Combined Endoscopic and Transoral Approach for Total Maxillectomy

Abstract

The technique of maxillectomy has been revised since it was first described in the 1820s. During the past decade, the endoscopic approach has been widely practiced for resecting maxilla. Compared with the traditional approaches, the combined endoscopic and transoral approach has many advantages such as avoiding facial incisions and postoperative scars and better visualization of the surgical margin. However, this technique is complicated to master and possess several challenges. Here, we demonstrate this approach step-by-step to show how to perform a total maxillectomy. We also reported nine cases with malignant tumors originating from the maxilla, and for all of them total maxillectomy was performed with combined endoscopic and transoral approach. Our data showed that the combination of the endoscopic and transoral approach could be used to resect the total maxilla successfully, though the tumor extended to the infratemporal and pterygopalatine fossa should be treated very carefully to avoid its spread in the local area. Furthermore, besides denture, other reconstruction methods should be attempted to improve the postoperative quality of life after the total maxillectomy.

Introduction

The squamous cell carcinoma from the maxillary sinus reports the highest incidence among the tumor developments within the sinonasal compartment¹. Besides squamous cell carcinoma, the pathological patterns of maxillary tumors also include various histological types, such as adenocarcinomas, melanoma, and esthesioneuroblastoma, etc.². Since the symptoms in the early phases are dormant and nonspecific, most of the patients diagnosed with malignant tumor originating from the maxilla are in an advanced stage during the time of diagnosis. This makes the maxillary malignant tumors one of the worst in comparison with other head and neck tumors.

The therapeutics options for the patients with malignant tumors involves maxilla surgeries combined with radiotherapies, and in some cases chemotherapies^3,4,5. Many approaches of maxillectomy have been developed to resect the maxilla since it was first demonstrated in 1826⁶. Recently, the maxillectomy can be divided into an approach with and without a skin incision. Among these approaches, lateral rhinotomy and midfacial degloving are still practiced in total maxillectomy. However, the drawbacks of these procedures include leaving a facial scar, and difficulties in treating the lesion located at or beyond the posterior margin of the maxilla due to the restricted field of visualization, limited working space, and significant bleeding of these areas⁷. Compared to these traditional approaches. A combined endoscopic and transoral approach has been presented for total maxillectomy without facial incision^8,9. This approach, taking advantage of the better visualization of the endoscopy, might lead to the better magnification of the operative field, especially for the surgical margins, resulting in potentially similar scales of resection but with less morbidity⁸. In addition, no facial scars are left with this approach, which might accelerate its application for the total maxillectomy in the future. However, the technique is complicated to master and possesses several challenges. Therefore, we present a step-by-step visual protocol of a combined endoscopic and transoral approach, which may help in shortening the learning curve of this approach.

Protocol

This procedure was approved by the Institutional Review Board of the Eye and ENT Hospital, Fudan University, China. A written informed consent was obtained from all the enrolled patients.

1. Preparation for the surgery

1. Before the surgery, examine the patients with anterior rhinoscopy, 4 mm endoscopy, computed tomography (CT), and Magnetic Resonance Imaging (MRI) scans to confirm the maxillary bone was invaded by the tumor and that a total maxillectomy is required. Make the surgical plan based on the location of the tumor.
2. On the day of the operation, place the patient on the operating table and then give general anesthesia. Place the anesthesia intubation into the mouth on the opposite side of the tumor to facilitate to perform the following transoral approach.
3. Tilt the operating table to a 30° angle (to the dorsal elevated position) and place the patient's head in a neutral position (neither flexed nor extended).
4. Soak the gauze piece with iodine, then sterilize the gingivobuccal sulcus with the gauze piece.

