Generation of Bone Marrow Derived Murine Dendritic Cells for Use in 2-photon Imaging

Podsumowanie

Antigen presentation in secondary lymphoid organs by dendritic cells is crucial for the initiation of the T cell mediated adaptive immune response. Here we demonstrate the culture of bone marrow derived murine dendritic cells, activation, and labeling for 2-photon imaging.

Streszczenie

Several methods for the preparation of murine dendritic cells can be found in the literature. Here, we present a method that produces greater than 85% CD11c high dendritic cells in culture that home to the draining lymph node after subcutaneous injection and present antigen to antigen specific T cells (see video). Additionally, we use Essen Instruments Incucyte to track dendritic cell maturation, where, at day 10, the morphology of the cultured cells is typical of a mature dendritic cell and <85% of cells are CD11chigh. The study of antigen presentation in peripheral lymph nodes by 2-photon imaging revealed that there are three distinct phases of dendritic cell and T cell interaction^{1, 2}. Phase I consists of brief serial contacts between highly motile antigen specific T cells and antigen carrying dendritic cells^{1, 2}. Phase two is marked by prolonged contacts between antigen-specific T cell and antigen bearing dendritic cells^{1, 2}. Finally, phase III is characterized by T cells detaching from dendritic cells, regaining motility and beginning to divide^{1, 2}. This is one example of the type of antigen-specific interactions that can be analyzed by two-photon imaging of antigen-loaded cell tracker dye-labeled dendritic cells.

Protokół

1) Remove both femur bones from one mouse

1. Use dissection scissors to cut away muscle and expose the femur bone above and below the joints (knee and hip). Grasp the center of the femur with dissection tweezers and cut above and below the joints to leave as much of the epiphysis intact as possible.
2. Clean off as much muscle as possible using small dissection scissors. Transfer the femur into a dish of RPMI.
3. All procedures should be carried out in the hood from this point on, using only sterile media, instruments, pipette tips and culture dishes.

2) Sterilize Femur bones:

1. In the hood, transfer bones from the RPMI to a small culture dish filled with 70% ethanol on ice.
2. Allow bones to soak in ethanol for 5 minutes on ice.

3) Collect Bone marrow under sterile conditions:

1. Transfer bones to a small culture dish containing sterile filtered Primary DC culture media.
2. With sterile tweezers, hold the bone over a discard dish or tube, and with sterile scissors, cut each epiphesis (ends of the bone) off. The cut should expose bone marrow which is bright red in the center of the bone.
3. With a sterile syringe (26-28 gauge needle), suck up about 100-200 mL of sterile media.
4. Hold the bone with the sterile tweezers over a fresh dish of sterile media and insert the needle into one side of the bone. Position the tip of the needle near the top of the bone and slowly wash the bone out with the sterile media. If you are in the center of the bone, the needle should slide in easily.
5. The bone marrow washes out, either in small pieces or as a single piece. It should be flushed out of the bone and into the dish of sterile media.
6. Repeat this step as needed to completely wash the marrow out of the bone.
7. When the bone is clean, it will be white and translucent.
8. Repeat this procedure with the other femur bone. Discard each femur bone once it is clean.

4) Re-suspend and Spin down Bone Marrow cells:

1. Transfer cells to a sterile falcon tube.
2. If marrow is still intact, very gently pipette media up and down in the dish, to break up the marrow into a single cell suspension. This may take several minutes and should be done slowly to avoid killing cells by sheer force.
3. Centrifuge cells as you would any other mammalian cells.

5) Cell Lysis:

1. Remove the tube from the centrifuge after the spin is done and pour media off (decant) into a small waste (50 mL falcon tube) in the hood.
2. Resuspend pellet by gently flicking the bottom of the tube.
3. Using sterile filtered water and 10x DPBS or 10x PBS, carry out a water lysis to remove the red blood cells (RBCs) using the following volumes:
   • 900 mL sterile filtered water
   • 100 mL 10x DPBS or 10x PBS
4. Add 100 mL of 10x PBS 5-10 seconds after adding the water. It is very important do this immediately so that only the RBCs are lysed. It is a good idea to have both pipettes filled and ready.
5. Add 5 mL – 10 mL of sterile DC basic media.

