Ultrasound Cyclo Plasty in Eyes with Glaucoma

Podsumowanie

Glaucoma is a chronic disease with progressive degeneration of optic nerve fibers resulting in decreased visual field. Elevated intraocular pressure is considered the most important and the only treatable risk factor. This manuscript describes a simple, surgeon-friendly, non-incisional technique, named Ultrasound Cyclo Plasty, for reducing intraocular pressure in glaucoma patients.

Streszczenie

Glaucoma is a chronic disease caused by the progressive degeneration of the optical nerve fibers, resulting in decreased visual field that can lead to severe visual impairment, and eventually blindness. This manuscript describes a simple, surgeon-friendly, non-incisional technique, named Ultrasound Cyclo Plasty (UCP), for reducing intraocular pressure (IOP) in glaucoma patients. The technique determines a selective coagulation necrosis of the ciliary body; in addition, the stimulation of supra-choroidal and trans-scleral portions of the uveo-scleral outflow pathway has been recently proposed. UCP shows several technical improvements in ultrasound technology compared to previous techniques, providing more precise focusing on the target zone. The procedure is performed in the operating room under peribulbar anesthesia. Briefly, the coupling cone is put in contact with the eye and the ring probe, that contains six piezoelectric transducers which produce the ultrasound beams, is inserted inside it. Their proper centering over the ocular surface represents a crucial step for the correct targeting of the ciliary body. Sterile balanced salt solution is used to fill the empty spaces to ensure ultrasound acoustic propagation. Surgical treatment consists in the sequential automatic activation of each of the six transducers, for a total duration of less than 3 min. The patient leaves the hospital 1 h after the procedure with the treated eye patched. In the present study, 10 patients with open-angle glaucoma were followed-up during at least 12 months after the procedure. IOP was reduced at each interval compared to pre-operative, as well as the number of hypotensive medications. Twenty percent of patients did not respond to the treatment, and needed subsequent surgery to better control IOP. Treatment tolerability was good, with no cases of hypotony or phthisis. The UCP procedure is simpler, faster, safer, and less invasive than traditional cyclodestructive procedures with similar results in reducing IOP.

Wprowadzenie

Glaucoma represents one of the major causes of blindness worldwide, affecting about 100 million people¹. It is an optical neuropathy generated by the progressive degeneration of the nerve fibers that converge on the optic nerve, resulting functionally in a decrease of the visual field that can progress to visual disability and eventually blindness without adequate treatment².

Elevated IOP is still considered the main risk factor for glaucoma onset and progression, and currently the only treatable parameter to reduce the visual field loss³. IOP reduction can be achieved by both reducing the production of aqueous humor and/or increasing its outflow through trabecular meshwork by the use of topical or systemic drugs, laser, or surgery^3,4. Many physical processes have been already introduced to induce the coagulation necrosis of the ciliary body following heating or freezing^{5,6,7,8,9,10,11,12}. However, the lack of selectivity for the target tissue and the unpredictable dose-effect relationship in reducing IOP limit their use only to eyes with glaucoma resistant to conventional medical and surgical therapies⁴.

Over the last years, a new device, named UCP, that employs high-intensity focused ultrasound (HIFU) has been developed, with the purpose of overcoming the limitations of traditional cyclodestructive techniques by achieving a more selective coagulation of the ciliary body and avoiding possible damages to the adjacent ocular structures^{13,14,15,16,17,18,19,20,21}. In addition, the stimulation of supra-choroidal and trans-scleral portions of the uveo-scleral outflow pathway has been recently proposed as a possible adjunctive mechanism of the procedure in reducing IOP²². To date, seven major clinical studies have been conducted using the UCP device in different types and severity grades of glaucoma, demonstrating the effectiveness and the safety of this non-incisional procedure^{14,15,19,20,21,22,23,24}.

The aim of this study is to describe the above-mentioned procedure in detail, in order to spread the knowledge of its introduction to the scientific medical community, and to provide useful tips and tricks to surgeons who would like to approach this novel field.

Protokół

All participants provided both verbal and written informed consent before any study procedure. The protocol of the study was carried out in accordance with the Declaration of Helsinki and was approved by the Ethics Committee for human research of S.Orsola-Malpighi Teaching Hospital.

