characterization-multi-layered-fish-scales-atractosteus-spatula-using

Characterization Of Multi-layered Fish Scales (<em>Atractosteus spatula</em>) Using Nanoindentation, X-ray CT, FTIR, and SEM

The hierarchical architecture of protective biological materials such as mineralized fish scales, gastropod shells, ram&#8217;s horn, antlers, and turtle ...

U.S. Army Engineer Research and Development Center

Isoelectric points (IEPs) were determined by the method of contact angle titration for five common quartz crystal microbalance (QCM) sensors. The isoelectric points range from mildly basic in the case of Al2O3 sensors (IEP = 8.7) to moderately acidic for Au (5.2) and SiO2 (3.9), to acidic for Ag (3.2) and Ti (2.9). In general, the values reported here are indicative of inherent surface oxides. A demonstration of the effect of the surface isoelectric point on the packing efficiency of thin mucin films is provided for gold and silica QCM sensors. It is determined that mucin layers on both substrates achieve a maximum and equal layer density of ∼3500 kg/m(3) at the corresponding IEP of either QCM sensor. This implies that mucin film packing is dependent upon short-range electrostatic interactions at the sensor surface.

Determination of isoelectric points and the role of pH for common quartz crystal microbalance sensors.

In benthic sediment bioassays, determining the relative contribution to exposure by contaminants in overlying water, porewater, and sediment particles is technically challenging. The purpose of the present study was to assess the potential for membranes to be utilized as a mechanism to allow freely dissolved hydrophobic organic contaminants into a pathway isolation exposure chamber (PIC) while excluding all sediment particles and dissolved organic carbon (DOC). This investigation was conducted in support of a larger effort to assess contaminant exposure pathways to benthos. While multiple passive samplers exist for estimating concentrations of contaminants in porewater such as those using solid-phase micro extraction (SPME) and polyoxymethylene (POM), techniques to effectively isolate whole organism exposure to porewater within a sediment system are not available. We tested the use of four membranes of different pore sizes (0.1-1.2μm) including nylon, polycarbonate, polyethylsulfone, and polytetrafluoroethylene with a hydrophilic coating. Exposures included both diffusion of radiolabeled and non-labeled contaminants across membranes from aqueous, sediment slurry, and whole sediment sources to assess and evaluate the best candidate membrane. Data generated from the present study was utilized to select the most suitable membrane for use in the larger bioavailability project which sought to assess the relevance of functional ecology in bioavailability of contaminated sediments at remediation sites. The polytetrafluoroethylene membrane was selected for use in the PIC, although exclusion of dissolved organic carbon was not achieved.

Testing of various membranes for use in a novel sediment porewater isolation chamber for infaunal invertebrate exposure to PCBs.

Assessing the dissolution of silver nanoparticles (AgNPs) in laboratory test media and in the aquatic environment is critical for determining toxicity. In the present study, the ion-release kinetics for 20-nm, 50-nm, and 80-nm AgNPs in environmentally relevant freshwaters with different electrical conductivity values (30 µS/cm, 150 µS/cm) were examined and related to the associated impact on Daphnia magna. The acute toxicity of the AgNP suspensions to D. magna was assessed after 0 d and 7 d of interaction time between the particles and test media. When 48-h lethal median concentrations were expressed as total silver, D. magna was more sensitive to AgNPs suspended in low ionic strength media relative to higher ionic strength media, with the exception of 50-nm AgNPs suspended in the 150-µS/cm medium. A 3.3-fold increase in hydrodynamic diameter measured by dynamic light scattering and field flow fractionation was observed over time for 20-nm particles in the 150-µS/cm medium, but only a small increase in aggregation size for 50-nm and 80-nm particles (1.4-fold and 1.2-fold increase, respectively) was observed. At a lower conductivity of 30 µS/cm, a 1.7-fold, 1.0-fold, and 1.2-fold increase in aggregation size was observed in the 20-nm, 50-nm, and 80-nm particles, respectively. Thus, the impact of higher conductivity test media on increased aggregation and decreased toxicity (after 7 d) was relatively greater for the smaller (20-nm) AgNP higher compared to the 50-80 nm AgNPs. Environ Toxicol Chem 2014;9999:1-9. Published 2014 Wiley Periodicals, Inc. This article is a US Government work and, as such, is in the public domain in the United States of America.

Aimee R. Poda

Environmental Laboratory

U.S. Army Engineer Research and Development Center

Characterization Of Multi-layered Fish Scales (Atractosteus spatula) Using Nanoindentation, X-ray CT, FTIR, and SEM