Transport Properties of Ibuprofen Encapsulated in Cyclodextrin Nanosponge Hydrogels: A Proton HR-MAS NMR Spectroscopy Study

The chemical cross-linking of &#946;-cyclodextrin (&#946;-CD) with ethylenediaminetetraacetic dianhydride (EDTA) led to branched polymers referred to as ...

Politecnico di Milano

In contrast to most pharmaceutical agents, the major anticoagulant agent, heparin, lacks a uniquely defined chemical structure. It is an inherently structurally varying, poly-disperse polymer, rendering quality control problematic. Structural modifications introduced during manufacture and the presence of possible contaminants are dangers. The comparison of any heparin test sample to a library of bona fide, but intrinsically variable heparins, is limited fundamentally to measuring the degree of similarity between them. A general approach for constructing a suitable illustrative heparin library employing (1)H NMR and multivariate analysis, is proposed and examples shown. Heparin samples contaminated with non-N-acetylated, persulfated, non-glycosaminoglycan carbohydrates (10%) were detected, some of which would not be easily detected under current regulatory guidelines. The ability to identify contaminated heparin is fundamentally dependent on the contents of the library, which should contain all the 'normal' variability within 'heparin'. Oversulfated chondroitin sulfate can be detected (∼5%) (using components 1 and 2, but is detectable at 3% using additional components, e.g. 1 and 5) analysing the full spectrum and at <1% if only the N-acetyl region is used. Signals arising from oxidation during the manufacturing processes can also be found. The design, properties and limitations of this approach are discussed. Assembly of such a library of market heparin can be termed the 'Current Statistical Definition of Heparin' (CSDH) and will form the basis of future quantitative methods.

Construction and use of a library of bona fide heparins employing 1H NMR and multivariate analysis.

The first use of statistical correlation spectroscopy to extract chemical information from 2D-HSQC spectra, termed HSQC correlation spectroscopy (HSQCcos), is reported. HSQCcos is illustrated using heparin, a heterogeneous polysaccharide, whose diverse composition causes signals in HSQC spectra to disperse. HSQCcos has been used to probe the chain modifications that cause this effect and reveals hitherto unreported structural details. An interesting finding was that the signal for position 2 of trisulfated glucosamine [N-, 3-O-, and 6-O-sulfated] (A*) is bifurcated, owing to the presence of A* residues in both the "normal" antithrombin binding site and also at the nonreducing end of the molecule, which is reported in intact heparin for the first time. The method was also applied to investigating the environment around other rare sequences/disaccharides, suggesting that the disaccharide; 2-O-sulfated iduronic acid linked to 6-O-sulfated N-glucosamine, which contains a free amine at position 2, is adjacent to the heparin linkage region. HSQCcos can extract chemically related signals from information-rich spectra obtained from complex mixtures such as heparin.

Unravelling structural information from complex mixtures utilizing correlation spectroscopy applied to HSQC spectra.

A new hyper-branched water-soluble polymer was synthesized by reacting β-cyclodextrin with pyromellitic dianhydride beyond the critical conditions that allow the phenomenon of gelation to occur. The molar ratio between the monomers is a crucial parameter that rules the gelation process. Nevertheless, the concentration of monomers in the solvent phase plays a key role as well. Hyper-branched β-cyclodextrin-based polymers were obtained performing the syntheses with excess of solvent and cross-linking agent, and the conditions for critical dilution were determined experimentally. A hyper-branched polymer with very high water solubility was obtained and fully characterized both as for its chemical structure and for its capability to encapsulate substances. Fluorescein was used as probe molecule to test the complexation properties of the new material.

Synthesis and characterization of a hyper-branched water-soluble β-cyclodextrin polymer.

Ibuprofen sodium salt (IP) was encapsulated in cyclodextrin nanosponges (CDNS) obtained by cross-linking of β-cyclodextrin with ethylenediaminetetraacetic acid dianhydride (EDTAn) in two different preparations: CDNSEDTA 1:4 and 1:8, where the 1:n notation indicates the CD to EDTAn molar ratio. The entrapment of IP was achieved by swelling the two polymers with a 0.27 M solution of IP in D2O, leading to colourless, homogeneous hydrogels loaded with IP. The molecular environment and the transport properties of IP in the hydrogels were studied by high resolution magic angle spinning (HRMAS) NMR spectroscopy. The mean square displacement (MSD) of IP in the gels was obtained by a pulsed field gradient spin echo (PGSE) NMR pulse sequence at different observation times t d. The MSD is proportional to the observation time elevated to a scaling factor α. The α values define the normal Gaussian random motion (α = 1), or the anomalous diffusion (α < 1, subdiffusion, α > 1 superdiffusion). The experimental data here reported point out that IP undergoes subdiffusive regime in CDNSEDTA 1:4, while a slightly superdiffusive behaviour is observed in CDNSEDTA 1:8. The transition between the two dynamic regimes is triggered by the polymer structure. CDNSEDTA 1:4 is characterized by a nanoporous structure able to induce confinement effects on IP, thus causing subdiffusive random motion. CDNSEDTA 1:8 is characterized not only by nanopores, but also by dangling EDTA groups ending with ionized COO(-) groups. The negative potential provided by such groups to the polymer backbone is responsible for the acceleration effects on the IP anion thus leading to the superdiffusive behaviour observed. These results point out that HRMAS NMR spectroscopy is a powerful direct method for the assessment of the transport properties of a drug encapsulated in polymeric scaffolds. The diffusion properties of IP in CDNS can be modulated by suitable polymer synthesis; this finding opens the possibility to design suitable systems for drug delivery with predictable and desired drug release properties.

