Source: Laboratories of Margaret Workman and Kimberly Frye - Depaul University
Lead occurs naturally in soil, in levels ranging from 10-50 ppm. However, with the widespread use of lead in paint and gasoline in addition to contamination by industry, urban soils often have concentrations of lead significantly greater than background levels – up to 10,000 ppm in some places. Ongoing problems arise from the fact that lead does not biodegrade, and instead remains in the soil.
Serious health risks are associated with lead poisoning, where children are particularly at risk. Millions of children in the U.S. are exposed to soil containing lead. This exposure can cause developmental and behavioral problems in children. These problems include learning disabilities, inattention, delayed growth, and brain damage. The Environmental Protection Agency has set a standard for lead in soil at 400 ppm for play areas and 1,200 ppm for non-play areas.
Lead is also of concern in soil, when it’s used for gardening. Plants take up lead from the soil. Therefore, vegetables or herbs grown in contaminated soil can lead to lead poisoning. In addition, contaminated soil particles can be breathed in while gardening or brought into the house on clothing and footwear. It is recommended that soils with lead levels greater than 400 ppm should not be used for gardening. It is further recommended that soil with lead levels between 100 and 400 ppm not be used for leafy vegetables or herbs, because lead can be stored in the leaves. On a similar note, root vegetables should not be grown in this soil, because lead can also accumulate in plant roots.
1. Soil Collection and Preparation
2. Sample Digestion
The software creates the calibration curve and automatically determines the concentration of the Pb in the samples (Figure 2).
Figure 2. The calibration curve and the concentration of the Pb in the samples automatically determined by the software.
The values given on the worksheet are mg/L of Pb in the sample solution. Addi
Atomic Absorption Spectrometry is a useful technique to analyze a wide range of environmental samples (e.g., water, soil, sludge, and sediment) for a large number of elements (e.g., heavy metals). This experiment highlights the use of flame AAS to determine the Pb content in soil. However, it could also be used to measure concentrations of Cu, Fe, Mn, K, Na, Mg, and Zn in soils.
Zinc is an important micronutrient and is needed for protein synthesis. Zn helps regulate the expr
Skip to...
Videos from this collection:
Now Playing
Environmental Science
123.8K Views
Environmental Science
79.0K Views
Environmental Science
48.9K Views
Environmental Science
11.8K Views
Environmental Science
21.8K Views
Environmental Science
51.7K Views
Environmental Science
88.3K Views
Environmental Science
35.4K Views
Environmental Science
54.9K Views
Environmental Science
38.2K Views
Environmental Science
26.0K Views
Environmental Science
29.6K Views
Environmental Science
28.8K Views
Environmental Science
213.9K Views
Environmental Science
16.3K Views
ABOUT JoVE
Copyright © 2025 MyJoVE Corporation. All rights reserved