Anterior Capsular Reconstruction with Human Dermal Allograft for Irreparable Subscapularis Tears

Résumé

This article details an open anterior capsular reconstruction technique using human dermal allograft for irreparable subscapularis tears, providing structural support and enhancing functional outcomes through precise graft fixation and rehabilitation.

Résumé

Anterior capsular reconstruction (ACR) using human dermal allograft (HDA) is an innovative surgical technique for managing irreparable subscapularis (SSc) tears. This procedure begins with patient positioning in the beach-chair configuration under general anesthesia, combined with an interscalene block for postoperative pain control. A deltopectoral approach is utilized, with an 8-10 cm incision extending from the coracoid tip to the deltoid tuberosity. After identifying and retracting the deltopectoral interval, the anterior glenoid is prepared by decorticating the bone surface to promote graft integration. Two suture anchors are placed at the 2- and 4-o'clock positions of the anterior glenoid. The HDA, measuring 50 mm × 40 mm and 3-4 mm in thickness, is folded into a double-layer configuration or used as a single layer based on the patient's requirements. The graft is secured with sutures to the glenoid anchors, with the arm positioned in neutral flexion, 30° abduction, and 30° external rotation for optimal tensioning. Additional fixation to the lesser tuberosity is achieved using a double-row suture bridge technique with anchors. For cases with a viable but retracted SSc tendon, augmentation over the graft is performed. Postoperative immobilization in an abduction brace is maintained for 6 weeks, followed by gradual rehabilitation. The precise graft fixation, tensioning, and structural support provided by this technique make ACR with HDA a valuable alternative to tendon transfers, preserving native shoulder biomechanics and offering a viable non-arthroplasty solution for severe anterior capsular deficiency.

Introduction

The subscapularis (SSc) is a critical component of the rotator cuff, responsible for maintaining shoulder stability, facilitating internal rotation, and acting as a restraint against anterior instability¹. Damage or irreparable tears to the SSc can lead to significant pain, dysfunction, and progressive shoulder instability, often culminating in cuff tear arthropathy². While surgical techniques such as tendon transfers are widely utilized to address these tears, they come with inherent limitations. Tendon transfers, including pectoralis major transfer, latissimus dorsi transfer, and latissimus dorsi with teres major transfers, are biomechanically non-anatomic and often fail to restore native shoulder kinematics, leading to high failure rates and complications^3,4,5,6.

Anterior capsular reconstruction (ACR) with allograft has emerged as a promising alternative for managing irreparable SSc tears^5,7. This technique offers a biomechanically anatomic solution by recreating the anterior capsule without compromising future surgical options⁸. It preserves shoulder biomechanics, providing a stable and functional joint environment⁸. The success of ACR has been inspired by the principles of superior capsule reconstruction, which have demonstrated improved outcomes in restoring shoulder stability in other rotator cuff pathologies⁹.

On the other hand, numerous studies have highlighted the effectiveness of human dermal allografts as augmentation in rotator cuff repair, with their clinical benefits also well-documented in superior capsular reconstruction^9,10,11.

This technical note provides a comprehensive overview of the ACR technique using human dermal allografts to address irreparable SSc tears. By focusing on this specific technique, we aim to guide surgeons through the essential steps and considerations for successful ACR, emphasizing procedural nuances and the potential for improved clinical outcomes. This approach seeks to optimize functional recovery and pain relief for patients with severe SSc damage, offering a viable solution for those with limited treatment options.

Protocole

The protocol follows the guidelines of our institution's human research ethics committee.

1. Patient positioning and preparation

1. Position the patient in a beach-chair configuration (Table of Materials) under general anesthesia to ensure optimal access to the shoulder joint.
2. Administer an interscalene block for postoperative pain management.
   NOTE: An interscalene block is performed by the anesthesiologist injecting a local anesthetic near the brachial plexus at the level of the anterior and middle scalene muscles. The procedure is guided by ultrasound to ensure accurate placement, providing targeted nerve blockades for shoulder and upper arm surgeries.
3. Prepare the surgical site using a standard sterile draping technique to expose the anterior shoulder region.