Anomalous diffusion of Ibuprofen in cyclodextrin nanosponge hydrogels: an HRMAS NMR study.

In drug-delivery systems, drug transport is a key step, but the interpretation of the transport mechanism is still controversial. Here, we investigated a promising hydrogel library loaded with the anticonvulsant drug ethosuximide (ESM). The self-diffusion coefficient of ESM was measured using two methods: a direct and advanced measurement with a pulsed field gradient spin-echo (PFGSE) method, using an NMR spectrometer equipped with high-resolution magic angle spinning (HR-MAS) probe, and an indirect one based on fitting in vitro drug-delivery data. Starting from the experimental data a mathematical model without fitted parameters was developed and all the phenomena involved, that is, adsorption and diffusion, were considered. At low drug concentrations, adsorption prevails and consequently the diffusivity in the gels is lower than that in water. At high drug concentrations, where all adsorption sites are saturated, the diffusion in the gels is similar to that in a water solution. This study may pave the way for better device design.

Drug-Polymer Interactions in Hydrogel-based Drug-Delivery Systems: An Experimental and Theoretical Study.

The polymerization of partially methylated β-cyclodextrin (CRYSMEB) with epichlorohydrin was carried out in the presence of a known amount of toluene as imprinting agent. Three different preparations (D1, D2 and D3) of imprinted polymers were obtained and characterized by solid-state (13)C NMR spectroscopy under cross-polarization magic angle spinning (CP-MAS) conditions. The polymers were prepared by using the same synthetic conditions but with different molar ratios of imprinting agent/monomer, leading to morphologically equivalent materials but with different absorption properties. The main purpose of the work was to find a suitable spectroscopic descriptor accounting for the different imprinting process in three homogeneous polymeric networks. The polymers were characterized by studying the kinetics of the cross-polarization process. This approach is based on variable contact time CP-MAS spectra, referred to as VCP-MAS. The analysis of the VCP-MAS spectra provided two relaxation parameters: T CH (the CP time constant) and T 1ρ (the proton spin-lattice relaxation time in the rotating frame). The results and the analysis presented in the paper pointed out that T CH is sensitive to the imprinting process, showing variations related to the toluene/cyclodextrin molar ratio used for the preparation of the materials. Conversely, the observed values of T 1ρ did not show dramatic variations with the imprinting protocol, but rather confirmed that the three polymers are morphologically similar. Thus the combined use of T CH and T 1ρ can be helpful for the characterization and fine tuning of imprinted polymeric matrices.

Polydisperse methyl β-cyclodextrin-epichlorohydrin polymers: variable contact time (13)C CP-MAS solid-state NMR characterization.

To address the increasing need for improved tissue substitutes, tissue engineering seeks to create synthetic, three-dimensional scaffolds made from polymeric materials able to incorporate cells and drugs. The interpretation of transport phenomena is a key step, but comprehensive theoretical data is still missing and many issues related to these systems are still unsolved. In particular, the contribution of solute-solute interactions is not yet completely understood. Here, we investigate a promising agar-carbomer (AC) hydrogel loaded with sodium fluorescein (SF), a commonly used drug mimetic. The self-diffusion coefficient of SF in AC formulations was measured by using high resolution magic angle spinning NMR spectroscopy (HR-MAS NMR). Starting from experimental data, a complete overview on SF transport properties is provided, in particular a mathematical model that describes and rationalizes the differences between gel and water environments is developed and presented. The hydrogel molecular environment is able to prevent SF aggregation, owing to the adsorption mechanism that reduces the number of monomers available for oligomer formation at low solute concentration. Then, when all adsorption sites are saturated free SF molecules are able to aggregate and form oligomers. The model predictions satisfactorily match with experimental data obtained in water and the gel environment, thus indicating that the model presented here, despite its simplicity, is able to describe the key phenomena governing device behavior and could be used to rationalize experimental activity.

Monica Ferro

Department of Chemistry,
Materials and Chemical Engineering "G. Natta",
Department of Chemistry, Materials and Chemical Engineering "G. Natta"

Politecnico di Milano

Transport Properties of Ibuprofen Encapsulated in Cyclodextrin Nanosponge Hydrogels: A Proton HR-MAS NMR Spectroscopy Study

Monica Ferro

.css-o250i3{font-size:18px;font-family:Open Sans,sans-serif;line-height:21.6px;}Department of Chemistry,Materials and Chemical Engineering "G. Natta",Department of Chemistry, Materials and Chemical Engineering "G. Natta"

Politecnico di Milano

Transport Properties of Ibuprofen Encapsulated in Cyclodextrin Nanosponge Hydrogels: A Proton HR-MAS NMR Spectroscopy Study

Department of Chemistry,
Materials and Chemical Engineering "G. Natta",
Department of Chemistry, Materials and Chemical Engineering "G. Natta"