A Chronic Immobilization Stress Protocol for Inducing Depression-Like Behavior in Mice

Podsumowanie

This article provides a simplified and standardized protocol for induction of depressive-like behavior in chronically immobilized mice by using a restrainer. In addition, behavior and physiological techniques to verify induction of depression are explained.

Streszczenie

Depression is not yet fully understood, but various causative factors have been reported. Recently, the prevalence of depression has increased. However, therapeutic treatments for depression or research on depression is scarce. Thus, in the present paper, we propose a mouse model of depression induced by movement restriction. Chronic mild stress (CMS) is a well-known technique to induce depressive-like behavior. However, it necessitates a complex procedure consisting of a combination of various mild stresses. In contrast, chronic immobilization stress (CIS) is a readily accessible chronic stress model, modified from a restraint model that induces depressive behavior by restricting movement using a restrainer for a certain period. To evaluate the depressive-like behaviors, the sucrose preference test (SPT), the tail suspension test (TST), and the ELISA assay to measure stress marker corticosterone levels are combined in the present experiment. The described protocols illustrate the induction of CIS and evaluation of the changes in behavior and physiological factors for the validation of depression.

Wprowadzenie

Major depressive disorder (MDD) is the leading cause of mental disability worldwide, with an incidence that is increasing faster than anticipated. In 2001, the World Health Organization predicted that MDD would be the second most common disease in the world by 2020. However, it was already the second most common in 2013¹. In addition, current antidepressants have many limitations, including delayed effectivity, drug resistance, relapse, and various side effects^2,3. Researchers must therefore develop more effective antidepressants. However, the ambiguous pathophysiology of MDD presents an obstacle to the development of novel antidepressants.

Long-term stress is the main risk factor for MDD. It can induce dysfunction in the hypothalamic-pituitary-adrenal (HPA) axis, which is also related to MDD etiology^4,5. As described previously, the HPA axis plays a critical role in stress-induced psychiatric pathophysiology including depression and anxiety disorders by increasing corticosterone levels^6,7,8,9. Many animal models have been based on sustained activation of the HPA axis, which is observed in patients with MDD⁴. Moreover, high glucocorticoids induced by chronic stress and subcutaneously injected glucocorticoids cause depressive behaviors along with neural cell death, atrophy of neuronal processes, and reduced adult neurogenesis in the brain of rodents^10,11. Another important brain area associated with depression is the medial prefrontal cortex (mPFC). The mPFC plays a crucial role in controlling brain subregions, such as the hypothalamus and amygdala, that control emotional behavior and stress responses^8,9. For instance, lesions in the dorsal mPFC induced HPA axis dysfunction and enhanced corticosterone secretion due to restraint stress^12,13. A recent study also showed that repeated restraint stress increased corticosterone levels, which could be decreased by glutamine supplementation via glutamate-glutamine cycle between neurons and astrocyte in the mPFC⁹.

The first chronic stress paradigm used to study the etiology of MDD was suggested by Katz¹⁴. Willner et al. then proposed a chronic mild stress (CMS) model based on the findings of Katz. They confirmed that the model had predictive validity by observing that antidepressants restored CMS-induced anhedonic-like behavior^15,16. Typically, the CMS model consists of a combination of various mild stresses, such as mild noise, cage tilting, wet bedding, altered light-dark cycles, cage shaking, forced swimming, and social defeat. The CMS model is widely utilized by researchers; however, this model is of poor replicability, and time- and energy-inefficient. Therefore, there is a growing demand for a standardized and simplified protocol for induction of depressive-like behavior and physiological analysis to evaluate depression. Compared to the CMS model, the chronic immobilization stress (CIS; also known as chronic restraint stress) model is simpler and more efficient; therefore, the CIS model can be widely used in chronic stress studies^{17,18,19,20,21,22,23,24}. In addition, CIS can be used in both male and female mice to develop depressive behaviors^25,26. During CIS, animals are placed in a body-fit sized cylinder for 1-8 hours per day for 2 or 4 weeks^9,27,28. Of these, restraint stress condition for 2 hours per day for 2 weeks is sufficient to cause depressive behaviors with minimal pain in mice^9,28. Under restraint conditions, blood corticosterone levels were rapidly increased^9,28,29. Several studies have shown that the CIS model has predictive validity, confirming that CIS-induced depressive-like symptoms are restored by antidepressants^19,20,30,31. Herein, we report the detailed procedures of CIS, as well as some behavioral and physiological outcomes after CIS in mice.