6) Count Cells:

1. In the hood, mix the 6 to 11 mL of bone marrow cells by gently swirling the tube with a slight inversion, a 45 degree tilt (not so that the media touches the top of the tube)
2. Remove 10 mL of media into a sterile tube for counting.
3. Re-cap the cells and centrifuge again.

7) Plating Dendritic cells:

1. Cells should be plated at a density of 1 x 106/mL.
2. Remove cells from centrifuge, decant media and re-suspend cells in the appropriate amount of Primary DC Media for plating.
3. Place in tissue culture incubator. 

8) Culture Care and Maturation:

Always check cultures before adding more media or using in any experiments. Check the general health of cells and look for potential contamination.

DAY 0: Dendritic cells plated.

DAY 3: Remove 75% of the media and non-adherant cells and add back Primary DC media.

DAY 6: After Initial Cell Plating: Re-plate the cells using the following procedure:

1. Remove media, which should contain some non-adherant DCs at this point, and place in a sterile 50 mL falcon tube, leaving plates very slightly wet (you don’t want the adherent cells to dry out)
2. Add 3 mM EDTA in PBS to each plate and allow to sit for 5 minutes.
3. Hold the plate at a 45 degree angle and gently pipette media up and down against the bottom of the plate to gently dislodge non-adherant cells.
4. EDTA/PBS should become thicker indicating cells are being collected from the bottom of the plate.
5. After several minutes of this, cell mixture can be transferred to the 50 mL falcon tube.
6. Spin all cells after performing this procedure for each plate.
7. Count and plate the cells at a density of 1 x 10^6 per plate in Secondary DC Media in new sterile 10 cm culture dishes. Return cells to tissue culture incubator.

DAY 10-11

Mature DCs ready for stimulation/antigen loading.

9) Dendritic Cell Stimulation:

1. Use LPS (lipopolyscaccharide) in combination with desired peptide for activation and peptide loading. Depending on your source of LPS, different stimulation conditions may give better results. Additionally, the desired amount of peptide for DC presentation should be optimized. Stimulation conditions in this protocol were 100 ng/mL LPS and 100 ug/mL OVA (ovalbumin). 
2. Load antigen/treat with LPS for 18-24 hours prior to harvest/use.

Dendritic Cell Media: Sterile filter after everything has been added

Please see the discussion section for a review of different dendritic cell culture conditions and for the resulting dendritic cell phenotype. These culture conditions are designed to produce mature dendritic cells that rapidly home to draining lymph nodes, 18-24 hours after subcutaneous injection and present antigen efficiently.

Primary DC Media: Sterile filter after everything has been added

• 500 mL IMDM (remove 55-60 mL for 500mL final volume)
• 50 mL heat inactivated FBS
• 5 mL of 200 mM L-Gln, final concentration of 2 mM
• 100 IU/mL Penicillin and 100 mg/mL streptomycin (5 mL of 10,000 IU/mL Pen and 10,000 mg/mL Strep stock)
• 50 uM B-Me (14.3 M B-Me stock, dilute 1:100 in chemical hood, use 35 ul per 100 mL media for 50 micromolar concentration)
• 20-30 ng/mL GM-CSF
• 100-400 IU/mL IL-4 roughly 10- 40 ng/mL

SecondaryDC media for maturation*

100 ng/mL TNF-alpha (add to Primary DC media)

* Note: GM-CSF + IL-4 should produce immature dendritic cells. Using GM-CSF + IL4 (400 IU/ul) + TNF-alpha (100 ug/mL) will create cells that resemble mature monocyte derived dendritic cells. Mature dendritic cells are known not to take up antigen as efficiently as immature dendritic cells and cultures may have endogenous TNF-a released from stromal cells⁴.

Access restricted. Please log in or start a trial to view this content.

Dyskusje

Dendritic cells are key mediators of the adaptive immune response and the most efficient antigen presenting cell characterized to date. Methods for human and mouse dendritic cell culture in the literature differ in the type of cytokines used to influence the development of different dendritic cell types. Notably, GM-CSF, flt3L, IL4, IL13, TNF-alpha and IFN-gamma are used in different combinations to produce mature, immature, inflammatory and steady-state like murine bone marrow derived dendritic cells in vitro^3-7

Access restricted. Please log in or start a trial to view this content.