analysis-athird11-intrinsic-disorder-binding-towards-metal-ions

Analysis of AtHIRD11 Intrinsic Disorder and Binding Towards Metal Ions by Capillary Gel Electrophoresis and Affinity Capillary Electrophoresis

Plants are strongly dependent on their environment. In order to adjust to stressful changes (e.g., drought and high salinity), higher plants evolve ...

TU Braunschweig

In this work, the behavior of several metal ions with different globular proteins was investigated by affinity capillary electrophoresis. Screening was conducted by applying a proper rinsing protocol developed by our group. The use of 0.1M EDTA in the rinsing solution successfully desorbs metal ions from the capillary wall. The mobility ratio was used to evaluate the precision of the method. Excellent precision for repeated runs was achieved for different protein metal ion interactions (RSD% of 0.05-1.0%). Run times were less than 6 min for all of the investigated interactions. The method has been successfully applied for the interaction study of Li(+), Na(+), Mg(2+), Ca(2+), Ba(2+), Al(3+), Ga(3+), La(3+), Pd(2+), Ir(3+), Ru(3+), Rh(3+), Pt(2+), Pt(4+), Os(3+), Au(3+), Au(+), Ag(+), Cu(1+), Cu(2+), Fe(2+), Fe(3+), Co(2+), Ni(2+), Cr(3+), V(3+), MoO4(2-) and SeO3(2-) with bovine serum albumin, ovalbumin, β-lactoglobulin and myoglobin. Different interaction values were obtained for most of the tested metal ions even for that in the same metal group. Results were discussed and compared in view of metal and semimetal group's interaction behavior with the tested proteins. The calculated normalized difference of mobility ratios for each protein-metal ion interaction and its sign (positive and negative) has been successfully used to detect the interaction and estimate further coordination of the bound metal ion, respectively. The comprehensive platform summarizes all the obtained interaction results, and is valuable for any future protein-metal ion investigation.

A comprehensive platform to investigate protein-metal ion interactions by affinity capillary electrophoresis.

Despite its importance and all the considerable efforts made, the progress in drug discovery is limited. One main reason for this is the partly questionable data quality. Models relating biological activity and structures and in silico predictions rely on precisely and accurately measured binding data. However, these data vary so strongly, such that only variations by orders of magnitude are considered as unreliable. This can certainly be improved considering the high analytical performance in pharmaceutical quality control. Thus the principles, properties and performances of biochemical and cell-based assays are revisited and evaluated. In the part of biochemical assays immunoassays, fluorescence assays, surface plasmon resonance, isothermal calorimetry, nuclear magnetic resonance and affinity capillary electrophoresis are discussed in details, in addition radiation-based ligand binding assays, mass spectrometry, atomic force microscopy and microscale thermophoresis are briefly evaluated. In addition, general sources of error, such as solvent, dilution, sample pretreatment and the quality of reagents and reference materials are discussed. Biochemical assays can be optimized to provide good accuracy and precision (e.g. percental relative standard deviation <10 %). Cell-based assays are often considered superior related to the biological significance, however, typically they cannot still be considered as really quantitative, in particular when results are compared over longer periods of time or between laboratories. A very careful choice of assays is therefore recommended. Strategies to further optimize assays are outlined, considering the evaluation and the decrease of the relevant error sources. Analytical performance and data quality are still advancing and will further advance the progress in drug development.

Data quality in drug discovery: the role of analytical performance in ligand binding assays.

To facilitate the implementation of affinity capillary electrophoresis into routine binding screening studies of proteins with metal ions, method acceleration, transfer and precision improvement were investigated. Affinity capillary electrophoresis was accelerated by using shorter capillaries, employing lower sample concentrations and smaller injection volumes. Intra- and inter-instrument method transfers were investigated considering the temperature setting of the capillary cooling system. For intra-instrument method transfer, similar results were obtained when transferring a method from a long (62 cm) to a short (31 cm) capillary. The analysis time was reduced from 9 to 4 min. In case of inter-instrument method transfer, interaction results showed small variation on the capillary electrophoresis instrument with inefficient capillary cooling system. Binding measurement precision was enhanced by slightly pushing the sample above the beginning of the capillary. Changing the buffer vials after each 30 runs and employing extra flushing after each 60 subsequent runs further enhanced the precision. The use of 0.1 molar ethylenediaminetetraacetic acid in the rinsing solution successfully desorbs the remaining metal ions from the capillary wall. Excellent precision for apparent mobility ratio measurements was achieved for different protein-metal ion interactions (relative standard deviation of 0.16-0.89%, 15 series, 12 runs for each). 

Optimization of affinity capillary electrophoresis for routine investigations of protein-metal ion interactions.

Strong, sequence-specific gas-phase bindings between proline-rich peptides and alkaline earth metal ions in nanoESI-MS experiments were reported by Lehmann et al. (Rapid Commun. Mass Spectrom. 2006, 20, 2404-2410), however its relevance for physiological-like aqueous phase is uncertain. Therefore, the complexes should also be studied in aqueous solution and the relevance of the MS method for binding studies be evaluated. A mobility shift ACE method was used for determining the binding between the small peptide GAPAGPLIVPY and various metal ions in aqueous solution. The findings were compared to the MS results and further explained using computational methods. While the MS data showed a strong alkaline earth ion binding, the ACE results showed nonsignificant binding. The proposed vacuum state complex also decomposed during a molecular dynamic simulation in aqueous solution. This study shows that the formed stable peptide-metal ion adducts in the gas phase by ESI-MS does not imply the existence of analogous adducts in the aqueous phase. Comparing peptide-metal ion interaction under the gaseous MS and aqueous ACE conditions showed huge difference in binding behavior. 

Ca(2+) -complex stability of GAPAGPLIVPY peptide in gas and aqueous phase, investigated by affinity capillary electrophoresis and molecular dynamics simulations and compared to mass spectrometric results.

Dehydrins are specialized proteins which are related to environmental stress tolerance in plants. The proteins can bind different metal ions and have versatile other functions such as reduction of reactive oxygen species and acting as transcription factor. The structure determination of proteins from this family is challenging, since they have a high number of disordered structure elements. Consequently, to determine the functionality of these proteins on a molecular basis a computed model is helpful. This work focuses on a model for the Arabidopsis thaliana dehydrin AtHIRD11. To develop a model which reflects experimental data from literature and own binding data from affinity capillary electrophoresis experiments, a more rigid state of this protein was chosen. The Cu-complex of this protein was formed and evaluated. The model explains some of the properties of the complexes. Possible Cu-bindings site were found and the change of conformations were investigated via molecular dynamics simulation. The AtHIRD11-Cu-complex is a first approach towards a complex model for a structural versatile protein, which is already sufficient to explain binding data and possible structure elements.

Markus Nachbar

Institute of Medicinal and Pharmaceutical Chemistry

TU Braunschweig

Analysis of AtHIRD11 Intrinsic Disorder and Binding Towards Metal Ions by Capillary Gel Electrophoresis and Affinity Capillary Electrophoresis