1. Preoperative Procedures and Ophthalmological Evaluation

1. Test distance and near Best Corrected Visual Acuity (BCVA).
2. Evaluate the anterior segment of the eye using a slit lamp biomicroscope.
3. Examine the anterior chamber angle using a slit lamp gonioscopy lens after having instilled topical anesthetic eye drops.
4. Evaluate the fundus by slit lamp indirect ophthalmoscopy with the use of a non-contact fundus lens. Pay particular attention to the optic disc head.
5. Measure the IOP using Goldmann applanation tonometry.
   1. Instill topical anesthetic eye drops to obtain corneal anesthesia.
   2. Color the tear film using 2% fluorescein (ophthalmic strips).
      NOTE: It is crucial to color the tear film with the proper amount of fluorescein. High amounts produce too thick fluorescein rings with overestimated IOP measures, while low amounts produce too thin rings with underestimated IOP readings.
   3. Mount the tonometer on the guide plate over the slit lamp axis.
   4. Set the blue cobalt filter light and the light beam as wide and bright as possible with the slit diaphragm fully open.
   5. Properly direct the blue light beam on the tonometer head putting the slit beam at 60° on the same patient's side of the eye under examination, in order to avoid the contact of the slit lamp with the patient's face and the covering of the light beam by the patient's nose.
   6. Ask the patient to lean the head on the slit lamp headrest, open both eyes wide, look straight ahead, and keep perfectly still.
   7. Move the tonometer using the slit lamp joystick until the biprism head is gently in contact with the center of the corneal surface: two regular hemi-circles of fluorescein tear meniscus are visualized through each prism when looking through the slit lamp eyepieces.
   8. Turn clockwise the calibrated knob on the side of the tonometer to bring near the visualized fluorescein hemi-circles until their inner borders just touch each other, forming a horizontal "S" shape: the number indicated in the calibrated knob represents the IOP measure.
      NOTE: Be sure to properly disinfect, rinse with sterile water, and wipe the tonometer head before any measurement.
6. Measure the ocular anatomical parameters by means of a non-contact optical biometer.
   1. Ask the patient to lean the head on the headrest, open both eyes wide, look straight ahead, and keep perfectly still.
   2. Move the optical biometer using its joystick to properly focus on the center of the corneal surface: an arrow and a green circle on the display help the clinician to find the correct position.
   3. Click the button on the joystick to start the measurement: a green line appears on the display and starts to move forming a circle. Keep the position as still as possible during this time.
   4. Perform at least 5 measurements per eye to reduce possible errors and increase reliability. The instrument automatically calculates the average value.
7. Use the nomogram tool (Figure 1) to calculate the appropriate size of the treatment probe among the 3 possible options (11, 12, or 13 mm of ring diameters).
   NOTE: Two ocular anatomical parameters are needed: the white-to-white (WTW, distance equal to the corneal horizontal diameter) and the axial length (AL, distance from corneal apex to fovea).
8. Prescribe to the patient pilocarpine eye drops 3 times per day starting from 3 days before surgery to ensure the proper intraoperative miosis, allowing a more precise targeting of the ciliary body by the ultrasound beams delivered by the probe.

2. Pre-surgical Procedures

1. Place the patient in a supine position on the surgical bed.
2. Administer local anesthesia by performing one peribulbar infiltration with 10 mL of local anesthetics (mepivacaine plus ropivacaine) 30 min before the surgery.
   1. Perform the injection inferotemporally at the junction of outer one third and inner two third of the lower orbital rim or superonasally beneath the superior orbital notch using a 27-gauge needle.

3. Preparation of the Treatment Device

1. Enter data about the surgeon and patient using the control unit touch screen, and then select the eye to treat.
   NOTE: First generation probes also can choose between 4 s or 6 s of ultrasound exposure time, while the second-generation probes (the only ones now available on the market) allow only 8 s of exposure time.
2. Open the sterile single-use device pack containing the coupling cone and the treatment probe and connect their cables to the control unit.