Access restricted. Please log in or start a trial to view this content.

Protokół

All experimental protocols and animal care were conducted according to the guidelines of the University Animal Care Committee for Animal Research of Gyeongsang National University (GLA-100917-M0093).

1. Materials

1. Mice
   1. Use males of C57BL/6 strain background weighing 22–24 g at postnatal week 7. Habituate in the breeding room for 1 week before the experiments.
      NOTE: All mice were purchased from a laboratory animal company.
   2. House mice individually in a temperature-controlled vivarium (22–24 °C) under a 12-hour light/dark cycle (lights on at 6:00 A.M.), with normal laboratory chow and water available ad libitum.
2. Restrainer
   1. Use a cylindrical, transparent, acrylic tank (height = 8.5 cm, diameter = 2.5 cm) fixed on a square pedestal to restrain and to produce depressive behavior (Figure 1A). The diameter of this cylinder was made to fit the body so that the mouse could not turn and move forwards or backwards. The restrainer can be purchased commercially or made in the lab.
3. Tail suspension apparatus
   1. Use a reasonable size tail suspension box made of translucent acrylic (height = 30 cm, width = 20 cm, length = 20, Figure 1B). To prevent interactions between the animals, use rectangular partitions within the box so that the floor and three of the four walls are blocked by acrylic plates. Leave the remaining two sides of the box open to allow video recording and to fix the horizontal bar. The box can be purchased commercially or made in the lab.
4. Video recording device and video tracking software
   1. Use a black and white-display closed-circuit television camera (see Table of Materials) connected to a computer and a tripod (or other support products) to allow recording of the behavioral experiment. Video recording is essential to allow behavioral scoring in this experiment, because at least two mice are tested at the same time.
   2. Ensure that the camera resolution is high enough to allow the video data to be analyzed using the video tracking software (see Table of Materials) installed in the connected computer.

2. Induction of depression by CIS restraint

NOTE: Handle the mouse gently, but firmly with confidence. Both rough and tentative handling is another stress factor in the experiment and it is an important reason for the mouse struggling, biting, and scratching.

1. Set the room light to light (200 Lux) conditions using a digital lux meter.
2. House the mouse in a separate cage at least a week before testing and place the mouse in the testing room for at least 30 min before the experiment.
   NOTE: Handle the mice at least once a day for at least 3 consecutive days before the experiment so that the mice become familiar with the experimenter. An adaptational period before the experiment is necessary to ensure that the mice acclimatize to the circumstance, such as the testing room.
3. Gently hold the mouse tail to avoid tensing the mouse, and then carefully place it on a rough surface (top of wire bar of the cage or cage lid).
4. Cover the restrainer with a small white towel, and then gently place the mouse at the opening of the restrainer so that the mouse enters the restrainer voluntarily.
   NOTE: In this case, the mouse is positioned in the opposite direction to that which it enters the restrainer with. To lead the mouse to enter the restrainer voluntarily, the restrainer is covered with a small towel to make the inside darker.
5. Place the closure to restrain the mouse as tight as possible, being careful to avoid damage to the body, such as tail, feet, and testicles.
6. Restrain the mouse for 2 h/day (9:00 A.M. to 11:00 A.M.) for 15 consecutive days.
7. Measure body weight and food intake every 48 h during exposure to the restrainer (i.e., food intake quantity during the 48 h before the initiation of the movement restraint).
   NOTE: When measuring body weight and food intake, place control mice in their home cages in the testing room during CIS. Ensure that other environmental factors are the same as for the CIS mice.
8. Confirm the induction of depression by performing behavioral tests such as the sucrose preference test (SPT) and the tail suspension test (TST) (refer to steps 4 and 5).
9. Confirm the induction of depression by measuring the stress marker corticosterone using ELISA assay (refer to section 6).

