coupling-carbon-capture-from-power-plant-with-semi-automated-open

Coupling Carbon Capture from a Power Plant with Semi-automated Open Raceway Ponds for Microalgae Cultivation

In the United States, 35% of the total carbon dioxide (CO2) emissions come from the electrical power industry, of which 30% represent natural gas ...

University of Arizona

Bacterial populations inhabiting ultrapure water (UPW) systems were investigated. The analyzed UPW systems included pilot scale, bench scale, and full size UPW plants employed in the semiconductor and other industries. Bacteria present in the polishing loop of the UPW systems were enumerated by both plate counts and epifluorescence microscopy. Assessment of bacterial presence in UPW by epifluorescence microscopy (cyanotolyl tetrazolium chloride [CTC] and DAPI [4',6'-diamidino-2-phenylindole] staining) showed significantly higher numbers (10 to 100 times more bacterial cells were detected) than that determined by plate counts. A considerable proportion of the bacteria present in UPW (50 to 90%) were cells that did not give a positive signal with CTC stain. Bacteria isolated from the UPW systems were mostly gram negative, and several groups seem to be indigenous for all of the UPW production systems studied. These included Ralstonia pickettii, Bradyrhizobium sp., Pseudomonas saccharophilia, and Stenotrophomonas strains. These bacteria constituted a significant part of the total number of isolated strains (>or=20%). Two sets of primers specific to R. pickettii and Bradyrhizobium sp. were designed and successfully used for the detection of the corresponding bacteria in the concentrated UPW samples. Unexpectedly, nifH gene sequences were found in Bradyrhizobium sp. and some P. saccharophilia strains isolated from UPW. The widespread use of nitrogen gas in UPW plants may be associated with the presence of nitrogen-fixing genes in these bacteria.

Analysis of bacteria contaminating ultrapure water in industrial systems.

Alternatives for the destruction of common military explosives, including trinitrotoluene; hexahydro-1,3,5-trinitro-1,3,5-triazine; and octahydro-1,3,5,7 tetranitro-1,3,5,7-tetrazocine (HMX) are being investigated in the post-cold war period. One alternative combines chemical treatment (i.e., base hydrolysis of the explosives) and biological treatment (i.e., denitrification of the hydrolysate). This paper focuses on results of the biological part of the treatment process, during which Hyphomicrobium sp. bacteria were isolated from a seed obtained from a denitrification facility. The bacteria were enriched and maintained on a surrogate waste with methanol as the carbon source. The resulting culture is capable of anoxic growth in waste solutions containing up to 5000 mg/L of nitrite-nitrogen. The culture efficiently denitrifies both surrogate and actual hydrolysate wastes. A substrate inhibition model was used to accurately predict denitrification rates. Comparisons are made between denitrification rates obtained for surrogate versus actual wastes. Denitrification rates were higher when actual waste streams were used. This work demonstrates the feasibility of using Hyphomicrobiun sp. bacteria to treat HMX hydrolysate and presents a model that can be used to design a large-scale system.

Biological denitrification of hydrolysates from octahydro-1,3,5,7 tetranitro-1,3,5,7-tetrazocine.

Copper Chemical Mechanical Planarization (Cu-CMP) is a critical step in integrated circuit (IC) device manufacturing. CMP and post-CMP cleaning processes are projected to account for 30-40% of the water consumed by IC manufacturers in 2003. CMP wastewater is expected to contain increasing amounts of copper as the industry switches from Al-CMP to Cu-CMP causing some IC manufacturers to run the risk of violating discharge regulations. There are a variety of treatment schemes currently available for the removal of heavy metals from CMP wastewater, however, many introduce additional chemicals to the wastewater, have large space requirements, or are expensive. This work explores the use of microorganisms for waste treatment. A Staphylococcus sp. of bacteria was isolated and studied to determine the feasibility for use in removing copper from Cu-CMP wastewater. A model Cu-CMP wastewater was developed and tested, as well as actual Cu-CMP wastes. Continuous-flow packed column experiments were performed to obtain adsorption data and show copper recovery from the waste. A predictive, empirical model was used to accurately describe Cu removal. Additionally, the immobilized cells were regenerated, allowing for the concentration and potential recovery of copper from the wastewater.

Biosorption of copper (II) from chemical mechanical planarization wastewaters.

The biotransformation of explosives has been investigated by many researchers. Bioremediation of soil and water contaminated with hexahydro-1,3,5-trinitro-1,3,5-triazine (RDX) is becoming the method of choice for clean-up of a variety of sites. In this study, we investigated biotransformation of RDX in the presence of barium. Ba is a metal commonly found in combination with RDX at sites requiring remediation. RDX was biotransformed by both a consortium of bacteria and an isolate from the consortium under anoxic conditions using a rich medium. However, Ba inhibited cell growth under both aerobic and anoxic conditions and slowed biotransformation rates by 40%. RDX and Ba inhibited growth of the isolate more than growth of the consortium. An additive inhibition model is proposed that accurately predicts the reduced growth rates observed.

Prediction of growth and biotransformation rates of hexahydro-1,3,5-trinitro-1,3,5-triazine (RDX) in the presence of barium.

