in-situ-ftir-spectroscopy-as-tool-for-investigation-gassolid

<em>In situ</em> FTIR Spectroscopy as a Tool for Investigation of Gas/Solid Interaction: Water-Enhanced CO<sub>2</sub> Adsorption in UiO-66 Metal-Organic Framework

In situ infrared spectroscopy is an inexpensive, highly sensitive, and selective valuable tool to investigate the interaction of polycrystalline solids ...

Bulgarian Academy of Sciences

Adsorption of CO on gold supported in zeolite NaY at 85 K led to the formation of (i) various carbonyls and isocarbonyls typical of the zeolite and (ii) carbonyls formed at cationic gold sites (observed in the 2186-2171 cm(-1) region). Analysis of the behavior of the bands allows their assignment to carbonyls of Au(3+) ions. At temperatures higher than 220 K, CO adsorption led to the formation of a new type of Au(3+)-CO species (2207 cm(-1)). Once formed, these complexes could be transformed into the dicarbonyls Au(3+)(CO)(2) when the sample was cooled to 85 K in the presence of CO. The results are explained by migration of Au(3+) ions to more accessible positions within the zeolite at increasing temperatures. When a CO molecule is already adsorbed, it stabilizes the Au(3+) ion in the new position, and a second CO molecule can be coordinated, thus forming a geminal species. These results are the first evidence of Au(3+)(CO)(2) complexes.

Formation of nonclassical carbonyls of Au3+ in zeolite NaY: characterization by infrared spectroscopy.

The reduction of a 1.3% Rh/TiO2 sample with carbon monoxide leads to the formation of uniform Rh nanoparticles with a mean diameter of dp ≈ 2.2 nm. Adsorption of CO on the reduced Rh/TiO2 produces linear and bridged carbonyls bound to metallic Rh(0) sites and only a few geminal dicarbonyls of Rh(I). The ν(CO) of linear Rh(0)-CO complexes is strongly coverage dependent: it is observed at 2078 cm(-1) at full coverage and at ca. 2025 cm(-1) at approximated zero coverage. At low coverage, this shift is mainly caused by a dipole-dipole interaction between the adsorbed CO molecules while at high coverage, the chemical shift also becomes important. Hydrogen hardly affects the CO adlayer at high CO coverages. However, on a partially CO-covered surface (θCO ≈ 0.5), the adsorption of H2 at increasing pressure leads to a gradual shift in the band of linear Rh(0)-CO from 2041 to 2062 cm(-1). Subsequent evacuation almost restores the original spectrum, demonstrating the reversibility of the hydrogen effect. Through the use of (12)CO + (13)CO isotopic mixtures, it is established that the addition of hydrogen to the CO-Rh/TiO2 system leads to an increase in the dynamic interaction between the adsorbed CO molecules. This evidences an increase in the density of the adsorbed CO molecules and indicates segregation of the CO and hydrogen adlayers. When CO is adsorbed on a hydrogen-precovered surface, the carbonyl band maximum is practically coverage independent and is observed at 2175-2173 cm(-1). These results are explained by a model according to which CO successively occupies different rhodium nanoparticles. 

Spectral evidence for hydrogen-induced reversible segregation of CO adsorbed on titania-supported rhodium.

We show that the first stages of interaction between NO and reduced ceria comprise the formation of azides, N3(-), with simultaneous oxidation of Ce(3+) to Ce(4+). This finding imposes revision on some current views of catalytic NO conversion and may contribute to design of new deNOx materials and processes. 

Formation of N3(-) during interaction of NO with reduced ceria.

Hydrogen dissociation and spillover on supported metal nanoparticles have received renewed interest because these chemical processes are closely related to applications in heterogeneous catalysis and hydrogen storage. In heterogeneous catalysis, spillover can control the reaction rate and selectivity of a wide range of reactions, e.g. hydrogenation, synthesis of methanol and hydroisomerization. In this work, we combine three spectroscopic approaches, i.e. the FT-IR spectroscopy of donated electrons, co-adsorbed CO and H/D exchange, to obtain detailed information on the dynamics of hydrogen interaction with a model 1.3% Rh/TiO2 catalyst. Our spectroscopic results helped us to build a physical picture of the processes occurring during the H-spillover on Rh/TiO2. It was found that molecular H2 dissociates on nanocrystalline Rh; H atoms spillover onto the titania thus protonating the semiconductor, while donating electrons to shallow trap (ST) states and the conduction band (CB) of TiO2. These donated electrons are observed by their specific IR features. By simultaneously monitoring the changes in the vibrational modes of CO, and, the infrared absorbance due to transitions involving CB and ST electrons, we found that both CO-reduced and partially re-oxidized Rh nanocrystallites promote the H-spillover and thus the n-doping of TiO2 materials. Upon evacuation, the process reverses: hydrogen atoms spillover back to Rh nanoparticles where they recombine to form H2 molecules that desorb from the surface. These new mechanistic insights into the process of H2 dissociation and spillover on the powder Rh/TiO2 catalyst call for further model surface science studies with model metal nanoparticle-single crystal substrate systems, in which a detailed picture of energetics and spatial distribution of hydrogen and injected electrons could be obtained. 

Hydrogen spillover on Rh/TiO2: the FTIR study of donated electrons, co-adsorbed CO and H/D exchange.

