, cast iron, and stone, exhibit unique characteristics. They fracture without considerable change in their elongation ...
Engineering stress is the ratio of the load and the undeformed original cross-sectional area. Engineering stress approximates strain which represents the ...
Hooke's law states that stress applied to a material is directly proportional to the strain it experiences within the elastic limit. For ductile ...
Materials under stress due to tensile loading exhibit elastic and linear behavior until the yield point. Removing the load at the yield point, stress and ...
Fatigue occurs when the materials, under repeated loads for thousands or millions of cycles, rupture at a stress level much lower than the material's ...
The deformation of a rod with different materials and cross-sections is computed by dividing it into parts, each characterized by individual parameters. ...
Consider two cylindrical rods, one of steel and another of brass, joined at point B and restrained by rigid supports at points A and C. Determine the ...
A homogeneous rod with a uniform cross-section, resting freely on a horizontal surface, expands when heated. The expansion is proportional to the ...
Consider a non-homogenous rod made of steel and brass, restrained at both ends and subjected to a temperature change. The stress and load on the rod are ...
When a slender bar is subjected to an axial load, the bar material undergoes axial strain, causing it to deform in the axial direction. Simultaneously, ...
The generalized Hooke's Law is a broadened version of Hooke's Law, which extends to all types of stress and in every direction. Consider an ...
The bulk modulus is a scientific term used to describe a material's resistance to uniform compression. It is the proportionality constant that links a ...
In a cubic element with a general state of stress, the shearing stresses can deform a cube into an oblique parallelepiped without affecting normal ...
A slender bar subjected to an axial load undergoes deformation in the axial and transverse directions. The deformation affects the cubic elements within ...
Consider a member with plates on both ends. When loads are applied centrally on the plates, they move towards each other without rotating, causing the ...
Stress concentration refers to the amplification of stress in a structural member near points of discontinuity, such as holes or abrupt changes in ...
When a rod is stretched beyond its yield point, it permanently deforms and doesn't regain its original length. The stresses created during loading are ...
Datenschutz
Nutzungsbedingungen
Richtlinien
Kontakt
BIBLIOTHEKS-EMPFEHLUNG
JoVE-Newsletter
JoVE Journal
Methodensammlungen
JoVE Encyclopedia of Experiments
Archiv
JoVE Core
JoVE Science Education
JoVE Lab Manual
JoVE Quiz
JoVE Playlist
Autoren
Bibliothekare
Zugang
ÜBER JoVE
JoVE Sitemap
Copyright © 2025 MyJoVE Corporation. Alle Rechte vorbehalten