Copper chemical mechanical planarization (CMP) effluents can account for 30-40% of the water discharge in semiconductor manufacturing. CMP effluents contain high concentrations of soluble copper and a complex mixture of organic constituents. The aim of this study is to perform a preliminary assessment of the treatability of CMP effluents in anaerobic sulfidogenic bioreactors inoculated with anaerobic granular sludge by testing individual compounds expected in the CMP effluents. Of all the compounds tested (copper (II), benzotriazoles, polyethylene glycol (M(n) 300), polyethylene glycol (M(n) 860) monooleate, perfluoro-1-octane sulfonate, citric acid, oxalic acid and isopropanol) only copper was found to be inhibitory to methanogenic activity at the concentrations tested. Most of the organic compounds tested were biodegradable with the exception of perfluoro-1-octane sulfonate and benzotriazoles under sulfate reducing conditions and with the exception of the same compounds as well as Triton X-100 under methanogenic conditions. The susceptibility of key components in CMP effluents to anaerobic biodegradation combined with their low microbial inhibition suggest that CMP effluents should be amenable to biological treatment in sulfate reducing bioreactors.

Anaerobic biodegradability and methanogenic toxicity of key constituents in copper chemical mechanical planarization effluents of the semiconductor industry.

Copper is used extensively in semiconductor circuits as the multilayer metal. In addition to copper, waste streams often contain chelating agents like EDTA, which is widely used in the process to enhance solubility of copper, and it tends to form copper-chelated complexes. PEI--agarose adsorbents in a packed-bed column are capable of removing these anionic complexes, but the competitive binding between this chelating agent and PEI for copper is not well understood and needs to be explored. The current work focuses on investigating copper sorption by PEI-agarose adsorbent in the presence of EDTA. The pH of the column is fixed at 5.5 using 0.1 M acetate buffer. The ratio of chelator to copper ions is varied. Copper binding capacity and copper breakthrough curves are compared and contrasted to results without additional chelator present. An excess of EDTA leads to an increase in the fraction of free dissociated (anionic) ligand that competes for electrostatic attraction on protonated amine groups and therefore leads to a decrease in sorption capacity in the column. However, this waste treatment technique is still feasible for the semiconductor industry as large volumes of copper-contaminated solutions from actual waste can be concentrated 12-fold. When equimolar (copper to EDTA) or higher concentrations of EDTA are present, acetate can be utilized to recover the metal; for low ratios of copper to EDTA, metal recovery is achieved using hydrochloric acid.

Removal efficiency and binding mechanisms of copper and copper-EDTA complexes using polyethyleneimine.

Sweet sorghum is a domesticated grass containing a sugar-rich juice that can be readily utilized for ethanol production. Most of the sugar is stored inside the cells of the stalk tissue and can be difficult to release, a necessary step before conventional fermentation. While this crop holds much promise as an arid land sugar source for biofuel production, a number of challenges must be overcome. One lies in the inherent labile nature of the sugars in the stalks leading to a short usable storage time. Also, collection of sugars from the sweet sorghum stalks is usually accomplished by mechanical squeezing, but generally does not collect all of the available sugars.

Efficient extraction method to collect sugar from sweet sorghum.

Meaningful use of biofuels for transportation depends on utilization of water from non-traditional, non-potable resources. Here it is hypothesized that (i) reclaimed wastewater or nutrient-rich side streams derived from municipal wastewater treatment are suitable for that purpose and (ii) use of those waters for algal growth can promote water quality through nutrient management. Experiments showed that metals levels in municipal wastewaters are unlikely to inhibit algal growth and lipid production, at least by metals tolerant microalgae like Nannochloropsis salina. Cells grew without inhibition in treated municipal wastewater or centrate derived from wastewater treatment at additions up to 75 percent v/v in their normal growth medium minus nitrogen and phosphorus. Although wastewater provides a suitable nutrient source for algal growth, not enough municipal wastewater is available to support a meaningful biofuels industry without efficient water recycling and nutrient recovery/reuse from spent algae. 

Cultivation of Nannochloropsis salina in municipal wastewater or digester centrate.

A multi-wavelength based optical density sensor unit was designed, developed, and evaluated to monitor microalgae growth in real time. The system consisted of five main components including: (1) laser diode modules as light sources; (2) photodiodes as detectors; (3) driver circuit; (4) flow cell; and (5) sensor housing temperature controller. The sensor unit was designed to be integrated into any microalgae culture system for both real time and non-real time optical density measurements and algae growth monitoring applications. It was shown that the sensor unit was capable of monitoring the dynamics and physiological changes of the microalgae culture in real-time. Algae biomass concentration was accurately estimated with optical density measurements at 650, 685 and 780 nm wavelengths used by the sensor unit. The sensor unit was able to monitor cell concentration as high as 1.05 g·L(-1) (1.51 × 10⁸ cells·mL(-1)) during the culture growth without any sample preparation for the measurements. Since high cell concentrations do not need to be diluted using the sensor unit, the system has the potential to be used in industrial microalgae cultivation systems for real time monitoring and control applications that can lead to improved resource use efficiency. 

Kimberly L. Ogden

Department of Chemical and Environmental Engineering,
Department of Biosystems Engineering

University of Arizona

Coupling Carbon Capture from a Power Plant with Semi-automated Open Raceway Ponds for Microalgae Cultivation

Kimberly L. Ogden

.css-o250i3{font-size:18px;font-family:Open Sans,sans-serif;line-height:21.6px;}Department of Chemical and Environmental Engineering,Department of Biosystems Engineering

University of Arizona

Coupling Carbon Capture from a Power Plant with Semi-automated Open Raceway Ponds for Microalgae Cultivation

Department of Chemical and Environmental Engineering,
Department of Biosystems Engineering