4. UCP Procedure

1. Disinfect accurately the palpebral and periorbital skin with 10% povidone-iodine 3 times. Wipe the disinfected skin with clean sterile gauzes.
2. Put a sterile surgical drape over the face of the patient with a central hole centered over the eye under treatment in order to properly expose it.
3. Place the patient's head lying slightly backwards in order to put the ocular surface horizontally allowing a comfortable placement of the cone of the device (Figure 2).
4. Open the patient's eye without using the speculum.
5. Put the coupling cone over the ocular surface, with tubing on the temporal side, and gently move to correctly position and center it, forming a uniform white scleral ring surrounding the limbus (Figure 3). Use a surgical clamp to reposition the cone, if needed.
   NOTE: A minimal uniform ring of 2 mm of white sclera should be visible between the limbus and the cone inner boarder. This ring should be as regular as possible all along the 360° of the eye to ensure the optimal centering of the probe and consequently the correct targeting of the ciliary body (Figure 3).
6. Push the aspiration button on the foot switch to start a low-level suction from the peripheral ring of the coupling cone until the vertical bar on the screen becomes green. This allows the maintenance of the coupling cone in direct contact to the patient's eye throughout the entire procedure (Figure 4A).
7. Insert the treatment probe inside the coupling cone, with the cable in nasal position.
   NOTE: A "click" sound confirms the proper anchorage of the probe to the cone (Figure 4B).
8. Fill the empty space delimited by the eye, the cone, and the probe with sterile balanced salt solution (BSS) at room temperature at the beginning and during the entire procedure to allow good propagation of the therapeutic ultrasounds (Figure 4C). Refill at the appropriate level in case of BSS leakage.
9. Ask the patient to hold the position and keep perfectly still the head.
10. Push the start button on the foot switch to start the treatment and hold the pressure during all the procedure (the passage between each treatment sector is completely automatic without the need to release pressure of the foot switch).
11. Maintain firmly in the optimal position the probe and the coupling cone during the entire procedure. Avoid moving, rotating, or pushing the probe in order to permit the best centering of therapeutic ultrasounds beams during the treatment (Figure 4D).
    NOTE: During the treatment, each of the six transducers are sequentially activated for 4, 6, or 8 s (depending on the generation of the probe), with 20 s of interval before each activation, starting from the superior sectors and moving clockwise. The control unit shows the sequential activation of the six transducers. Surgical treatment lasts 124 s, 136 s, or 148 s.
    1. Release the pressure on the foot switch to stop the procedure. In case of interruption of the treatment during the interval between the activation of two consecutive sectors, the treatment can continue without losing any sector; on the contrary, in case of interruption of the treatment during the activation of a sector, the treatment in the sector in question is not completed.
12. At the end of the procedure, deactivate the suction system by pressing the aspiration button on the foot switch and slowly tilt the cone until BSS is removed through the tube.

5. Post-surgical Procedures

1. Instill antibiotic plus steroid eye drops in the treated eye immediately after the procedure, and patch the treated eye for 24 h.
   NOTE: The patients can leave the hospital 1 h after the procedure.
2. Remove the eye patch the day after the procedure, examine the treated eye, and measure the IOP.
3. Prescribe to the patient antibiotic plus steroid eye drops 4 times per day for 1 month.
4. Examine the treated eye and measure the IOP at 1, 7, and 14 days, 1, 3, 6, and 9 months, and 1 year after the procedure.

Wyniki

Ten eyes of 10 patients (6 men and 4 women, mean age 64.9 ± 13.7 years, range 39–80 years) affected by open-angle glaucoma were treated with UCP device according to the technique described above. Treatment exposure time was 4 s for 2 patients, 6 s for 4 patients, and 8 s for 4 patients. Before surgery, the mean IOP was 24.8 ± 9.6 mmHg (mean ± standard deviation), while the mean number of daily hypotensive drops was 3.9 ± 1.0 and the mean number of daily acetazola...

Dyskusje

Glaucoma is a chronic progressive disease affecting the optic nerve for which new effective treatments are needed to improve long-term prognosis. The reduction of IOP is still considered the only effective therapy to prevent or delay visual field loss, in eyes both with and without elevated IOP³.

UCP is a new non-incisional cyclodestructive procedure that can lower IOP, acting in two different ways: it reduces the aqueous humor inflow determining the selective necrosis ...

Materiały

Name	Company	Catalog Number	Comments
BM 900 Slit Lamp Biomioscropy	Haag-Streit, Koeniz, Switzerland	BM 900	Slit Lamp Biomiscroscopy
G-4 Four-Mirror Glass Gonio Lens	Volk Optical Inc., Mentor, OH, USA	#VG4	Contact lens for gonioscopy
78D Non Contact Slit Lamp Lens	Volk Optical Inc., Mentor, OH, USA	#V78C	Non contact slit lamp lens
HospiFluo strips	AIESI Hospital Service S.a.s., Napoli, Italy	AHS129	Fluorescein sterile disposable strips
AT 900 Goldmann Applanation Tonometer	Haag-Streit, Koeniz, Switzerland	AT 900	Goldmann applanation tonometer
Lenstar LS900	Haag-Streit, Koeniz, Switzerland	LS900	Optical biometer
Pilocarpina 2% eye drops	Farmigea, Pisa, Italy	S01EB01	Miotic eye drops
Mepivacaina 20mg/ml injectable solution	Angelini, Roma, Italy	N01BB03	Local anesthetic for injection
Naropina 10mg/ml injectable solution	AstraZeneca, Milano, Italy	N01BB09	Local anesthetic for injection
Oftasteril 5% eye drops	Alfa Intes, Napoli, Italy	S01AX18	5% povidone-iodine eye drops
EyeOP1	Eye Tech Care, Rillieux-la-Pape, France		UCP device
BSS (balanced salt solution)	Alcon Inc., Forth Worth, TX, USA	0065-1795-04	Sterile irrigating solution
Tobradex eye drops	Alcon Italia Spa, Milano, Italy	S01CA01	Antibiotic and steroid eye drops