2. Surgical technique

1. Approach and exposure
   1. Make an 8-10 cm deltopectoral incision, starting at the coracoid tip and extending distally toward the deltoid tuberosity (Figure 1).
   2. Identify the deltopectoral interval and retract the cephalic vein medially or laterally to protect it from damage.
   3. Incise the clavicopectoral fascia using electrosurgical pencils to expose the anterior joint capsule (Figure 2).
   4. Use retractors to maintain a clear surgical field and minimize trauma to surrounding structures (Figure 3).
2. Subscapularis assessment and preparation
   1. Use a curette to create a bleeding bone surface on the humeral lesser tuberosity to enhance allograft integration (Figure 4).
   2. Mobilize the SSc tendon with sharp and blunt dissection to release adhesions.
   3. Visually evaluate the feasibility of a tension-free repair by assessing tendon quality and retraction.
   4. Proceed with anterior capsular reconstruction⁵ if the tendon is severely retracted or of poor quality.
3. Glenoid preparation
   1. Insert a Fukuda retractor (Table of Materials) to improve the visibility of the glenoid (Figure 5).
   2. Decorticate the anterior glenoid surface at the 2- and 4-o'clock positions using a periosteal elevator, rasp, and curette to create a bleeding bone surface.
   3. Place two suture anchors (Table of Materials) at the prepared glenoid site for stable graft fixation (Figure 6).
4. Graft preparation
   1. Select a human dermal allograft (Table of Materials) measuring approximately 50 mm × 40 mm and 3-4 mm thick.
   2. If additional thickness is required, fold the graft in half to create a double-layer construct. Folding is optional and at the surgeon's discretion.
   3. Reinforce the edges of the graft with 1-0 silk sutures for stability and ease of handling during fixation (Figure 7).
5. Graft fixation
   1. Place two additional suture anchors (Table of Materials) into the humeral lesser tuberosity to secure the graft (Figure 8).
   2. Thread sutures from the glenoid anchors through the graft and secure it to the anterior glenoid with firm knotting (Figure 9 and Figure 10).
      NOTE: In this illustrated case, the graft is not folded to increase its thickness. However, depending on the surgeon's preference, the graft can be folded to create a thicker construct.
   3. Position the arm in neutral flexion with 30° of abduction and 30° of external rotation to ensure proper tensioning of the reconstructed capsule.
   4. Use sutures from the humeral lesser tuberosity anchors (Table of Materials) to pass through the graft (Figure 11). Secure the graft to the humeral side using a double-row suture bridge technique (Figure 12).
6. Completion and augmentation
   1. If the SSc tendon stump is retracted but viable, suture it over the graft to augment the reconstruction.
   2. Close the rotator interval (Figure 13) and inferior capsule (Figure 14) using adjacent tissue sutures to restore the native soft tissue envelope.

3. Postoperative rehabilitation

NOTE: First-generation cephalosporins were administered as antibiotics until postoperative day 1. For pain management, NSAIDs were provided alongside opioids on a PRN basis. Opioids were administered when the postoperative pain visual analog scale (VAS) score exceeded 7.

1. Immobilization phase
   1. Immobilize the shoulder in an abduction brace for 6 weeks to protect the reconstruction and facilitate initial healing.
   2. Initiate passive range-of-motion of forward flexion exercises during this period to prevent stiffness and maintain joint mobility without compromising graft fixation.
2. Early rehabilitation phase
   1. At 6 weeks, begin a gradual rehabilitation program emphasizing passive and active-assisted range-of-motion exercises.
   2. Limit external rotation to 30° initially to avoid excessive stress on the graft.
3. Strengthening phase
   1. Introduce isometric strengthening exercises at three months to rebuild muscle strength gradually.
   2. Progress to full active range of motion and advanced strengthening exercises by six months.
4. Return to activity
   1. Gradually transition patients to daily activities and athletic pursuits after achieving adequate strength and stability.

Résultats

This retrospective study⁵ was conducted with institutional review board approval patients who underwent open ACR with human dermal allograft for irreparable SSc tears between August 2020 and January 2022.

A total of 18 patients (mean age: 63.7 years) underwent open anterior capsular reconstruction (ACR) using human dermal allografts for irreparable subscapularis (SSc) tears, with a mean follow-up of 17 months. Inclusion criteria included Yoo-Rhee type 4 or 5 tears, Gout...

Discussion

The success of ACR with human dermal allograft is contingent upon meticulous surgical technique and adherence to key procedural steps. Accurate preparation of the anterior glenoid and the lesser tuberosity of the humerus is crucial to achieve optimal fixation and facilitate graft integration. Proper tensioning of the reconstructed capsule is equally critical and is accomplished by positioning the arm in neutral flexion with 30° of abduction and 30° external rotation during the procedure. Postoperative rehabilit...

matériels

Name	Company	Catalog Number	Comments
Lift-Assist Beach Chair Positioner	Arthrex, Naples, FL, USA	AR-1627	Surgical bed
Universal Head Positioner	Arthrex, Naples, FL, USA	AR-1627-05	Head holder
SPIDER2	Smith & Nephew, Watford, UK	72203299	Pneumatic arm holder
HEALICOIL	Smith & Nephew, Watford, UK	72203707	Anchors for glenoid
Hi-Fi Tape	CONMED, Utica, NY, USA	YRC03	Anchors for humerus, medial row
CrossFT	CONMED, Utica, NY, USA	CFK-55DT	Anchors for humerus,
Knotless DT	CONMED, Utica, NY, USA	CFK-55DT	lateral row
Electrosurgical Pencils	CONMED, Utica, NY, USA	131307A	Electrocauterization
BellaCell HD	Hans, Daejeon, Korea	Not applicable	Human dermal allografts
Modified Fukuda-type Retractor	Innomed, Savannah, GA, USA	1930	Retractor for optimizing the surgical view of the glenoid