2. Surgical procedure

1. Soak 8 gauzes (6 cm x 60 cm) in a mixture of 20 mL of 1% tetracaine and 4 mL of 0.1% adrenaline. To shrink the nasal mucosa, put several pieces of soaked gauze into each nasal cavity for 5 min.
2. Cut off the middle turbinate and then perform a routine ethmoidectomy and sphenoidectomy. Widen the osteum of the frontal and maxillary sinuses on the side of the lesion by the quadcut and curved sinus blades powered by the dynamic planning system.
   NOTE: To reduce bleeding, the above-mentioned procedures could also be carried out with plasma.
3. Cut off the inferior turbinate and remove the mucosa layer on the lateral wall of the nasal cavity with the mayo scissors and the plasma.
4. Drill the frontal process and the lacrimal bone with the trans-nasal skull base bur and expose the naso-lacrimal duct and lacrimal sac. Then, cut off the naso-lacrimal duct and perform the lacrimal sac incision with the blade and make sure that the mucosal flaps are laid out on the lateral nasal wall.
5. Wipe off the medial wall of the maxilla with the trans-nasal skull base bur from the level of maxillary palatal process inferiorly, to the level of inferior wall of orbit superiorly, to the piriform aperture forwardly, and to the palate bone posteriorly.
6. Remove the perpendicular plate of the palatine bone from the medial side to the lateral side with the trans-nasal skull base bur. Expose the palatine canal and cauterize the greater and lesser palatine arteries with the monopolar electrocoagulation.
   NOTE: In this step, the conchal crest can be used as a landmark to differentiate the perpendicular plate of the palatine bone and the medial pterygoid plate.
7. Locate the sphenopalatine foramen, which is posterior to the ethmoidal crest. Introduce the Kerrison punch into the foramen and remove the posterior wall of the maxillary sinus anterior to the pterygopalatine fossa.
8. Use a needle connected to a 5 mL syringe to immerse the gingival buccal groove in several milliliters of a mixed solution of 20 mL of 0.9% NaCl and 0.05 mL of 0.1% adrenaline in the subperiosteal planes on the side of the tumor from the level of the central incisor to the level of the third ipsilateral molar.
9. Make the incision in the gingivobuccal sulcus with the blade or the monopolar electrocoagulation; start from the central incisor to the third ipsilateral molar (Figure 1A).
10. Dissect of the soft tissues subperiosteally with the suction elevator, electrocoagulation, and plasma along the anterior wall of the maxillary sinus until the infraorbital rim is exposed (Figure 1B).
    NOTE: The infraorbital nerve should be preserved if it was not involved by the malignancy. Whether the infraorbital nerve was involved in the tumor was identified based on the MRI and CT scan pre-surgery and confirmed during the surgery.
11. Separate the soft tissue from the underneath bone to the pyriform aperture level medially, to the zygomaticomaxillary fissure level laterally, and to the mandibular tubercles posteriorly.
12. Retract and protect the facial soft tissue superiorly with the mastoid retractor. Wipe off the anterior wall of the maxilla with the trans-nasal skull base bur. Remove the residual bone of the piriform aperture.
    1. Try to keep the periostea and mucosa in the maxillary sinus intact when wiping off the anterior bony wall of the maxilla, which could reduce the bleeding. To achieve this goal, change the trans-nasal skull base bur to the carborundum drill at this step.
       ​NOTE: After wiping off the anterior bony wall of the maxilla, the periostea and mucosa will be seen under it. The periostea and mucosa should be very obvious, if it is not involved by the tumor.
13. Then, remove the posterior lateral wall of the maxillary sinus by the trans-nasal skull base bur and the carborundum drill. If the infratemporal fossa was not involved by the tumor, the periostea covering it should be kept intact in this step.
14. Medially, separate the connection of the vertical and the horizontal process of the palate bone by abrading the pyramidal process with the carborundum drill. Laterally, separate the maxillary tuberosity from the lateral pterygoid plate with the carborundum drill.
15. Use the carborundum drill to remove to the lateral and the malar process to remove the superior and the inferior orbital walls, respectively.
16. Pull out the ipsilateral central incisor. Make a hole between the soft palate and hard palate with the electricoagulation at the midline of the hard palate. Pull the fretsaw through the hole and make a sagittal incision along the hard palate from posterior to anterior (Figure 1C,D).
    NOTE: In this step, the upper lip should be retracted upward and carefully protected.
17. Separate the hard palate from the soft palate with the Metzenbaum scissors. Then take out the maxilla from the mouth.
18. Put the warm gauze (40 °C) into the operative region immediately for several minutes to stop the bleeding. Then control the bleeding by electrogoagulation.
19. Rinse the surgical cavity with 40 °C warm water.
20. Fix the denture to reconstruct of the hard-palatal defect. Return the facial soft tissue to the normal position.
21. Cover the surface of the surgical margin with gelatin sponge. Then, pack the nasal cavity with iodoform gauze and inflation sponge.

3. Procedure and assessment after surgery

1. Take out the gauze and sponge 4 days after surgery. Then, examine through enhanced CT or MRI immediately.
   NOTE: Get rid of the denture before the MRI examination.
2. Review the patient 2 weeks after the surgery to check and clean the surgical field. Then, review the patient according to the NCCN guidelines¹⁰.

Results

In this study, we presented the details of the surgical protocol to resect the total maxillectomy with a combined endoscopic and transoral approach. We also included nine cases who were diagnosed with malignant tumors that originated from maxillary sinus and were treated in the Eye and ENT hospital of Fudan University. The combined endoscopic and transoral approach on all the patients was performed and clear surgical margins were achieved in all the patients. The patients' mean age was 47.9 years (with a range of 18-...

Discussion

In this work, we demonstrated an endoscopic approach to resect the total maxilla. Our results showed that this approach was effective and safe to achieve its goal, which is consistent with previous cadaveric⁸ and clinical studies⁹. Nine patients with malignant tumor originated from maxillary sinus were treated with this endoscopic approach. All of their information was recorded, and the length of their follow-up ranged from 2 months to 32 months. During the follow-up period...

Materials

Name	Company	Catalog Number	Comments
Carborundum drill	Medtronic, Inc.	REF15BA60D
Curved sinus blade	Medtronic, Inc.	REF1884006	11 cm x 4 mm
Dynamic planing system	Medtronic, Inc.	REF1898001
Electrocoagulation	Shanghai Hutong Electronics. Co.,Ltd	GD350-B5
Epinephrine	Shanghai Harvest Pharmaceutical Co., Ltd	10170405
Fret Saw Wire Instruments	Shanghai Medical Instruments (Group) Ltd., Corp. Surgical Instruments Factory	N30030
Gauze	Ningbo Shenyuan Medical Material Co., Ltd		6 cm x 60 cm
Mastoid Retractor	Shanghai Medical Instruments (Group) Ltd., Corp. Surgical Instruments Factory	NH6F090	Lengh: 16 cm
Mayo scissors	Shanghai Medical Instruments (Group) Ltd., Corp. Surgical Instruments Factory	J22040	Lengh: 16 cm
Metzenbaum scissors	Shanghai Medical Instruments (Group) Ltd., Corp. Surgical Instruments Factory	JC2514	Lengh: 25 cm
Nasal Endoscopy	Karl Storz-Endoskope	7230 AA
Plasma (EVAC 70 Xtra HP With integrated Cable)	Smith & Nephew	EIC5874-01
Quadcut blade	Medtronic, Inc.	REF1884380HR	4.3 mm
Suction Elevator	Zhejiang Tian Song Medical Products Co., Ltd	B2117.1	Width: 4 mm
Tetracaine	Eye & ENT Hospital of Fudan University	180130
Trans-Nasal Skull Base Bur	Medtronic, Inc.	REFTN45RCD	13 cm x 4.5 mm