S'identifier

Core - Civil Engineering

Chapter 2

Masonry

2.1 : Composite Masonry Walls

2.1 : Composite Masonry Walls

Composite masonry walls are constructed using two or more wythes made with different masonry materials or the same masonry materials. The wythes are ...

2.2 : Masonry Cavity Walls

2.2 : Masonry Cavity Walls

A masonry cavity wall consists of two wythes separated by a hollow space. The outer and inner wythes are connected using corrosion-resistant masonry ties ...

2.3 : Masonry Loadbearing Walls

2.3 : Masonry Loadbearing Walls

Masonry load-bearing walls are constructed using brick, stone, or concrete masonry units to support floor and roof structures. These walls carry their own ...

2.4 : Masonry Curtain Walls

2.4 : Masonry Curtain Walls

Masonry curtain walls are exterior claddings of brick or stone masonry veneers supported by the building's structural frame. Firstly, steel shelf ...

2.5 : Posttensioned Masonry Walls

2.5 : Posttensioned Masonry Walls

Post-tensioned masonry walls are constructed using threaded high-strength steel rods or flexible tendons that are anchored to the foundation and extended ...

2.6 : Cavity Drainage and Flashings in Masonry walls

2.6 : Cavity Drainage and Flashings in Masonry walls

In cavity walls, a minimum separation is maintained to ensure unobstructed cavity drainage. Often, a continuous drainage mat within the cavity is used to ...

2.7 : Thermal Insulation in Masonry Walls

2.7 : Thermal Insulation in Masonry Walls

Masonry walls can be thermally insulated to minimize heat loss in the winter and heat gains in the summer. Thermal insulation can be done on the exterior ...

2.8 : Expansion and Contraction in Masonry Walls

2.8 : Expansion and Contraction in Masonry Walls

Consider a brick wall exposed to continuous rain; the brick absorbs moisture and tends to expand slightly. In the absence of space to expand, compressive ...

2.9 : Movement Joints in Buildings

2.9 : Movement Joints in Buildings

Slight movements in buildings can occur during the expansion of building units exposed to moisture or the upward heaving of foundations when water in the ...

2.10 : Types of Building Separation Joints

2.10 : Types of Building Separation Joints

Consider a large shopping mall with a geometrically complex building structure. This complex is subdivided into small, geometrically compact, independent ...

2.11 : Efflorescence in Masonry

2.11 : Efflorescence in Masonry

Efflorescence appears as a crystalline powder patch, often white in color, on brick, stone, or concrete masonry surfaces. When water infiltrates the ...

2.12 : Mortar Joint Deterioration in Masonry

2.12 : Mortar Joint Deterioration in Masonry

A masonry wall, when exposed to rainwater, often collects water in the mortar-filled joints of the wall. The water collected in the joints, when subjected ...

2.13 : Masonry in Cold and Hot Weather Conditions

2.13 : Masonry in Cold and Hot Weather Conditions

During cold weather, rapid-hardening cement is used in mortar preparation. Hot water is added to it, keeping the mortar temperature between 40 degrees to ...

2.14 : Masonry Paving

2.14 : Masonry Paving

Masonry pavings are used in pedestrian walkways, building entrances, patios, and sometimes in driveways. It is constructed using bricks, stones, and ...

Copyright © 2025 MyJoVE Corporation. Tous droits réservés.