One-Step Approach to Fabricating Polydimethylsiloxane Microfluidic Channels of Different Geometric Sections by Sequential Wet Etching Processes
9.7K Views
•
08:31 min
•
September 13th, 2018
DOI :
September 13th, 2018
•Chapters in this video
0:04
Title
1:12
Fabrication of Polydimethylsiloxane (PDMS) Channel Layouts
3:20
Experimental Characterization of PDMS Wet Etching
4:36
PDMS Sequential Wet Etching for Microfluidic Channels of a Cross-shaped Cross-section
5:50
Fabrication and Characterization of a Microfluidic Mixer with Different Channel Sections
7:08
Results: Fabrication of Microfluidic Channels with Different Geometric Sections
7:49
Conclusion
Related Videos
Fabricating Metamaterials Using the Fiber Drawing Method
13.7K Views
Simulation of the Planetary Interior Differentiation Processes in the Laboratory
11.5K Views
Knowledge Based Cloud FE Simulation of Sheet Metal Forming Processes
12.0K Views
Electrochemical Etching and Characterization of Sharp Field Emission Points for Electron Impact Ionization
9.4K Views
Wicking Tests for Unidirectional Fabrics: Measurements of Capillary Parameters to Evaluate Capillary Pressure in Liquid Composite Molding Processes
8.7K Views
Microfluidic Imaging Flow Cytometry by Asymmetric-detection Time-stretch Optical Microscopy (ATOM)
10.2K Views
A Pipette-Tip Based Method for Seeding Cells to Droplet Microfluidic Platforms
11.1K Views
Nerve Stem Cell Differentiation by a One-step Cold Atmospheric Plasma Treatment In Vitro
7.3K Views
Drawing and Hydrophobicity-patterning Long Polydimethylsiloxane Silicone Filaments
8.8K Views
Fabricating van der Waals Heterostructures with Precise Rotational Alignment
9.3K Views
Copyright © 2025 MyJoVE Corporation. All rights reserved