3. The sucrose preference test

1. Before testing, habituate the mice to the presence of two drinking bottles (one containing 0.1 M sucrose and the other containing plain water) for 48 h. Switch the positions of the two bottles after 24 h to reduce any confounding produced by a side bias.
2. On the 3^rd day, deprive the mice of water for 24 h.
3. On the day of the SPT experiment, expose the mice to two drinking bottles for 6 h. After 3 h, switch the position of the water bottles.
4. Record the volume (mL) of sucrose solution and water consumed and then calculate the animals’ affinity to sucrose.
5. Generally, calculate sucrose preference as a percentage of the volume of sucrose consumption over the total fluid consumption during the test.

4. The tail suspension test

1. Bring the CIS-induced mice into the testing room at least 30 min before beginning the TST.
2. Set the room light to dim (50 Lux) conditions.
3. To obtain the highest resolution video file, place the camera as close to the mouse as possible (around 40 cm from the mouse).
4. Suspend the mouse firmly from the horizontal bar (30 cm from the bottom line) using cellophane adhesive tape (the distance from the tip of the tail is 1 cm). Complete the process of applying tape to the mouse as soon as possible to minimize other sources of stress.
5. Once the mouse is positioned in the middle of suspension box, start recording and observe the behavioral alterations continuously for 6 min.
   NOTE: If the mouse attempts to climb its tail, use a stick or climb stopper to prevent it from doing so.
6. At the end of the experiment, move the mouse to its home cage and carefully remove the tape from its tail.
7. Analyze the accumulated time of immobile periods using the video tracking software.
   NOTE: The duration of immobility is the most important CIS parameter. This can be calculated as the accumulated time of immobile periods, defined in terms of a motion threshold contained within the level-filtering device of the software.

5. Measuring corticosterone levels in blood by ELISA

NOTE: A day after the behavioral test, the mice are sacrificed for blood collecting.

1. Anesthetize the mouse with 5% isoflurane in an induction chamber until anesthesia. Ensure the mouse has sufficient time in the induction chamber (at least 2 min) to prevent waking up during surgery.
2. Collect blood from the heart using a 1 mL syringe, and store the blood in vacutainers containing K₃EDTA on the ice (at 9 A.M.)
3. Separate plasma by centrifugation at 1,000 × g for 15 min at 4 °C.
4. Quantify plasma corticosterone levels using the corticosterone ELISA kit (see Table of Materials) according to the manufacturer's protocol.

Access restricted. Please log in or start a trial to view this content.

Wyniki

In the representative experiment, all data were acquired from 6 - 8 mice per group. Representative materials and the method to insert the mouse voluntarily into the restrainer are shown in Figure 1.

To perform the behavioral test and blood sampling after CIS induction, mice were subjected to the experimental procedure as summarized in Figure 2A. As shown in Figure 2 and Figure 3

Access restricted. Please log in or start a trial to view this content.

Dyskusje

The complexity of the brain and heterogeneity of MDD make it challenging to create animal models that completely reproduce the condition. Many researchers have overcome this difficulty using an endophenotype-based approach³², in which anhedonia (lack of interest in rewarding stimuli) and despair are considered evolutionarily conserved and quantifiable behaviors in animal models, which are also seen in patients with depression³³. In the present paper, we have presented a met...

Access restricted. Please log in or start a trial to view this content.

Materiały

Name	Company	Catalog Number	Comments
1 ml disposable syringes	Sungshim Medical	P000CFDO
Balance	A&D Company	FX-2000i
Ball nozzle	Jeung Do B&P	JD-C-88
CCTV camera	KOCOM	KCB-381
Corticosterone ELISA kits	Cayman Chemical
Digital lux meter	TES	TES-1330A
Ethovision XT 7.1	Noldus Information Technology
Isoflurane	HANA PHARM CO., LTD.		Ifran solution
Mice	Koatech		C57BL/6 strain
Restrainer	Dae-jong Instrument Industry	DJ-428
Saccharose (sucrose)	DAEJUNG	7501-4400
Small animal isoflurane anaesthetic system	Summit
Acrylic bar			The apparatus was made in the lab for TST test
Tail suspension box			The apparatus was made in the lab
Timer	Electronics Tomorrow	TL-2530
Water bottle	Jeung Do B&P	JD-C-79