Acidity of solids is decisive for their interaction with guest molecules. One of the most used methods for measuring the acidity of surface hydroxyl groups is the hydrogen bond method based on the spectral shift of the OH stretching modes induced by the adsorption of weak bases. However, many materials of practical interest (e.g. metal organic frameworks, zeolites, etc.) are porous and the OH groups are involved in H-bonding with framework basic sites. Here we show that MIL-53(Al) and NH2-MIL-53(Al) samples are characterized by one type of structural hydroxyl but three IR bands are detected at 100 K with these materials (at 3721, 3711 and 3683 cm(-1)). These bands are assigned to structural hydroxyls involved in H-bonding with different strengths. There is no correlation between the acidities of the hydroxyls, as measured by low-temperature CO or (15)N2 adsorption, and the main reason for this is the pre-existing H-bond. A method for the estimation of the intrinsic frequency of the OH groups (i.e. if not participating in H-bonds), based on the analysis of the spectral data obtained with two molecular probes, is proposed. According to this method, the OH stretching frequency of the structural hydroxyls of MIL-53(Al) samples is determined to be 3727 cm(-1). The formation of 1 : 1 adducts between the hydroxyls and strong bases leads to breaking of the pre-existing H-bonds. When the base is weak, bifurcated complexes are formed which slightly affects the spectral shift. The conclusions derived here considerably broaden the applicability of the H-bond method for assessing protonic acidity of materials and systems where the OH groups are preliminarily involved in H-bonding. 

An advanced approach for measuring acidity of hydroxyls in confined space: a FTIR study of low-temperature CO and (15)N2 adsorption on MOF samples from the MIL-53(Al) series.

The paper addresses possible ambiguities in the determination of the state of platinum species by the stretching frequency of a CO probe, which is a common technique for characterization of platinum-containing catalytic systems. We present a comprehensive comparison of the available experimental data with our theoretical modeling (density functional) results of pertinent systems - platinum surfaces, nanoparticles and clusters as well as reduced or oxidized platinum moieties on a ceria support. Our results for CO adsorbed on-top on metallic Pt(0), with C-O vibrational frequencies in the region 2018-2077 cm(-1), suggest that a decrease of the coordination number of the platinum atom, to which CO is bound, by one lowers the CO frequency by about 7 cm(-1). This trend corroborates the Kappers-van der Maas correlation derived from the analysis of the experimental stretching frequency of CO adsorbed on platinum-containing samples on different supports. We also analyzed the effect of the charge of platinum species on the CO frequency. Based on the calculated vibrational frequencies of CO in various model systems, we concluded that the actual state of the platinum species may be mistaken based only on the measured value of the C-O vibrational frequency due to overlapping regions of frequencies corresponding to different types of species. In order to identify the actual state of platinum species one has to combine this powerful technique with other approaches. 

Can the state of platinum species be unambiguously determined by the stretching frequency of an adsorbed CO probe molecule?

A fully interpenetrated 8,3-connected zirconium MOF with the the-i topology type, STA-26 (St Andrews porous material-26), has been prepared using the 4,4',4"-(2,4,6-trimethylbenzene-1,3,5-triyl)tribenzoate (TMTB) tritopic linker with formic acid as a modulating agent. In the as-prepared form STA-26 possesses Im3‾ m symmetry compared with the Pm3‾ m symmetry of the non-interpenetrated analogue, NU-1200, prepared using benzoic acid as a modulator. Upon removal of residual solvent there is a shift between the interpenetrating lattices and a resultant symmetry change to Cmcm which is fully reversible. This is observed by X-ray diffraction and  C MAS NMR is also found to be remarkably sensitive to the structural transition. Furthermore, heating STA-26(Zr) in vacuum dehydroxylates the Zr nodes leaving coordinatively unsaturated Zr sites, as shown by IR spectroscopy using CO and CD CN as probe molecules. Nitrogen adsorption at 77 K together with grand canonical Monte Carlo simulations confirms a microporous, fully interpenetrated, structure with pore volume 0.53 cm  g while CO adsorption at 196 K reaches 300 cm STP g at 1 bar. While the pore volume is smaller than that of its non-interpenetrated mesoporous analogue, interpenetration makes the structure more stable to moisture adsorption and introduces shape selectivity in adsorption.

Modulator-Controlled Synthesis of Microporous STA-26, an Interpenetrated 8,3-Connected Zirconium MOF with the the-i Topology, and its Reversible Lattice Shift.

Konstantin I. Hadjiivanov

Institute of General and Inorganic Chemistry

Bulgarian Academy of Sciences

In situ FTIR Spectroscopy as a Tool for Investigation of Gas/Solid Interaction: Water-Enhanced CO₂ Adsorption in UiO-66 Metal-Organic Framework

Konstantin I. Hadjiivanov

.css-o250i3{font-size:18px;font-family:Open Sans,sans-serif;line-height:21.6px;}Institute of General and Inorganic Chemistry

Bulgarian Academy of Sciences

In situ FTIR Spectroscopy as a Tool for Investigation of Gas/Solid Interaction: Water-Enhanced CO2 Adsorption in UiO-66 Metal-Organic Framework

Institute of General and Inorganic Chemistry

In situ FTIR Spectroscopy as a Tool for Investigation of Gas/Solid Interaction: Water-Enhanced CO₂ Adsorption in UiO-66 Metal-Organic Framework