Forschungszentrum Jülich

In this protocol the fabrication, setup and basic operation of a microfluidic picoliter bioreactor (PLBR) for single-cell analysis of prokaryotic microorganisms is introduced. Industrially relevant microorganisms were analyzed as proof of principle allowing insights into growth rate, morphology, and phenotypic heterogeneity over certain time periods, hardly possible with conventional methods.

The methodology to perform friction force microscopy experiments for contacting brushes is presented: Two polymer brushes that are grafted from (a) substrates and (b) colloidal probes are slid to show that, by using two contacting immiscible brush systems, friction in sliding contacts is reduced compared to miscible brush systems.

A scanner for imaging magnetic particles in planar samples was developed using the planar frequency mixing magnetic detection technique. The magnetic intermodulation product response from the nonlinear nonhysteretic magnetization of the particles is recorded upon a two-frequency excitation. It can be used to take 2D images of thin biological samples.

A method for the functionalization of carbon nanotubes with structure-tunable polymeric encapsulation layers and structural characterization using small-angle neutron scattering is presented.

We demonstrate the precise manipulation of individual organic molecules on a metal surface with the tip of a scanning probe microscope driven in 3D by the experimenter's hand using a motion capture system and fully immersive virtual reality goggles.

This manuscript describes a generic approach for tailor-made design of microbial cultivation media. This is enabled by an iterative workflow combining Kriging-based experimental design and microbioreactor technology for sufficient cultivation throughput, which is supported by lab robotics to increase reliability and speed in liquid handling media preparation.

Guidelines are presented for recording and interpreting off-axis electron holograms to provide quantitative images of magnetic fields in nanoscale materials and devices in the transmission electron microscope.

We describe the method for quantitative analysis of the distribution of Aspergillus fumigatus conidia (3 µm in size) in the airways of mice. The method also can be used for the analysis of microparticles and nanoparticle agglomerate distribution in the airways in various pathological condition models.

This proctocol aims to provide a method for in vitro and in vivo mitochondrial Ca²⁺ imaging in astrocytes and neurons.

The robotic technique described herein aims to detail a stepwise approach to robot-assisted total mesorectal excision and lateral pelvic lymph node dissection for locally advanced (T3/T4) rectal cancer located below the peritoneal reflection.

Here, we describe the method of generating an artificial decidualization model using the ovariectomized mouse, a classic endometrial decidualization experiment in the research field of endometrial decidualization.

Utilizing the volume change of Si nanoparticles during (de)lithiation, the present protocol describes a screening method of potential coatings for all-solid-state batteries using in situ transmission electron microscopy.